Summary of the content on the page No. 1
Owner's Manual
,®
Liquid Propane Gas Grill
Model141.166801
Natural Gas Grill
Model141.176801
WARNING: Note to Installer: Leave this Owner's Manual
with the consumer after delivery and/or installation.
Read this Owner's Manual carefully and be sure
your gas grill is properly assembled, installed and
Note to Consumer: Leave this Owner's Manual
maintained. Failure to follow these instructions
in a convenient place for future reference.
could result in serious bodily injury and!or property
damage. T
Summary of the content on the page No. 2
/_k WARNING Warranty ..................................................... 2 Combustion byproducts produced when using Safety Instructions ..................................... 2 this product contain chemicals known to the State of California to cause cancer, birth Hardware ............................................................ 6 defects, or other reproductive harm. Parts Diagram and Lists ........................ 7 Z_ WARNING Assembly Instructions ............................... 11 Failur
Summary of the content on the page No. 3
18-1/2incheshighis the maximum sizeLP gas • LP gas tanks must be stored outdoors in a well-ventilated area and out of the reach of tankto use.You must use an "OPD" gas tank which offers an Overfill Prevention Device. children. Disconnected LP gas tanks must not This safety feature prevents the tank from being be stored in a building, garage or any other overfilled which can cause malfunction of the LP enclosed area. gas tank, regulator and/or grill. • When your gas gdll is not in use the gas mus
Summary of the content on the page No. 4
Figure 1 (Natural gas model only) IMPORTANT: your Kenmore Natural Gas Grill cannot GAS SUPPLY be converted to use LP Gas. Attempting to do so INSIDE is extremely hazardous and will also void the grill WALL warranty. OUTSIDE WALL Your natural gas grill is designed to operate on TO GRILL natural gas only, at a pressure of 7" water column SHUT OFF (W.C.) (1/4 psi or 1.75 kpa), regulated atthe LOCKING residential meter. Check with your gas utility SHUT OFF company for local gas pressure and with you
Summary of the content on the page No. 5
CAUTION:Spidersand smallinsectsocca- To reducethe chanceof "FLASHBACK" (see sionallyspin websor makenestsin the grill CAUTION at right)cleanthe BurnerTubesand BurnerTubesduringtransitand warehousing. Burnersbeforefully assembling yourgdtl. Remove the CotterPinfrom the rearunderside Thesewebscan leadto a gasflowobstruc- tionwhichcouldresultin a fire in and around of eachBurnerusinga pairof longnosepliers. the BurnerTubes.Thistypeof fire is known Carefully lift eachBurnerupand awayfromthe as a "FL
Summary of the content on the page No. 6
The following table illustrates a breakdown of the hardware pack. It highlights what components are used in the various stages of assembly. Ref. Component Qty. PurposeofComponents Attaches Side Shelf To Grill Head H031 1/4"x3/4" Phillips Head Screw 4 1/4"x3/4" Flat Head Screw 4 Attaches Cart Side Handle To Grill Head H034 P05301001A AA Battery 1 Powers The Electdc Ignitor P05301002A AAA Battery 2 Powers The Fuel Gauge Display (LPG model only) Attaches To Outside Bowl Panel - Left P05313023B Manu
Summary of the content on the page No. 7
The followingtableillustrates a breakdown of the screwsfor cabinetcart.It highlights whatcomponents areusedin the variousstagesof assembly. Ref. Component Qty. Purpose of Components Install Caster To Caster Seats of Bottom Shelf H005 1/4"xl/2"PhillipsHeadScrew 16 Attaches Cart Side Panels To Bottom Shelf H030 1/4"x50mm PhillipsHeadScrew 8 Attaches Rear Panel To Cart H005 1/4"xl/2"PhillipsHeadScrew 7 H005 1/4"xl/2"PhillipsHeadScrew 4 Attaches Tank Pull-out Tray Kit To Bottom Shelf (LPG model only
Summary of the content on the page No. 8
LPG = Liquid Propane Gas 3_ NG = Natural Gas 19 13a (NO only)\ 28(LPGonly) 29(NI 16 PG only) 40 j(LPG only)44a 17 /55b [NG only)44b\ 32 33 38 b7 (LPG only) only) only) 8
Summary of the content on the page No. 9
REF# DESCRIPTION PART# QTY 1. Stainless Steel Lid 1 PO0116346A 2. Stainless Steel Lid Trim Plate 1 P0011434EA 1 3. Lid Side Panel - Left P00105347U P00106347U 1 4. Lid Side Panel - Right 1 PO0601171A 5. Temperature Gauge 1 6. Lid Handle P00205031B 1 7. Name Plate P00410038C P01506027B 1 8. S/S Secondary Cooking Rack 2 9. S/S Stainless Steel Cooking Grid P01606030B 1 10, S/S Stainless Steel Cooking Grid - 4" Size P01606031B 11, S/S Stainless Steel Flame Tamer 2 P01708031B 1 12, S/S Stainless Stee
Summary of the content on the page No. 10
REF# DESCRIPTION PART# QTY 44a. Rear Panel (LPG only) P07702010E 44b. Rear Panel (NG only) P07702013E 45. Door Bracket P03301017J 46. Door Panel - Left PO4302012A 47. Door Panel - Right P04303012A 48. Door Trim Plate - Left P07506007D 49. Door Trim Plate - Right P07507007D 50. Door Axle Bracket - Left Top P03314018C 51. Door Axle Bracket - Left Bottom P03314019C 52. Door Axle Bracket - Right Top P03314020C 53. Door Axle Bracket - Right Bottom P03314021C 54. S/S Door Handle P00205036B 2 55a. Wire
Summary of the content on the page No. 11
Figure 1 L CAUTION : While it is possible for one person to OUTSIDE BOWL PANEL-LEFT remove the grill from the carton, it is recommended that you obtain assistance because of the weight of the grill. 1. Open the parts boxes. Use the parts list to check that all parts have been included. MAx8mm PHILLIPS 2. Inspect the grill for damage as you assemble it. Do HEAD SCREW _. not assemble or operate the grill if it appears damaged. If there are damaged or missing parts when you unpack the shipping box,
Summary of the content on the page No. 12
ElectrodeCheck- Requires an Assistant Installing Cooking Components Before placing the cooking components into your Important: Before cooking on your grill the first grill, ensure that the Spark Electrode Tip is properly time, wash the Cooking Grids and Cooking Rack positioned within each Gas Collector Box ( a with warm, soapy water. Rinse and dry thoroughly. 3-1/4" wide stainless mechanism found at the front After cooking is completed, turn gdll to HIGH between each set of Burners.) The easiest
Summary of the content on the page No. 13
Calibration Procedure. Figure 6a 1. Before installingbatteries be sure the gas tank is not mounted in the tank pull-out tray. FUEL GAUGE DISPLAY COVER 2. From the underside of the Control Panel, unscrew the Fuel Gauge Display Cover on the Fuel Gauge Display DISPLAY BOX Box. See Fig.6a WIRE 3. Carefully remove the battery box from the back of the Fuel Gauge Display Box and insert two "AAA" batter- ies(provided). Be sure to follow correct polaritywhen AAABATTERY inserting batteries. BATTERYBOX 4.
Summary of the content on the page No. 14
Connecting A Liquid Propane Gas (LP gas) Figure 7a (LP gas model only) Tank To Your Grill 1. Remove the Pull-out Grease Draining Traywith the Heat Shield from Grill. 2. Locate hose and regulator assembly packed for shipping purposes on front underside of grill head. Remove fastening band. Push assemblyto back of grill and pull down to connect to tank valve. Before connecting, check valve and assembly threads to be sure they match. (Type 1 connection per ANSI Z21.58a- 1998)See Fig.7b. FRONT DOOR
Summary of the content on the page No. 15
Connecting Natural Gas To Your Grill /K WARNING For Natural Gas grills: The 12 foot Natural Gas Hose has already been connected to Gas Mani- A strong gas smell, or the hissing sound of fold as shown in Fig.7c. Thread the 12 foot gas indicates a serious problem with your gas Natural Gas Hose through the hole of Rear Panel to outside. Also read the natural gas safety grill or the LP gas tank. Failure to immedi- instructions.(on page 4) ately follow the steps below could result in a fire or explosi
Summary of the content on the page No. 16
. If the burner does not light, turn the Control Knob to OFF, wait 5 minutes for gas to clear, then retry. Basic Lighting Procedures 9. Once the left grill burner is ignited, the adjacent Machine oils used inthe manufacturing process of burner can be lit by simply turning its Control Knob stainless steel can cause stainless steel to turn a tan toHIGH. color. Before initialgrill use, remove protective PVC 10. film from Control Panel and inside and outside of Grill Adjust Control Knobs to your des
Summary of the content on the page No. 17
Manually Lighting Your Grill by Match Misalignment of Ignitor on Burner Correction: Check for proper position of the To light your main burners by match, insert a match Electrode Tip as shown in Figure 4 The gap into the Manual Lighting Stick and follow steps 1 between the Spark Electrode Tip and Burner or through 6 of the Gas Lighting Instructions. Then, light Spark Receiver should be approximately 3/16", the match and place Manual Lighting Stick through the Adjust if necessary. With the gas su
Summary of the content on the page No. 18
. Cover each Gas Valve Orifice with aluminum foil. 6. Brush the inside and bottom of the grill with a fiber CAUTION: pad or nylon brush, and wash with a mild soap and BesureyourgrillisOFFandcootbefore cleaning. warm water solution. Rinse thoroughly and let dry. Takecarenottochiporscratch thepainted surfaces 7, Remove aluminum foil from Orifices and check because itwillvoidyourwarranty against rusting. each Orifice for obstruction. Aswithallappliances, proper careandmaintenance 8. Check each Spar
Summary of the content on the page No. 19
Regardless of which Burner cleaning procedure you Cleaning The Burner Tubes and Burner Ports use, we recommend you also complete the following To reduce the chance of FLASHBACK the procedure steps to help prolong Burner life. below should be followed at least once a month in late 1. Use a fiber pad or nylon brush to clean the entire summer or early fall when spiders are most active or outer surface of each Burner until free of food when your grill has not been used for a period of time. residue
Summary of the content on the page No. 20
Question: What is the best way to protect my new Kenmore gas gdll from the weather? Answer: A good quality grill cover should be used to Question: Can I convert my Kenmore gas grill from protect your grill when not in use. Sears offers a cover one fuel type to another? that is made to fit this particular gdll model. Also, follow Answer: Your Kenmore gas grill is manufactured to the cleaning and maintenance instructions in this exact specifications and is approved by the Canadian Owner's Manual o
