Summary of the content on the page No. 1
STAINLESS STEEL GAS GRILL
MODEL NO.: 720-0061-LP
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Summary of the content on the page No. 2
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions………………………….. 1-5 Exploded View……………………….….. 20 Placement of the grill……………………….. 5 Parts List ………………………………… 21 SECTION TWO SECTION SIX Side Burner & Side Shelf Assembly………. 6 Grilling Hints …………………………….. 22 Side Burner Handle Assembly…………
Summary of the content on the page No. 3
PRECAUTIONS SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING WARNING Do not try lighting this ap pliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual. WARNING – Hazards or unsafe practices which COULD result in severe personal injuray or death. DO NOT USE ALUMINUM FOIL TO LINE THE GRILL RACKS OR GRILL BOTTOM. This can severely upset combustion air flow or trap CAUTION excessive heat in th
Summary of the content on the page No. 4
PRECAUTIONS SAFETY INSTRUCTIONS WARNING: IMPORTANT! USING THE SIDE BURNER: Inspect the gas supply hose prior to turning the gas “ON”. If there is evidence of cuts, wear or abrasion, it must be replaced prior to use. Do not use the side burner if the odor of gas is present. WARNING: Always keep your face and body as far away from the burner as possible when lighting. WARNING: IMPORTANT! BEFORE LIGHTING… Inspect the gas supply hose prior to turning the gas “ON”. If there is e
Summary of the content on the page No. 5
SAFETY INSTRUCTIONS *** WARNING *** FOR YOUR SAFTY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appl
Summary of the content on the page No. 6
PRECAUTIONS SAFETY INSTRUCTIONS WARNING Do not try lighting this appliance without first reading CHILDREN SHOULD NOT BE LEFT ALONE OR the “LIGHTING INSTRUCTIONS” section of this UNATTENDED IN AN AREA WHERE THE GRILL manual. IS BEING USED. NEVER ALLOW THEM TO SIT, STAND OR PLAY ON OR AROUND THE GRILL AT TESTED IN ACCORDANCE WITH ANSI Z21.58b- ANY TIME. 2002 and CGA 1.6B-2002 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. THIS DO NOT STORE ITEMS OF INTEREST TO GRILL IS FOR O
Summary of the content on the page No. 7
PRECAUTIONS SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, burner grate or immediate surroundings as these Do not use the grill for cooking excessively fatty areas become extremely hot and could cause meats or products which promote flare-ups. Do not burns. Use only dry potholders. Moist or damp operate the grill under unprotected combustible potholders on hot surfaces may cause burns from construction. Use only in well ventilated areas. Do steam. Do not use a to
Summary of the content on the page No. 8
INSTALLATION OF SIDE SHELF & SIDE BURNER ASSEMBLY • The screws used to attach the side shelf and side burner are already screwed into the two- side panels (see the figure below). Remove the screws from the two-side panel, align with the holes in the left side shelf, and then re-screw into the holes on the left side panel of the grill. • Repeat the above step to install the left side shelf on left side panel. Please note: for the left side shelf, insert the top two screws from the
Summary of the content on the page No. 9
SIDE BURNER HANDLE ASSEMBLY • To assemble the side burner lid handle, open the lid first, cut off the plastic tie tied in the screw hole. Install the handle in the lid as shown in figure below. • Take four of the side burner handle screws from hardware bag. Align the side burner hole in the side shelf, and tighten up the screws (see figure below). 7
Summary of the content on the page No. 10
BATTERY ASSEMBLY • In order to install the battery, remove the ignition button housing. Please keep the positive pole of the battery facing toward you. Insert the battery into the housing. Replace the ignition button housing after battery is installed. 8
Summary of the content on the page No. 11
SIDE BURNER GAS HOSE ASSEMBLY • The side burner PVC gas hose is attached on the valve manifold inside the grill cart. Insert the gas hose to the hole on right panel of the grill. Secure it on the gas hose connector under the side burner as shown in figure below. 9
Summary of the content on the page No. 12
CLO SE PROPANE TANK ASSEMBLY • Attach propane gas tank to regulator inlet fitting by turning the regulator clockwise as shown in figure below. g 10 OPEN
Summary of the content on the page No. 13
GAS HOOK-UP Only the pressure regulator and hose assembly LP GAS HOOK-UP: supplied with the grill should be used. Any Ensure that the black plastic grommets on the LP replacement pressure regulator and hose assembly cylinder valve are in place and that the hose does must be specified by the grill manufacturer. not come into contact with the grease tray or the grill head. This is a liquid propane configured grill. CONNECTION: Do not attempt to use a natural gas supply unless
Summary of the content on the page No. 14
LEAK TESTING GENERAL local gas supply may make it necessary to adjust Although all gas connections on the grill are leak the burners. The flames of the burners should be tested at the factory prior to shipment, a complete visually checked. gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks following the procedur
Summary of the content on the page No. 15
INSTALLER FINAL CHECK Specified clearance maintained 24” from hose & regulator assembly provided (pre-set for combustibles. 11.0” water column). All internal packaging removed. Unit tested and free of leaks. Knobs turn freely. User informed of gas supply shut off valve Burners are tight and sitting properly on orifices. location. Pressure regulator connected and set for 11.2” W.C. LP gas. Gas connections to grill using PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REF
Summary of the content on the page No. 16
2 OPERATING INSTRUCTIONS General use of the grill and rotisserie Each main burner is rated at 15,000 BTU/hr. The the stainless steel motor mount. The rotisserie main grill burners encompass the entire cooking motor must be electrically grounded in accordance area and are side ported to minimize blockage from with local codes or, in the absence of local codes, falling grease and debris. Above the burners are with the National Electrical Code, ANSI/NFPA 70- stainless steel radiant (flame
Summary of the content on the page No. 17
LIGHTING INSTRUCTIONS variations in the local gas supply may take minor WARNING: IMPORTANT! adjustments necessary. BEFORE LIGHTING… Burner flames should be blue and stable with no Inspect the gas supply hose prior to turning the gas yellow tips, excessive noise, or lifting. If any of “ON”. If there is evidence of cuts, wear, or abrasion, these conditions exist call our customer service line. it must be replaced prior to use. Do not use the grill If the flame is yellow, it
Summary of the content on the page No. 18
TO MATCH LIGHT THE GRILL TO MATCH LIGHT THE GRILL: If the burner will not light after several attempts then the burner can be match lit. If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit extended match or lighter through the cooking grids to the burner. Press the control knob and rotate left to the HI setting, continue to press the knob
Summary of the content on the page No. 19
LIGHTING ILLUSTRATION Main & Side Burner Lighting Illustration Rotisserie Burner Lighting Illustration 1. Make sure the lid is open 1. Push and turn the rotisserie knob to HI. 2. Push and turn one of main or side burner knobs 2. Press the electric igniter 3 to 4 seconds to to HI position
Summary of the content on the page No. 20
USING THE SIDE BURNER control knob counterclockwise to the “HI” position. If the burner does not light, turn the control knob to WARNING: IMPORTANT! “OFF”. If the smell of gas is detected and the igniter USING THE SIDE BURNER: is not functioning, immediately turn the control knob Inspect the gas supply hose prior to turning the gas “OFF”. Allow 5 minutes for any accumulated gas to “ON”. If there is evidence of cuts, wear or abrasion, dissipate. If the side burner igniter is not it
