Summary of the content on the page No. 1
STAINLESS STEEL LP GAS GRILL
MODEL NO.: 720-0165 ITEM NO: 30082
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Summary of the content on the page No. 2
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions…………………………… 1-5 Exploded View…………………………….. 20 Placement of the Grill……………………….. 5 Parts List…………………………………… 21 SECTION TWO SECTION SIX Side Shelf Assembly………………………… 6 Grilling Hints……………………………….. 22 Side Shelf Handle & Battery Installation…..
Summary of the content on the page No. 3
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING WARNING Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual. WARNING – Hazards or unsafe practices which COULD result in severe personal injury or death. WARNING Spiders and insects can nest inside the burners of CAUTION the grill and disrupt gas flow. This very dangerous condition could cause a fire behind the valve pane
Summary of the content on the page No. 4
SAFETY INSTRUCTIONS CAUTION WARNING When using a match to light the grill make Do not use the grill if the odor of gas is present. Contact customer service at 1- sure to use the attached lighting rod. 800-554-5799. CAUTION Before cleaning, make sure the gas supply WARNING and control knobs are in the “OFF” position When lightin g, keep your face and hands and the burners have cooled. as far away from the grill as possible. WARNING Failure to properly place
Summary of the content on the page No. 5
SAFETY INSTRUCTIONS USING THE SIDE BURNER WARNING Inspect the gas supply hose prior to turning on Do not attempt to light the grill if gas odor is the gas. If there is evidence of cuts, wear or present. Contact customer service at 1-800- abrasion, it must be replaced prior to use. Do 554-5799. not use the side burner if gas odor is present. When lighting, keep your face and body as far Keep a spray bottle of soapy water near the away from the burner as possible. gas supply val
Summary of the content on the page No. 6
SAFETY INSTRUCTIONS The grill is not intended to be installed in or on WARNING recreational vehicles and/or boats. Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section Children should not be left alone or unattended in of this manual. an area where the grill is being used. Do not allow children to sit, stand or play on or around TESTED IN ACCORDANCE WITH ANSI Z21.58 the grill at any time. LATEST STANDARD and CSA 1.6 LATEST STANDARD FO
Summary of the content on the page No. 7
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, Turn off all control knobs and make certain the grill burner grate or immediate surroundings as these is cool before using any type of aerosol cleaner on areas become extremely hot and could cause or around it. The chemical that produces the burns. Use only dry potholders. Moist or damp spraying action could, in the presence of heat, potholders on hot surfaces may cause steam burns. ignite or cause metal parts to corrod
Summary of the content on the page No. 8
SIDE SHELF ASSEMBLY Estimated Assembly Time: Approximately 5-7 minutes Required Tools: Phillips Screwdriver (not included) 1. Open the grill lid and remove the side shelf from the fire box. 2. The screws used to attach the side shelves are already screwed into the side panels of the grill cart. Remove the screws from the side panels. 3. Align the holes in the left side shelf with the holes in the grill cart. Insert the screws and tighten. Note: The top two screws
Summary of the content on the page No. 9
SIDE SHELF HANDLE ASSEMBLY Estimated Assembly Time: Approximately 5-7 minutes Required Tools: Phillips Screwdriver (not included) 1. Remove the four screws from the side of the shelf. 2. Align the holes in the side burner handle with the holes in the shelf. 3. Insert the screws and tighten. BATTERY INSTALLATION 1. Remove the ignition button housing. 2. Insert the battery into the housing with the positive terminal facing outward. 3. Replace the i
Summary of the content on the page No. 10
BRAKING SYSTEM OPERATIONS Push right to lock. 1 1 Push left to unlock. LIQUID PROPANE CYLINDER RETENTION SYSTEM Insert the liquid propane gas cylinder into the slide-out tray using the gas cylinder retention screw. Turn the retention screw clockwise to tighten the gas cylinder. Retention Screw 8 2 2
Summary of the content on the page No. 11
CLOSE SLIDE-OUT TRAY LOCKING SYSTEM 1. To lock and unlock the liquid propane gas cylinder tray, press the gas cylinder tray’s top button to lock. Press the side button to unlock. PROPANE REGULATOR HOOK-UP 1. Attach the regulator to the propane cylinder by turning the regulator handle clockwise. 2. Turn off the gas supply at the cylinder when the appliance is not in use. g 9 OPEN
Summary of the content on the page No. 12
GAS HOOK-UP Only the pressure regulator and hose assembly supplied with the grill should be used. Any The liquid propane cylinder must be fitted with an replacement pressure regulator and hose assembly Overfill Protection Device (OPD). Remove the must be specified by the grill manufacturer. plastic valve cover from the liquid propane cylinder. Make sure the grill’s gas hoses do not come in This is a liquid propane configured grill. Do not contact with the grease tray or grill firebox
Summary of the content on the page No. 13
LEAK TESTING GENERAL Although gas connections on the grill are leak tested prior to shipment, a complete gas tightness Only those parts recommended by the check must be performed at the installation site. manufacturer should be used on the grill. Periodically check the whole system for leaks Substitutions will void the warranty. following the procedures listed below. GAS FLOW CHECK If the smell of gas is detected at anytime, you Each grill burner is tested and adjusted at the
Summary of the content on the page No. 14
INSTALLER FINAL CHECK Specified clearance maintained 24 inches from combustible materials/construction. The unit has been tested and is free of leaks. All internal packaging has been removed. The gas supply shut off valve has been located. The hose and regulator are properly connected. All burners are factory installed. WARNING 1. Do not store spare liquid propane cylinders under or near this appliance. 2. Never fill the cylinder beyond
Summary of the content on the page No. 15
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND ROTISSERIE Each main burner is rated at 13,000 BTU/Hr. The After its first use, the stainless steel adjacent to the main grill burners encompass the entire cooking rotisserie burner will most likely turn dark blue. This area and are side ported to minimize blockage from is a normal property of the non-rusting type falling grease and debris. Above the burners are stainless steel used on the grill. stainless steel flame tamers. The ignit
Summary of the content on the page No. 16
NOTE Adjust the counter balance weight to balance the It is normal for the skewer to flex when larger cuts heavier side of the meat and avoid lopsided rotation of meat are being cooked. of the rotisserie motor. If the meat scrapes on the cooking grids during any CAUTION part of the rotation, the cooking grids must be When using the rotisserie burner, remove the removed. Test this clearance before lighting the grill warming rack. High heat from the burner may cause as the cooking
Summary of the content on the page No. 17
TO MATCH LIGHT THE GRILL If the burner will not light after several attempts using the control knobs, the burner may be lit with a match. 1. If you have already attempted to light the burner with the igniter, wait 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod. Ignite the match and insert through the cooking grids to the burner. 3. Press the control knob and rotate it left to the “HI” setting. Continue to press the knob until the burne
Summary of the content on the page No. 18
LIGHTING ILLUSTRATIONS MAIN, SIDE , ROTISSERIE & REAR BURNER LIGHTING 1. Open the top cover or lid. 2. Push and turn the main, side, rotisserie or rear burner control knobs to the “HI” setting. Push the knob until the burner ignites. The burner should ignite within 4 seconds (if burner does not ignite follow match lighting instructions on Page15. 3. Once the burner ignites, adjust the temperature level as
Summary of the content on the page No. 19
USING THE SIDE BURNER 4. If the smell of gas is detected and the igniter Inspect the gas supply hose prior to turning on is not functioning, immediately turn the control the gas. If there is evidence of cuts, wear or knob to the “OFF” position. abrasion, it must be replaced prior to use. Do not use the side burner if gas odor is present. 5. Allow 5 minutes for any accumulated gas to dissipate. If the side burner igniter will not function, follow the match lighting instruct
Summary of the content on the page No. 20
CARE & MAINTENANCE OF THE GRILL STAINLESS STEEL GRILL BURNERS Grease specks can gather and bake onto the Extreme care should be taken when moving a surfaces of the stainless steel, giving the burner. It must be correctly centered on the appearance of rust. For removal, use an abrasive orifice before any attempt is made to relight the pad with a stainless steel cleaner. grill. Frequency of cleaning will depend on how often you use the grill. GRILL RACK The easiest way to cle
