Summary of the content on the page No. 1
S S
oonnoom maa
S S
oonnoom maa
TM
PLA PLATINUM TINUM EDITION EDITION
Sonoma Platinum Edition Grill:
27” Model
USE AND CARE MANUAL
FOR OUTDOOR USE ONLY
MADE IN THE U.S.A.
Summary of the content on the page No. 2
Summary of the content on the page No. 3
General Safety Instructions IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED. - This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids. Do not allow flammable materials to co
Summary of the content on the page No. 4
Grill Features: SGR27LP 6 1 7 2 10 3 11 8 4 9 5 1. Roll top grill hood 7. Warming shelf 2. Grilling/Cooking surface 8. Electronic igniter: main & side burner 3. Side Shelf 9. Cart with door 4. Control knobs: main burners 10. Side Burner 5. Convection vents 11. Control knob: Side Burner 6. Hood Handle 2
Summary of the content on the page No. 5
Grill Assembly IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling. Fig. 1 LEFT SHELF ASSEMBLY 1. Open the grill hood and place a piece of styrofoam from the packaging under the grill hood to prop the grill hood open slightly. (See Fig. 1) 2. Attach the left shelf by inserting the four shelf hooks into the slots on the side of the grill. (See Fig. 1) 3
Summary of the content on the page No. 6
Grill Assembly 5. Slide the valve assembly through the center hole in the front of the shelf. (See Fig. 5) 6. Insert one valve screw through the bezel and in to the side burner valve and tighten. Next, install the second Fig. 5 valve screw through the bezel and tighten (See Fig. 6) 7. Press the side burner assembly upward into the side burner tray (See Fig. 7) and install two (2) self tapping screws from the top of the tray. (See Fig. 8) 8. Install metal knob, making sure to line up the flat sid
Summary of the content on the page No. 7
Grill Assembly IGNITER ASSEMBLY 1. The battery, spring and igniter cap must be installed before using. 2. Slide the threaded part of the igniter through the mounting bracket and then through the igniter hole in the front of the Fig. 13 side burner shelf, then install the locknut. (See Fig. 13) 3. Slide spring assembly over the negative side of the battery. (See Fig. 14) 4. Install the battery, positive side first. (See Fig. 14) 5. Screw igniter cap onto igniter. (See Fig. 15) 6. Attach the larg
Summary of the content on the page No. 8
Gas Requirements L.P. GAS INSTALLATION Sonoma Gas Grills are set to operate with L.P. gas and come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Sonoma). This assembly is designed to connect directly to a standard 20 lb. L.P. cylinder. L.P. Cylinders are not included with the grill. L.P. Cylinders can be purchased separately at an independent d
Summary of the content on the page No. 9
Pre Operation Leak Testing GENERAL INFORMATION Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness check must be per- formed at the installation site due to possible shifting during shipment, installation or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks and immediately check the system if the smell of gas is detected. BEFORE TESTING Do not smoke while leak testing. Extinguish all open fla
Summary of the content on the page No. 10
Lighting the Grill Do not attempt to “Light” the grill if the odor of gas is present!! BEFORE LIGHTING Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as Fig. 21 possible when lighting. GRILL BURNER LIGHTING Lighting the Grill with electronic igniter 1. Make sure all control knobs are in the “OFF” position. 2. Open the gas supply valve located on top of your L.P. tank. ATTENTION: When turning the L.P
Summary of the content on the page No. 11
Using the Grill GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation. NOTE: The grill will operate best if it is not facing directly into the wind. Clearance to combustible construction - A minimum of 12” from the sides and back must be maintained from
Summary of the content on the page No. 12
Using the Side Burner SIDE BURNER LIGHTING Push and turn the control knob to the “HIGH” position and immediately press and hold the electronic igniter button. You’ll hear a snapping sound. It may be necessary to hold the electronic starter button for about 4 seconds. If the burn- er does not light in 4 seconds, turn the knob to the “OFF” position and wait 5 minutes before trying again. (See Fig. 26) MATCH LIGHTING Fig. 26 If by chance the electronic igniter does not light the burner, the burner
Summary of the content on the page No. 13
Care and Maintenance DRIP TRAY The drip tray should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. Important: Do not leave the grill outside during inclement weather unless it is covered. Rain water can collect inside of the grill, the grill cart or the drip tray if left uncovered. If the drip tray is not cleaned after use and the grill is left uncovered, the drip tray will fill with water causing grease and water to sp
Summary of the content on the page No. 14
Troubleshooting Your Grill GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditions occur: • The smell of gas. • Flames appearing mostly yellow. (some yellow at the tips is OK) • The grill will not get hot enough. • Burners make a snapping noise. • The grill heats unevenly. SPIDER AND INSECT WARNING Spider and insects can nest in the burners of this or any other grill and cause the gas to flow from the front of the burner. Thi
Summary of the content on the page No. 15
Troubleshooting Your Grill PROBLEM SOLUTION Grill will not light with a match or low heat with dial set • Is your gas supply fully turned on? to "High" position. • Is there gas in your L.P. tank ? Check your gas level. • Shut off gas supply, disconnect gas line at tank, reconnect the line to the tank. • Make sure all the knobs are in the off position, then open the gas supply valve on the L.P. tank very slowly 1/4 turn, then open fully (at least two full turns). Check flame height again. • Check
Summary of the content on the page No. 16
Warranty LIMITED LIFETIME WARRANTY Sonoma warrants this grill to the original purchaser of our grills when subject to normal residential use to be free from defects in workmanship and materials for the periods listed below. IMPORTANT: We recommend you return the warranty registration card so that you can be contacted with any questions of safety arise that could affect you. The return of the warranty registration card is not a condition for warranty coverage. LIMITED WARRANTY Component Warr
