Summary of the content on the page No. 1
Heavy-Duty Gas Grill
Parrilla de Gas de Alta Resistencia
OWNER’S MANUAL / MANUAL DEL PROPIETARIO
ASSEMBLY AND OPERATING IN STRUC TIONS
INSTRUCCIONES DE ARMADO Y OPERACIÓN
SAVE THIS MANUAL FOR FUTURE REFERENCE
GUARDE ESTE MANUAL PARA REFERENCIA FUTURA
WARNING/ADVERTENCIA
NOTICE TO INSTALLER:
HAZARDOUS EXPLOSION MAY RESULT IF THESE WARNINGS AND INSTRUCTIONS
LEAVE THESE INSTRUCTIONS
ARE IGNORED. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS IN THIS
WITH THE GRILL OWNER FOR
MANUAL TO AVOID PERSO
Summary of the content on the page No. 2
IMPORTANT SAFETY WARNINGS WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL. DANGER IF YOU SMELL GAS: 1. Shut off gas to the appliance. 2. Extinguish any open fl ame.
Summary of the content on the page No. 3
TABLE OF CONTENTS: General Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 LP Gas Cylinder (Tank) Specifi cations and Installation. . . . . . . . . . . . . . . . 4-6 Hose & Regulator Specifi cations and Installation . . . . . . . . . . . . . . . . . . . . 6-7 Leak Testing. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-8 Pre-start Check List . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
GENERAL WARNINGS: WARNING • Leak test all connections before fi rst use, even if grill was purchased fully assembled and after each tank refi ll. Check the propane tank rubber seal for damage. • Always check the grill and propane tank prior to each use as indicated in the “Checking for Leaks” & “Pre-Start Check List” sections of this manual. • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal, lava rocks or wood briquets in a gas grill. Flavoring chips must
Summary of the content on the page No. 5
• Grill is hot when in use. To avoid burns: • DO NOT attempt to move the grill. • Block the wheels so the unit does not accidentally move. • Wear protective gloves or oven mitts. • DO NOT touch any hot grill surfaces. • DO NOT wear loose clothing or allow hair to come in contact with grill. • Not for commercial use. DO NOT use this grill for anything other than its intended purpose. USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR GAS GRILL. FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GU
Summary of the content on the page No. 6
LP GAS CYLINDER (TANK) SPECIFICATIONS: LP gas cylinder (not supplied with this grill) The LP (Liquid Propane) gas cylinder specifi cally designed to be used with this grill must be 12” (30.5 cm) diameter x 18” (45.7 cm) tall and have a 20 lb. (9.1 kg) capacity incorporating a Type 1 cylinder valve and an over-fi lling protection device (OPD). This grill is designed to fi t Worthington, Manchester or SMPC brand 20 lb. (9.1 kg) cylinders. Other brand DOT cylinders may fi t this grill if the cyl
Summary of the content on the page No. 7
LP GAS CYLINDER (TANK) RUBBER SEAL INSPECTION: • Inspect the propane tank valve rubber seal for cracks, wear or deterioration prior to use. A damaged rubber seal can cause a gas leak, possibly resulting in an explosion, fi re or severe bodily harm. • Inspection should be done each time the propane tank is connected to the grill, has been refi lled, exchanged or has not been used for more than 60 days. • Do not use a propane tank with a damaged rubber seal. Good Damaged Exchange the tank o
Summary of the content on the page No. 8
HOSE AND REGULATOR: Your grill is equipped with a Type 1 connection device with the following features: 1. The system will not allow gas fl ow from the cylinder until a positive connection to the valve has been made. Note: The cylinder valve and all grill burner knobs must be turned OFF before any connection is made or removed. 2. A regulator fl ow limiting device, when activated, restricts the fl ow of gas to 10 cubic feet per hour. If the fl ow limiting device is activated, perform Regula
Summary of the content on the page No. 9
DANGER To prevent fi re or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS in a well ventilated area that is protected from the wind. • Never perform a leak test with a match or open fl ame. • Never perform a leak test while the grill is in use or while grill is still hot. WHEN TO PERFORM A LEAK TEST: • After assembling your grill and before lighting for the fi rst time, even if purchased fully assembled. • Every t
Summary of the content on the page No. 10
PRE-START CHECK LIST: DANGER Property damage, bodily harm, severe burns, and death could result from failure to follow these safety steps. These steps should be performed after the grill has been assembled and prior to each use. DO NOT operate this grill until you have read and understand ALL of the warnings and instructions in this manual. • Ensure that the grill is properly assembled. • Inspect the gas supply hose for burns, chaffing, kinks, and proper routing before each use. If it is evi
Summary of the content on the page No. 11
6. Repeat steps 3–5 for lighting each burner. Always use electronic igniter for lighting each burner. If burner does not ignite using the push-button igniter, wait 5 minutes, see “Match Lighting the Main Burners” section. 7. To turn off, turn each control knob clockwise until it locks in the “OFF” position. This does not turn off the gas fl ow from the cylinder.. Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual. MATCH LIGHTING THE MA
Summary of the content on the page No. 12
OPERATING THE GRILL: WARNING • Read and follow all warnings and instructions contained in the preceding sections of this manual. • Never use charcoal, lava rocks or wood briquets in a gas grill. Flavoring chips must be contained in a metal smoking box to contain ash and prevent fi res. • DO NOT cover cooking grates or other components with aluminum foil, as this blocks ventilation and damage to grill or personal injury may occur. • DO NOT leave your grill unattended while “ON” or in use. • D
Summary of the content on the page No. 13
ROTISSERIE COOKING: • Your grill was pre-drilled from factory to include mounting holes for a rotisserie (sold separately). Do not use a rotisserie not specifi cally manufactured for this grill. • Read and follow all instructions provided with the rotisserie. Save instructions for future reference. • Do not use the side burner when using a rotisserie. WARNING • When using an AC current rotisserie, it must be electrically grounded in accordance with local codes, or in the absence of local codes
Summary of the content on the page No. 14
PROPER CARE & MAINTENANCE: WARNING: If a bristle brush is used to clean any of the cooking surfaces, ensure no loose bristles remain on the cooking surfaces prior to grilling as loose bristles may attach to food. CLEANING INTERIOR OF GRILL: • We recommend cleaning off food residue immediately after cooking by gently scrubbing grates with wire bristle brush and then turning burners to HIGH for approximately 5 minutes. WARNING: DO NOT leave grill unattended when grill is on. Wear oven mitts t
Summary of the content on the page No. 15
BURNER ASSEMBLY/MAINTENANCE: • Although your burners are constructed of stainless steel, they may corrode as a result of the extreme heat and acids from cooking foods. Regularly inspect the burners for cracks, abnormal holes, and other signs of corrosion damage. If found, replace the burner. • DO NOT block ventilation areas in sides, back or cart Debris compartment of grill. Burner tubes can become blocked by spiders and other insects building their nests. Blocked burner tubes can preven
Summary of the content on the page No. 16
BURNER ADJUSTMENT: WARNING • DO NOT attempt to adjust burner air shutter until grill has cooled down for approximately 30 minutes. Failure to do so could cause severe burns. • Normal fl ame should be soft blue with yellow tips between 1 in. - 2 in. when burner is on “HIGH” . Depending on elevation, burner air shutter may need to be adjusted to obtain correct air to fuel ratio. CORRECT INCORRECT Soft blue fl ame with yellow tips Wavy with yellow fl ames • To adjust air shutter, loosen set screw
Summary of the content on the page No. 17
TROUBLE SHOOTING: To see trouble shooting or assembly videos, visit us at: Problem Possible Cause Prevention/Cure Burner will not light LP gas tank valve is closed Make sure regulator is securely attached to the LP gas tank, turn LP gas tank valve to “OPEN” LP gas tank is low or empty Check if LP gas tank is empty. If empty, replace or refi ll. LP gas leak 1. Turn LP gas tank valve to “CLOSED” 2. Wait 5 minutes for gas to clear 3. Follow “Leak Testing” in the owner’s manual Coupling nut and reg
Summary of the content on the page No. 18
Problem Possible Cause Prevention/Cure Flame blows out High or gusting winds Do not use grill in high winds Low on LP gas Replace or refi ll LP gas tank Burner holes may be obstructed Refer to “Burner Assembly/Maintenance” instructions Flow limiting device tripped Refer to “Regulator Resetting Procedure” Flare-up Grease buildup Clean all grill parts per “Proper Care and Maintenance” instructions Excess fat in meat Trim fat from meat before grilling Excessive cooking temperature Adjust (lower) co
Summary of the content on the page No. 19
ASSEMBLY INSTRUCTIONS: Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS before you begin the installation process. PARTS BAG CONTAINS: Qty. Qty. 8 M6 X 12 mm Bolts (Black) 1 Locking Nut 17 M6 X 12 mm Bolts (Silver) 2 M6 Washers 4 M6 X 30 mm Bolts (Silver) 3 Hinge Pins 2 M5 X 12 mm Bolts (Black) 3 Cotter Pins 2 M4 X 12 mm Bolts (Black) 3 AA/1.5V Alkaline Batteries 8 M4 X 12 mm Bolts (SIlver) 1 Caster Tightening Pin 1 Shoulder Bolt (Black) M6 X 12
Summary of the content on the page No. 20
READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN AS SEM BLING THIS UNIT. The following tools are required to assemble this Brinkmann Heavy-Duty Gas Grill: • Screwdriver • Hex Nut Wrench PARTS LIST: 16 1 1 Grill Body Assembly 1 Grease Tray 17 2 1 Left Side Table Assembly 1 Cart Base 18 3 1 Right Side Table Assembly 1 Lower Cart Brace 4 19 1 Warming Rack 1 Door Stopper 20 5 3 Cooking Grills 1 Ta
