Summary of the content on the page No. 1
GB
Instructions – Garage Door Operator Model ML700-GB,
ML750-GB and ML850-GB
WARNING: DAMAGE MAY OCCUR TO DOOR OR OPERATOR IF
IR PROTECTOR SYSTEM IS NOT INSTALLED. PROTECTOR SYSTEM
MUST BE INSTALLED FOR PROPER FUNCTIONING OF THE OPENER.
SEE PROTECTOR SYSTEM INSTALLATION STEPS.
GB 0800 317847
i
114A2804E-GB
Summary of the content on the page No. 2
Start by Reading These Important Safety Instructions Failure to comply with the following instructions may result in serious personal injury or property damage. • Read these instructions carefully • The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual. These safety alert symbols mean WARNING – a personal safety or property damage instruction. Read these instructions carefully
Summary of the content on the page No. 3
Tools Required 2 8 Attach Trolley to Rail Slide outer trolley (1) into back (opener) end of the rail assembly (2), Hardware Provided 3 be sure end with trolley release arm (3) is heading in direction of opener. Slide outer trolley down rail until it engages with inner trolley. (1) Hex Bolt (4) (13) Hex Nut (7) (2) Clevis Pin (1) (14) Ring Fastener (3) 9 Fasten Rail to Opener and Install (3) 8mm Carriage Bolt (3) (15) Rail Grease (1) Chain/Belt (4) Wood Screws (8) (16) Lock Nut (1) Remove four wa
Summary of the content on the page No. 4
Connect Electric Power 13 Install the Header Bracket TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE NOTE: Refer to vertical center and horizontal lines created in step GARAGE DOOR OPENER UNTIL INSTRUCTED TO DO SO. 12 for proper placement of header bracket. Connect the door opener only to an outlet controlled by a double A. Wall Mount: Center the header bracket (1) on the vertical center pole switch. line (2) with the bottom edge of the header bracket on the horizontal line (4) (with the arro
Summary of the content on the page No. 5
21 Install Door Control 22 Install the Protector System™ Locate door control where the garage door is visible, away from In order to operate this unit, the Protector System™ MUST be door and door hardware and out of the reach of children. Mount installed. at least 1,5 m (5 feet) above the floor The Protector System™ provides an additional measure of safety Serious personal injury from a moving garage door may result against a small child being caught under a garage door. from misuse of opener.
Summary of the content on the page No. 6
Aligning the Safety Sensors 23 Program your Opener & Remote Plug in opener. Indicator lights in both sending and receiving eyes Activate the opener only when door is in full view, free of will glow steadily if wiring connections and alignment are correct. obstruction and properly adjusted. No one should enter or leave Sending eye orange indicator light will glow regardless of alignment or garage while door is in motion. Do not allow children to operate obstruction. If green indicator light in re
Summary of the content on the page No. 7
ADJUSTMENT SECTION 24 Program your Keyless Entry Activate the opener only when door is in full view, free of 25 Setting the Limits obstruction and properly adjusted. No one should enter or leave Travel limits regulate the points at which the door will stop when garage while door is in motion. Do not allow children to operate moving up or down. Follow the steps below to set the limits. push button(s) or remote(s). Do not allow children to play near To program the travel limits: the door. 1. Open
Summary of the content on the page No. 8
28 Special Features 30 Accessories A. Door within a door connection (1) Model 84330EML Single-Function Remote Control (2) Model 84333EML 3-Function Remote Control Open light lens. Locate auxiliary quick connect terminals. Insert bell wire into quick connect terminals 8 and 7 (3) Model 84335EML 3-Function Mini Remote Control B. Flashing light connection (4) Model 8747EML Keyless Entry System The flashing light can be installed anywhere. Connect light leads (5) Model 845EML Multi-Function Door Co
Summary of the content on the page No. 9
HAVING A PROBLEM? 1. Opener doesn't operate from either door control or remote: 12. Opener strains: • Does the opener have electric power? Plug lamp into outlet. If it Door may be unbalanced or springs are broken. Close door and use manual release rope and handle to disconnect trolley. Open and close doesn't light, check the fuse box or the circuit breaker. (Some outlets are controlled by a wall switch.) door manually. A properly balanced door will stay in any point of travel while being support
Summary of the content on the page No. 10
CARE OF YOUR OPENER OPERATION OF YOUR OPENER When properly installed, opener will provide high performance with Your opener can be activated by any of the following devices: a minimum of maintenance. The opener does not require additional • The Lighted Door Control Button. Hold the button down until door lubrication. starts to move. Limit and Force Settings: These settings must be checked and • The Outside Keylock or Keyless Entry System (if you have properly set when opener is installed. Weathe
Summary of the content on the page No. 11
SPECIFICATIONS Input Voltage...................230-240 VAC, 50Hz Max. Pull Force ..............700N (ML700-GB, ML750-GB) ........................................800N (ML850-GB) Power .............................115W (ML700-GB, ML750-GB) ........................................125 (ML850-GB) Standby-by power rating @ 230V......5.5W (ML700-GB, ML750-GB, ML850-GB) Normal Torque ................7Nm (ML700-GB, ML750-GB) ........................................8Nm (ML850-GB) Motor Type..............
Summary of the content on the page No. 12
Summary of the content on the page No. 13
Summary of the content on the page No. 14
1 1 A B D C E 2 10 mm, 8 mm, 4,5 mm, 4 mm 11mm, 13mm 2 114A2884D 2
Summary of the content on the page No. 15
Summary of the content on the page No. 16
Summary of the content on the page No. 17
Summary of the content on the page No. 18
Summary of the content on the page No. 19
Summary of the content on the page No. 20
