Summary of the content on the page No. 1
Register your product and get support at
www.philips.com/welcome
EN USER MANUAL
Summary of the content on the page No. 2
Model Serial www.philips.com/support Country Number Tariff Austria 0810 000205 €0.07/min Belgium 078250145 €0.06/min Bulgaria +3592 489 99 96 local Croatia 01 3033 754 local Czech Rep 800142840 free Denmark 3525 8759 local Finland 09 2311 3415 local France 0821 611655 €0.09/min Germany 01803 386 852 €0.09/min Greece 0 0800 3122 1280 free Hungary 0680018189 free Ireland 01 601 1777 local Italy 840320086 €0.08/min Luxembourg 40 6661 5644 local Netherlands 0900 8407 €0.10/min Norway 227
Summary of the content on the page No. 3
Summary of the content on the page No. 4
Table of contents 7. Connect devices . . . . . . . . . . . . . . . . . . . . . . 18 7.1. Connection overview . . . . . . . . . . . . . 18 7.2. Select connection quality . . . . . . . . . . 19 1. Important. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 7.3. Connect devices . . . . . . . . . . . . . . . . . 21 1.1. Safety . . . . . . . . . . . . . . . . . . . . . . . . . . .3 1.2. Screen care . . . . . . . . . . . . . . . . . . . . . .4 1.3. Environmental care . . . . . . . . .
Summary of the content on the page No. 5
2008 © Koninklijke Philips performing source distribution, a 1. Remove fuse cover and fuse. Electronics N.V. All rights reserved. complete machine-readable copy 2. The replacement fuse must Specifications are subject to change of the corresponding source code comply with BS 1362 and have on a medium customarily used for without notice. Trademarks are the ASTA approval mark. If the the property of Koninklijke Philips software interchange. fuse is lost, contact your dealer in Electronics N
Summary of the content on the page No. 6
• To avoid risk of fire or electric shock, do 1. Important not place the TV, remote control or remote control batteries near naked flame sources Congratulations on your purchase and (e.g. lighted candles) and other heat sources welcome to Philips! including direct sunlight. Read this user manual before you start to use • Do not install the TV in a confined space this product. such as a bookcase. Leave a space of at least 10cm (four inches) around the TV Pay close attention to this
Summary of the content on the page No. 7
• Turn off the TV, then the mains power (if of time. Examples include screen menus, available). teletext pages, black bars or stock market tickers. If you must use stationary images, • Unplug the mains cord from the mains reduce the screen contrast and brightness socket outlet. to avoid screen damage. 1.3 Environmental care Recycling your packaging The packaging of this product is intended to be recycled. Contact your local authorities for information on how to recycle the packagi
Summary of the content on the page No. 8
Back connectors. 2. Your TV This section gives you an overview of commonly-used TV controls and functions. EXT 3 2.1 TV overview Side controls Use the TV back connectors to connect to the VOLUME 4 antenna and permanent devices such as a high- definition disc player, DVD player or VCR. 3 MENU D Note: For more information about connections, see Section 7 Connect devices. PROGRAM 2 1 POWER 5 1. POWER 2. PROGRAM +/- 3. MENU 4. VOLUME +/- 5. Power indicator/remote control sensor Side connec
Summary of the content on the page No. 9
Remote control 1. . Power 2. SOURCE 3. TELETEXT 1 4. Colour keys From left, red, green, yellow, blue 2 5. Í, Æ, Î, ï, OK 3 Navigation or cursor keys 6. MENU 4 7. P +/- Program up or down 8. ” +/- 5 Volume up or down For more information about the remote control, see Section 5.1 Remote control overview. 6 7 8 EN-6
Summary of the content on the page No. 10
3.2 Wall mount the TV 3. Get started B WARNING: Wall mounting of the TV This section helps you position and install the should only be performed by qualified TV and supplements the information provided installers. Koninklijke Philips Electronics in the Quick Start Guide. N.V. bears no responsibility for improper D Note: Refer to the Quick Start Guide for mounting that results in accident or stand mounting instructions. injury. Step 1 Purchase a VESA-compatible wall 3.1 Position the TV
Summary of the content on the page No. 11
easier installation. Refer to your VESA- compatible wall bracket documentation for instructions. 1. Locate the four mounting nuts at the back of the TV. 3. Firmly pull the stand from the bottom of the TV. Place both the stand and bolts in a secure location for future reinstallation. 2. Align the plate/bracket to the four mounting nuts, placing the spacers between the plate/bracket and the mounting nuts. 3. Using a spanner, insert the bolts through the plate/bracket and spacers, tightl
Summary of the content on the page No. 12
3.3 Connect the antenna cable 3.4 Connect the mains cord 1. Locate the TV ANTENNA connector at B WARNING: Verify that your mains the back of the TV. voltage corresponds with the voltage 2. Connect one end of an antenna cable printed at the back of the TV. Do not (not supplied) to the TV ANTENNA insert the mains cord if the voltage is dif- connector. Use an adaptor if the antenna ferent. cable does not fit. To connect the mains cord D Note The location of the mains connector varies accor
Summary of the content on the page No. 13
3.5 Manage cables 3.7 Switch on the TV Route your mains cord, antenna cable and all The first time you switch on the TV, check that other device cables through the cable holder the mains cord is properly connected. When (1) at the back of the TV. ready, then press POWER on the side of the TV. D Note: Certain TV models require you to press and hold POWER for up to two seconds. Your TV may take up to 15 seconds to start. 3.8 First time setup 1 When you turn on the TV for the fir
Summary of the content on the page No. 14
be consumed as long as the mains remain 4. Use your TV connected and powered. When not in use for extended periods of time, switch off and This section helps you perform basic TV disconnect the TV from the mains. operations. Instructions on advanced TV opera- tions are provided in Section 5 Use more of your TV. Switch on from standby • If the power indicator is in standby (red), 4.1 Switch on/off or to standby press . on the remote control. Switch on your TV • If the power indica
Summary of the content on the page No. 15
Adjust volume 4.4 Use teletext 1. Press TELETEXT on the remote control. The main index page appears. • Press + or - on the remote control, or press VOLUME + or - on the side controls of the TV. • Press on the remote control to mute 2. Press the number keys to enter a page the sound. Press again to unmute on the number. sound. 3. Press P +/- or Î/ï to view the next or previous page. D Note: For headphones: • Press + or - on the remote control 4. Press a colour key to select one
Summary of the content on the page No. 16
Selects a picture format or freezes a 5. Use more of your TV teletext page. 4. DUAL I-II/REVEAL Press repeatedly to select a sound mode or 5.1 Remote control overview to toggle between reveal and conceal mode. 5. Colour keys Select tasks or teletext pages. 1 6. INFO Displays programme information, if available. 2 21 7. OK 20 3 Accesses the All channels menu or 4 19 5 activates a setting. 8. Í, Æ, Î, ï 18 6 Navigate the menus. 9. Incredible Surround 7 17 Adds greater depth and dime
Summary of the content on the page No. 17
5.2 Use TV menus Main Control 4 Picture 8 On-screen menus help you install your TV, Picture Smart picture adjust picture and sound settings and access Sound Contrast other features. This section describes how to Features Brightness navigate the menus. Install Colour Sharpness Tint Access the main menu Color temp 1. Press MENU on the remote control to Picture format display the main menu. The picture menu contains the settings that affect the quality of the picture. Description of picture
Summary of the content on the page No. 18
• Super zoom (Not for HD) Removes the black bars on the side of 4:3 Main Control 4 Sound 4 broadcasts with minimal distortion. Picture Smart sound Sound Settings Features Incredible surround Install AVL • 4:3 (Not for HD) Displays the classic 4:3 format. The sound menu contains the settings that affect the reproduction of the sound. 2. Press Î or ï to highlight a setting and press Æ to select the setting. • Movie expand 14:9 (Not for HD) 3. Press Î or ï to adjust the setting, and Scales
Summary of the content on the page No. 19
Timer 6. Install channels • Clock: set the time. This chapter provides instructions on how • Star t time: set the time to turn the TV on to perform a first-time setup and reinstall automatically. channels. • Stop time: set the time to turn the TV off D Note: Reinstalling channels modifies the automatically. All channels list. • Sleep timer: select an automatic standby period, from 0 to 180 minutes. 6.1 Automatically install channels NR Attenuates picture noise (snow) in difficul
Summary of the content on the page No. 20
1. Press MENU on the remote control and 4. Select Prog. No., and press the number select Install > Auto store. 0 to 9 or Î / ï to enter the program number. 2. Press Æ to select Start. 5. Select Finetune, and press Î or ï to 3. Press OK to confirm. adjust the tuning. 4. When the channel search is complete, press 6. Select Store and press Æ to store the MENU to exit. program. 7. Repeat the above steps for each program 6.2 Manually store channels you want to store. 8. Press MENU to exit.
