Summary of the content on the page No. 1
USER’S MANUAL
MANUEL DE L’UTILISATEUR
MANUAL DEL USUARIO
LD-3260
Summary of the content on the page No. 2
English TABLE OF CONTENTS TABLE OF CONTENTS TABLE OF CONTENTS.................................................... i DIGITAL TELEVISION TRANSITION NOTICE .................. 1 IMPORTANT INFORMATION .......................................... 2 Warnings.................................................................... 2 NOTICES ................................................................... 3 FCC COMPLIANCE STATEMENT ............................... 4 IMPORTANT SAFETY INSTRUCTIONS .............
Summary of the content on the page No. 3
Summary of the content on the page No. 4
Summary of the content on the page No. 5
English DIGITAL TELEVISION TRANSITION NOTICE DIGITAL TELEVISION TRANSITION NOTICE This device contains a digital television tuner, so it should receive digital over the air TV programming, with a suitable antenna, after the end of full-power analog TV broadcasting in the United States on June 12, 2009. The nationwide switch to digital television broadcasting will be complete on June 12, 2009, but your local television stations may switch sooner. After the switch, analog-only television sets
Summary of the content on the page No. 6
English IMPORTANT INFORMATION IMPORTANT INFORMATION Warnings To reduce the risk of fire or electric shock: • Do not expose this product to rain or moisture. • Do not remove the rear cover. There are no user-serviceable parts inside. Refer all servicing requirements to qualified service personnel. • The plug should be connected to a mains socket outlet with a protective earthing connection. The lightning flash with arrowhead inside an equilateral triangle symbol is intended to alert the user t
Summary of the content on the page No. 7
English IMPORTANT INFORMATION NOTICES Important Notices Concerning Power Cord Selection The specific power cord for this LED TV is enclosed and has been selected according to the country of destination. Use the enclosed power cord to prevent electric shock. Observe the following guidelines if it is necessary to replace the original cord set, or if there is no cord set enclosed. The female receptacle of the cord set must meet IEC-60320 requirements and should look like Figure A1 below: Figure
Summary of the content on the page No. 8
English IMPORTANT INFORMATION FCC COMPLIANCE STATEMENT This equipment has been tested and complies with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and may cause harmful interference to radio communications if not installed and used in accordance with the instructions.
Summary of the content on the page No. 9
English IMPORTANT INFORMATION IMPORTANT SAFETY INSTRUCTIONS Make sure to note and follow all warnings and instructions marked on the LED TV. Observe the following safety instructions. • Read these instructions. • Keep these instructions. • Heed all warnings. • Follow all instructions. • Do not use this apparatus near water. • Clean only with dry cloth. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources suc
Summary of the content on the page No. 10
English IMPORTANT INFORMATION Circuit Overload Do not overload wall outlets, extension cords, or power strips. This can result in a fire or electronic shock. Power Cord Protection Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. Periodically inspect the cords for damage. Install the LED TV near a wall socket outlet where the power cord can be readily accessed. Ventilation The slots and openings on the cabinet are
Summary of the content on the page No. 11
English IMPORTANT INFORMATION WARNINGS AND PRECAUTIONS • Do not orient the LED TV towards direct sunlight to reduce glare. • If the LED TV will not be used for a long period of time, unplug the unit and remove the batteries from the remote control. • Avoid touching the display screen by hand or any object. • Never remove the rear cover. The LED TV interior contains high-voltage parts. You may be seriously injured if you touch them. • Always handle the LED TV with caution when moving it. • Do n
Summary of the content on the page No. 12
English IMPORTANT INFORMATION ANTENNA INSTALLATION SAFETY Outdoor Antenna Grounding If an outside antenna or cable system is connected to the LED TV, be sure the antenna or cable system is grounded to prevent voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANS/NFPA 70, provides information on proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, connection to grounding electrodes, and requi
Summary of the content on the page No. 13
English IMPORTANT INFORMATION CLEANING THE LED TV • Make sure the LED TV is turned off and the power cord is disconnected from the power outlet. • Never spray or pour any liquid directly onto the screen or the case. To clean the screen: 1 Wipe the screen with a clean, soft, lint-free cloth. This removes dust and other particles. 2 If it is still not clean, apply a small amount of non-ammonia, non-alcohol based glass cleaner onto a clean, soft, lint-free cloth, and wipe the screen. To clean t
Summary of the content on the page No. 14
ENGLISH IMPORTANT INFORMATION Open Source License This product includes software code developed by third parties, and may include software code that is subject to open source software license such as the GNU General Public License (GPL) or the GNU Lesser General Public License (LGPL). Open source licenses ensure users’ freedom to run, copy, distribute, study, change and improve the software. Any such open source code is subject
Summary of the content on the page No. 15
Summary of the content on the page No. 16
English MENU VOL CH INPUT R L CONTROL PANEL CONTROL PANEL 1 2 3 4 5 Item Description 1. MENU Displays the LED TV setup screen. • Adjusts the volume during playback. 2. Volume +/- • Selects an item on a menu screen. • Switches the channel during TV viewing. 3. Channel +/- • Selects an item on a menu screen. • Selects the video input source. 4. INPUT • Executes a command on a menu screen. 5. Power Toggles the power on and off. 11 USB R L AV 2
Summary of the content on the page No. 17
English TERMINALS TERMINALS 8 9 10 1 2 3 4 56 7 11 12 - AUDIO R L AUDIO - - DC IN HDMI 1 HDMI 2 VGA IN Y Pb Pr OUT Item Function Connects the AC adapter from this outlet to a 1. DC in power source. Connects to an external AV device such as a 2. HDMI 1/2 VCR, DVD player, set-top box, or game system. Connects to a computer or other device with a 3. VGA VGA output using a 15-pin VGA cable. 4. Audio in Connects to the audio out port of a computer. 5. Component input Connect to an exter
Summary of the content on the page No. 18
English REMOTE CONTROL REMOTE CONTROL Item Description Mutes the sound. Press again to toggle 1. Mute the sound back on. Toggles the TV power on or off. 2. Power Adjusts the LED screen backlight. 3. Backlight Toggles the Multichannel Television 1 2 4. MTS Sound options. Toggles the closed caption display on or 3 4 5. CC C.C. ZZZ MTS off. 5 6 Favorite A Sets the sleep timer for the LED TV to Z 6. Sleep z z turn off automatically. B 8 7. Channel keys Use to key in the channel number. 7 C S
Summary of the content on the page No. 19
English REMOTE CONTROL OPERATION REMOTE CONTROL OPERATION INSTALLING THE REMOTE CONTROL BATTERIES CAUTIONS: • Only use AAA batteries. • Do not mix new and old batteries. This may result in cracking or leakage, which may pose a fire risk or lead to personal injury. • Insert batteries according to the (+) and (-) markings. Inserting the batteries incorrectly may result in cracking or leakage, which may pose a risk of fire or lead to physical injury. • Dispose of used batteries in accordance wit
Summary of the content on the page No. 20
English LED TV BASE LED TV BASE CAUTION: The LED TV unit may be too heavy for one person to lift. If this is the case, make sure to ask for assistance in handling the LED TV to prevent physical injury and/or damage to the unit. INSTALLING THE LED TV BASE 1 Open the LED TV carton box. 2 Remove the LED TV base. 3 Remove the plastic bag. 4 Remove the two top carton stabilizers from the LED TV. 5 Remove the protective plastic covering the LED TV. 6 Grasp the two sides of the LED TV and then pull i
