Edelbrock Predator Carburetor user manual

Summary of the content on the page No. 1

INSTRUCTION SUPPLEMENT FOR 2003-
LATER POLARIS PREDATOR



Removing stock carburetor and cables.




1. Remove seat and gas tank. Make sure fuel
petcock is in “off” position.


2. Remove throttle cable paying close attention

to routing, as the new cable(s) will need too
Thumb Throttle Instructions
be routed the same.


NOTE: #3196 KIT REQUIRES THE USE OF
3. Remove stock carburetor and stock throttle
A SUZUKI THUMB THROTTLE HOUSING.
housing. Stuff a clean, dry rag into m

Summary of the content on the page No. 2

1. Carefully trim the rubber alignment tab off of the face of the manifold with a razor blade or side cutters. NOTE: If flooding occurs, slowly open 2. Remove the hex pipe plug from the carb cap throttle to wide open and hold. With using a 11mm or 7/16 wrench. Do not throttle still open engage starter until discard plug, as it will be needed later. engine fires. Install the metering adjustment tool included in the hardware kit. Do not over-tighten as For any questions regarding