Summary of the content on the page No. 1
Z6JE/US2F
For assistance:
Owner’s Manual
4
Table of Contents
Manual del usuario
18
www.sanyoctv.com
Tabla de contenido
HDT V LCD
TVHD de LCD Manuel d’instructions
32
1-800-877-5032
TVHD ACL Table des matières
We’ll be glad to Help
DP26640
Model No. / No. de Modelo / Nº de modèle
© 2011 Sanyo Manufacturing Corporation Part No. / No. de parte / Nº de piece: 1JC6P1P0404 - - 1JC6P1P0404 - -
Summary of the content on the page No. 2
THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A CAUTION RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. RISK OF ELECTRIC SHOCK DO NOT OPEN! CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SER- MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS VICE PERSONNEL. UNIT. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOC
Summary of the content on the page No. 3
PC RESOLUTION CHART FCC INFORMATION __________ This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment gen- erates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Summary of the content on the page No. 4
Please read before CONTENTS IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . 2 operating your HDTV! FCC INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 TRADEMARKS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 PC RESOLUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 PROTECTING THE LCD SCREEN DISPOSAL PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . .3 CAUTION: The screen can be damaged if it is not SPECIFICATIONS . . . . . . .
Summary of the content on the page No. 5
STAND ASSEMBLY ___________ GETTING STARTED NOTE: Skip these steps if you are wall mounting the TV. BATTERY INSTALLATION Place HDTV face down on a padded or cushioned Install two (2) “AA” batteries in the remote control. 1 flat surface to protect the screen and finish. (Not included) Carefully insert the stand base to the bottom of the To ensure safe operation, please observe 2 HDTV and secure the base by inserting two (2) the following precautions: screws as indicated in the diagram below. NOTE:
Summary of the content on the page No. 6
GETTING STARTED HDTV SIDE PANEL HDTV INPUT/OUTPUT REFERENCE HDMI 2 HDMI (INPUT1 or INPUT2) 1 1 An all digital AV interface that can accept uncompressed HDMI video signals for the very best picture possible. 1 NOTE: A DVI conection is possible via the HDMI (DVI) INPUT1 using an appropriate adapter and connecting the audio to the Stereo Mini AUDIO jack. 2 2 USB Input View pictures stored in a USB flash drive. 3 3 PC Input Monitor RGB (D-SUB) 4 4 AUDIO mini stereo jack (3.5mm) 5 For AUDIO signal fr
Summary of the content on the page No. 7
GETTING STARTED AUDIO / VIDEO CONNECTIONS HDMI (DVI) INPUT1 can be used to hookup a DVI Use HDMI INPUT1 & 2 to hookup HD digital device with the use of an appropriate DVI to devices such as a Blu-ray player, HD Cable Box, HDMI cable or adapter. Stereo Mini AUDIO jack HD Satellite Receiver or Video-game System. needs to be hooked up to the DVI device as well Connect your digital device’s HDMI output to any NOTE: HDMI INPUT1 may also be used to hookup of the two (2) HDMI inputs on your HDTV with t
Summary of the content on the page No. 8
REMOTE CONTROL OPERATION Turns your HDTV On or Off. Selects the video source to view. Holding down the key displays the Input List. Selects the desired Audio mode. Displays the Channel Information banner. Stereo, Mono, or SAP (when available.) Pressing it twice restores your HDTV to its Displays the “Off” Timer. While Off Timer factory settings. All user customized set- is on-screen, press the “0” key to Set the tings will be cleared. amount of time (in 30 minute increments) at which the HDTV wi
Summary of the content on the page No. 9
ON-SCREEN MENU OPERATION GETTING STARTED (CONTINUED) INITIAL CHANNEL SEARCH CHANNEL SETTING Display the On Screen menu and use the CURSOR Before proceeding, please make sure to correctly keys to select Channel Setting. Press ENTER. hook up your antenna or cable connection and all AV equipment to your HDTV. Channel Search Auto – Searches the detected mode, Cable or Air. 1. PLUG IN AC POWER CORD 120V AC, 60Hz Cable – Searches for analog and unscrambled (ClearQAM) digital cable channels. 2. TURN
Summary of the content on the page No. 10
ON-SCREEN MENU OPERATION CHANNEL SETTING (CONTINUED) Digital Caption Captioning is textual information transmitted along with Input Setting the picture and sound. Turning Captioning ON (by Input Setting feature allows the removal of unused pressing the CAPTION key during normal TV viewing) inputs from the AV input loop. causes the HDTV to open these captions (digital or analog) and superimpose them on the screen. Use the CURSOR keys to select an AV input. Press ENTER to disable (uncheck) or
Summary of the content on the page No. 11
NOTE: Blocking a rating will automatically block all Light Sensor higher ratings. Unblocking a rating will auto- This feature detects ambient room light brightness and matically unblock all lower ratings. uses that reading to control the panel brightness level and picture parameters to reduce the HDTV’s power For V-Chip (Movie) ratings select Movie and press consumption. ENTER, and then select the desired MPAA rating limit. Press the EXIT key to close the V-Chip menu. NOTE: When room lighting is
Summary of the content on the page No. 12
ON-SCREEN MENU OPERATION UNDERSTANDING PIX-SHAPE NOTE: Images on left are for a 4:3 transmission while PICTURE images on right are for a 16:9 transmission. Display the On Screen menu and use the CURSOR Pix1Shows a standard definition 4:3 image in its keys to select Picture. Press ENTER. original format, a 16:9 wide image is slightly You may choose between Vivid, Mild, and Standard, compressed horizontally. which have predetermined fixed picture parameter values, or choose the Manual option
Summary of the content on the page No. 13
ON-SCREEN MENU OPERATION USB INPUT SOUND PHOTO VIEWER View pictures on your HDTV with the use of a USB mass Display the On Screen menu and use the CURSOR storage device (not included.) keys to select Sound. Press ENTER. Choose an option for your sound settings: USB FLASH Auto – Sound settings are linked to the current Picture 1 DRIVE option and parameters are adjusted accordingly. Dynamic, Mild, Standard – Predetermined sound parameters not linked with any Picture option. NOTE:The HDTV switch
Summary of the content on the page No. 14
PC INPUT Use your HDTV as a computer monitor by hooking up PC Setting your PC or Laptop to the TV with the use of an appropri- Auto Adjustment – Automatically adjusts display posi- ate monitor cable (not included.) tion, dot clock and phase. Before connecting any cables, disconnect the AC Dot Clock – Adjust the Dot frequency to match your power cords of both the HDTV and PC from the computer’s Dot frequency. AC outlets. Phase – Adjust this parameter when the picture appears Power on the HDTV and
Summary of the content on the page No. 15
ONE-YEAR LIMITED PARTS AND LABOR WARRANTY THIS LIMITED PARTS AND LABOR WARRANTY IS VALID ONLY ON SANYO TELEVISIONS PURCHASED AND USED IN THE UNITED STATES OF AMERICA, CANADA, AND PUERTO RICO, EXCLUDING ALL OTHER U.S. TERRITORIES AND PROTECTORATES. THIS LIMITED WARRANTY APPLIES ONLY TO THE ORIGINAL RETAIL PURCHASER, AND DOES NOT APPLY TO PRODUCTS USED FOR INDUSTRIAL OR COMMERCIAL PURPOSES. WARRANTY APPLICATION FOR ONE YEAR from the date of original retail purchase Sanyo Manufacturing Corporation
Summary of the content on the page No. 16
F For assistanc or assistance: e: Visit our Web site: w ww ww w..san sany yo oc ct tv v..c co om m or call toll free: 1 1--8 80 00- 0-8 877 77--5 50 03 32 2 W We e’ll be glad t ’ll be glad to Help o Help Sanyo Manufacturing Corp. 3333 Sanyo Road, Forrest City, AR 72335 Printed in Mexico SMC, August 2011 Impreso en México SMC, agosto 2011 Imprimé aux. Mexique SMC, août 2011 1JC6P1P0404 - - US2F / 26-Z6JE / GXFA
