Summary of the content on the page No. 1
Install Programs
SyncMaster 460Pn/460P
Summary of the content on the page No. 2
Notational Failure to follow directions noted by this symbol could result in bodily harm or damage to equipment. Prohibited Important to read and understand at all times Do not disassemble Disconnect the plug from the outlet Do not touch Grounding to prevent an electric shock Power When not used for an extended period of time, set your computer to DPMS. If using a screen saver, set it to the active screen mode. Do not use a damaged or lo
Summary of the content on the page No. 3
This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. An improper ground may cause electric shock or equipment damage. Insert the power plug firmly so that it does not come loose. A bad connection may cause fire. Do not excessively bend the plug and wire nor place heavy objects upon them, which could
Summary of the content on the page No. 4
This may cause damage to the product or human body. Install the monitor base in a showcase or shelf so that the end of the base does not protrude from the showcase or shelf. Dropping the product may cause damage to the product or personal injury. Do not place the product on an unstable or small surface area. Place the product on an even, stable surface, as the product may fall and cause harm to someone walking by, specifically children. Do not place the product on the fl
Summary of the content on the page No. 5
Installing a wall bracket must be done by a qualified professional. Installation by unqualified personnel may result in injury. Always use the mounting device specified in the owner's manual. When installing the product, make sure to keep it away from the wall (more than 10cm/4inch ) for ventilation purposes. Poor ventilation may cause an increase in the internal temperature of the product, resulting in a shortened component life and degraded performance. Clean
Summary of the content on the page No. 6
Contact the Service Center or Customer Center for interior cleaning once a year. Keep the product's interior clean. Dust which has accumulated in the interior over an extended period of time may cause malfunction or fire. Others Do not remove cover (or back). This may cause an electric shock or fire. Refer servicing to qualified service personnel. If your monitor does not operate normally - in particular, if there are any unusual sounds or smells coming from i
Summary of the content on the page No. 7
Do not cover the vents on the monitor cabinet. Bad ventilation may cause a breakdown or fire. Do not place water containers, chemical products or small metal objects on the monitor. This may cause malfunction, an electric shock or fire. If a foreign substance enters the monitor, unplug the power cord and contact the Service Center. Keep the product away from combustible chemical sprays or inflammable substances. This may cause an explosion or fire. Never insert an
Summary of the content on the page No. 8
Do not install the product on an unstable, uneven surface or a location prone to vibrations. Dropping the product may cause damage to the product or personal injury. Using the product in a location prone to vibrations may shorten the lifetime of the product or may catch fire. When moving the monitor, turn off and unplug the power cord. Make sure that all cables, including the antenna cable and cables connecting to other devices, are disconnected before moving the monitor. Failure t
Summary of the content on the page No. 9
public recycling center or to a store selling the same type of the battery or rechargeable battery.
Summary of the content on the page No. 10
SyncMaster 460Pn Please make sure the following items are included with your monitor. If any items are missing, contact your dealer. Contact a local dealer to buy optional items. This stand is not for the Floor Standing Type. Unpacking Monitor Manual User's Guide, MDC software, Warranty Card Quick Setup Guide Natural Color software, (Not available in all locations) MagicNet software Cable
Summary of the content on the page No. 11
D-Sub Cable Power Cord Speaker Wire Cable Sold separately Wall Mount KIT Speaker Set Stand KIT DVI Cable LAN Cable Others Remote Control Batteries (AAA X 2) Cover-Hole BNC to RCA Semi Stand Adapter Jack
Summary of the content on the page No. 12
Front 1.MENU 6.PIP 2. Navigate button (Up-Down button) 7. Power button 3. Adjust button (Left-Right button)/ 8. Power indicator Volume button 4. ENTER 9. Remote Control Sensor 5. SOURCE 1. MENU Use this button to open the on-screen menu and exit from the menu screen or close screen adjustment menu. 2. Navigate buttons (Up-Down button) Moves from one menu item to another vertically or adjusts selected menu values. 3. Adjust buttons (Left-Right button) / Volume buttons Move
Summary of the content on the page No. 13
for long periods. Rear For detailed information concerning cable connections, refer to Connecting Cables under Setup. The monitor's rear configuration may vary slightly depending on the monitor model. 1. POWER SW : Switch the monitor on and off. 2. POWER IN : Power cord, plug into monitor and wall receptacle. MDC(Multiple Display Control) Program Port 3. RS232C OUT/IN (RS232C Serial PORT): 4. DVI IN(HDCP) (PC Video Connection Terminal) Using DVI Cable (DVI-D to DVI-D) - DV
Summary of the content on the page No. 14
7. COMPONENT AUDIO IN [L-AUDIO-R](Component Audio Connection Terminal (Input)) 8. BNC/COMPONENT OUT (BNC/Component Connection Terminal (Output)) - BNC (Analog PC) Connection : connecting R, G, B, H, V port - Component Connection : connecting PR, Y, PBport 9. BNC/COMPONENT IN (BNC/Component Connection Terminal (Input)) 10. AV AUDIO IN [L-AUDIO-R](Monitor Audio Connection Terminal (Input)) 11. AV OUT [VIDEO](VIDEO Connection Terminal) : AV mode (Output) 12. AV IN [VIDEO](VIDEO Connection
Summary of the content on the page No. 15
17. LAN (LAN Connection Terminal) (MS Internet Explorer) 18. USB (USB Connection Terminal) (Keyboard / Mouse, Mass Storage Device Compatible.) 19. DIGITAL AUDIO OUT (Digital Audio Connection Terminal) 20. Kensington Lock The Kensington lock is a device used to physically fix the system when using it in a public place. (The locking device has to be purchased separately. ) For using a locking device, contact where you purchase it. See Connecting the Monitor for further information r
Summary of the content on the page No. 16
1. ON / OFF 2. MAGICNET 3. MDC 4. LOCK 5. MagicNet buttons 6. +100 7. VOL 8. MUTE 9. AUTO 10. MENU 11. ENTER 12. PRE-CH 13. CH/PAGE 14. SOURCE 15. INFO 16. EXIT 17. Up-Down Left-Right buttons 18. P.MODE (M/B) 19. STILL 20. BBE 21. MTS 22. PIP 23. SOURCE 24. SIZE 25. SWAP 26. 27. 28. 29. MagicNet Remote Control 1. ON / OFF Use these buttons to turn the monitor on or off. 2. MAGICNET MagicNet Quick Launch Button. 3. MDC MDC Quick Launch Button. 4. L
Summary of the content on the page No. 17
- This fuction does not work for this monitor. 7. VOL Adjusts the audio volume. >>Click here to see an animation clip 8. MUTE Pauses (mutes) the audio output temporarily. Displayed on the lower left corner of the screen. The audio resumes if MUTE or - VOL + is pressed in the Mute mode. 9. AUTO Adjusts the screen display automatically. If you change resolution in the control panel, auto function will be executed. 10. MENU Use this button to open the on-screen menu and e
Summary of the content on the page No. 18
21. MTS You can select the MTS (Multichannel Television Stereo) mode. Audio Type MTS/S_Mode Default Mono Mono Manual Change Stereo FM Stereo Mono Stereo SAP Mono Mono SAP - This fuction does not work for this monitor. 22. PIP Every time you push the button, a PIP screen appears. 23. SOURCE The PIP window's signal source changes. 24. SIZE You can switch the Picture Size. 25. SWAP Swapping the contents of the PIP and main image. The image in the PIP window will appear o
Summary of the content on the page No. 19
Remote Control PHOTO When the files are selected in the library list Previous file Stop slideshow / View the bottom menu bar Slideshow Next file When you see no menu in a zoomed-in picture Move up to the top of the image Move down to the bottom of the image Move to the left of the image Move to the right of the image MUSIC When the files are selected in the library list File view on the curso
Summary of the content on the page No. 20
Move to the previous page (when the cursor is placed at the bottom, it will move to the first file of the next page) Move to the next page (when the current page is the first, it will move to the last page) Move to the previous page (when the current page is the last, it will move to the first page) File view on the cursor position Play MOVIE When the files are selected in the library list Move to the top (when the cursor is placed at the top, it will go back to
