PYLE Audio PSW112 user manual

Summary of the content on the page No. 1

2,3
1
Brick, Brick, C Concr oncrete ete a and nd Stone Stone w wall(F all(Fiig g 2c): 2c):
Using the wall mount as template to mark 6 holes location on the wall. There holes are
located at the top row of the slots and three more are located at the bottom row. The
outer holes must be fall to the left and right of the two holes in the middle of the
mount. Please make sure these holes are level and at least 6” between any two lines.
Pre-drill these holes with a 10mm drill bit to at least 80mm deep

Summary of the content on the page No. 2

Har Hard dwar ware e List: List: Step Step 2: 2: Attach Attach mount mount t to o wall wall 3 First, determine the height of stand 2 1 The best height of stand is parallel to eyelevel of a person who sitting on a couch. Normally, the horizontal distance of eyelevel is about 4’ from ground level. The following two conditions are for determining the perfect height of stand: 1) the distance between wall and couch(Fig 2a). 2) the distance of eyelevel from ground level plus the distance measured from

Summary of the content on the page No. 3

3. For display with protruding HDTV tune or deeply curved backs(Fig b), two 9/16” spacers(R) or two WARNING ½” spacers(S) should be used. Stack two spacers and then install them between display and the bracket. As shown in Fig 1c. Fig b We are not responsible for any personal injury or product damage due to mishandling, incorrect mounting, incorrect assembly or incorrect use of this product. M4 Fig bit M5 Fig bit Note: The supplied wall mounting hardware is not for use on steel stud walls or col

Summary of the content on the page No. 4

Following examples shows how to use bolts, spacers and square washers. 2. Some displays have curved backs with recessed mounting lands(Fig.a). It will 1.Some displays have vertical backs. No spacer is required. Install the bracket directly require the use of spacer. For this display, to the back of display by using bolts and square washers provided. As shown in Fig.1a. install a 9/16” spacer(R) or ½”spacer(S) Fig a between display and the bracket. As shown in Fig 1b. M4 Fig bit M5 Fig bit M4 Fig