Summary of the content on the page No. 1
Register your product and get support at
www.philips.com/welcome
46PFL3705D
40PFL3705D
40PFL3505D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right sid
Summary of the content on the page No. 2
Contents 9 Connect devices 27 1 Notice 4 Connection overview 27 Selecting your connection quality 28 2 Important 5 Connecting your devices 29 Product information 5 Screen care 5 10 Troubleshooting 31 Environmental care 5 Downloading an electronic copy 31 Regulatory notices 5 Contact us 31 3 Your TV 6 11 Notes for the Use of USB Devices 32 Side controls and indicators 6 Remote control 6 12 Product Information 33 4 Get started 8 Supplied accessories 8 13 Warranty 34 Standing
Summary of the content on the page No. 3
Return your Product Registration Card or register online at www.philips.com/welcome today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: *Proof of Purchase *Product Safety *Additional Benefits Notification Returning the enclosed card guarantees By registering your
Summary of the content on the page No. 4
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6.
Summary of the content on the page No. 5
Modifi cations 1 Notice The FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by Philips Consumer Electronics may void the user’s authority to operate the equipment. 2010 © Koninklijke Philips Electronics N.V. All rights reserved. Specifi cations are subject to change without notice. Trademarks are Cables the property of Koninklijke Philips Electronics N.V. or their respective Connections to this device must be made wit
Summary of the content on the page No. 6
Environmental care 2 Important Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/welcome to ensure: • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to The packaging of this product is intended to be recycled. Contact your ob
Summary of the content on the page No. 7
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/welcome b Side contr ols and indicators s c * r d q p e f f e g d o h c b a n i a Standby indicator / remote control sensor b Ambient light sensor j [ ] When in Home mode, this TV will automatically adjust the brightness based on the ambient light. If there is a sudden change in TV brightness, it may be due to ch
Summary of the content on the page No. 8
c FORMAT Selects a picture format (see ‘Changing picture format’ on page 16). d SAP Digital Mode (DTV) • Press to select the audio language. Analog Mode (TV) • Press to select the audio mode. e FREEZE Press to pause screen image. f OK Activates a selection or accesses the menu. g Î ï Í Æ (Navigation buttons) Navigates through the menus. h INFO Displays information about the TV channel or accessory device. The quality and accuracy of the information depends on the broadcaster. You might see a
Summary of the content on the page No. 9
Position the TV 4 Get started Warning Supplied accessories • Do not insert the AC power cord into the power socket outlet before all the connections are made. • Remote control • Large screen TVs are heavy. 2 people are required to carry and handle a large screen TV. • Bef ore you move the TV, disconnect the cables to prevent breakage. • 2 x AAA, 1.5V batteries • M5 x 20 double sems screw x 4 • AC Power cord In addition to reading and understanding the safety instructions, • Cable manag
Summary of the content on the page No. 10
If you connect a set-top box through RF IN / OUT Connecting the antenna or cable If the TV is connected to a cable box or satellite set-top box via a coaxial connection, set the TV to channel 3 or 4, or to the channel specifi ed by the service provider. Cable If you connect to an antenna Any DTV programs that are broadcast in your area can be received for If you connect a set-top box through HDMI free through an antenna connection. If the TV is connected to a cable box or satellite set-top box
Summary of the content on the page No. 11
Managing cables Plugging in the AC power cord Route your antenna cable and all other cables through the cable holder Warning at the back of the TV. The holder helps keep your cables tidy and easily manageable. • Verify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable holder as illustrated below. 1 Locate the power connector at the back of the TV. The location of the power con
Summary of the content on the page No. 12
Press Í or Æ 5 times to select the side of the pictures that is the most Switching on and set up the TV pleasing to you. then press OK. Before you switch on the TV, check that the AC power cord is properly . . connected. Press POWER at the right side of the TV, or press on Left side Right side the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Initial Setup Initial Setup English Select your menu languag
Summary of the content on the page No. 13
Switching channels 5 Use your TV This section helps you perform basic TV operations. Switching your TV on / off or to standby Press CHANNEL + / − on the side of the TV. For digital channels, press a number (1 to 135) followed by a dot “ ” and then the corresponding • sub channel number (1 to 135). e.g. 108.30. • Press CH + / − or enter a number on the remote control. • Press PREV CH to return to the previously viewed channel. To switch on • Press . POWER at the side of the TV or press . (St
Summary of the content on the page No. 14
Adjusting v olume Still mode You can pause the image shown on the TV screen. Press FREEZE to pause the image shown on the TV screen. FREEZE • The sound output will not be paused. • If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted. • The still function will be released after 5 minutes. To cancel still mode, press any button except . (Standby-On). Watching channels from a set-top box To watch channels from a
Summary of the content on the page No. 15
TV W atching a Blu-ray Disc Press SAP to display the currently selected audio mode. While To watch a Blu-ray Disc receiving an MTS broadcast, press repeatedly to cycle through the 1 Insert a Blu-ray Disc into your player. available audio channel. 2 Press ► (play) on the remote control of the Blu-ray Disc player. 11 » The Blu-ray Disc might automatically play on the TV. SAP / STEREO If the picture does not appear When all audio are available SAP / STEREO SAP / MONO SAP / STEREO When stere
Summary of the content on the page No. 16
Summary of picture settings 6 Use more of your TV The following picture settings can be confi gured. Depending on the format of the picture source, some picture settings are not available. [ ] • Auto Picture : Sets all picture settings to the factory default. Changing pictur e and sound settings [ ] • Brightness : Adjusts the intensity and details of dark areas. [ ] When in Home mode, this TV will automatically adjust the Y ou must set [Home] in [Location] (refer to page 21). brightness bas
Summary of the content on the page No. 17
For 4:3 video signal Changing pictur e format 1 Press FORMAT on the remote control. [][ ] Normal 16:9 Î ï 2 Press or to select a picture format and press OK to confi rm your choice. [ ] Movie Expand Summary of picture formats 5 types of display modes can be selected when the broadcasting station is sending 16:9 or 4:3 video signal. And 3 types of display modes can be selected for PC input signal. For 16:9 video signal [ ] [ ] Wide Zoom Normal Display a 4:3 picture at its original size. Sid
Summary of the content on the page No. 18
[ ] TV Speakers Using y our TV as a PC monitor This option will allow you to select the audio output from the Use an HDMI-DVI cable or an HDMI-DVI adaptor to connect a PC to unit’s speakers. If you have an amplifi er which is compatible with your TV. For sound, add an audio cable with a stereo mini jack. the HDMI CEC function connected to this unit using an HDMI cable, some sound operations such as volume up can be used with Caution this unit’s remote control. Î ï • Before you connect yo
Summary of the content on the page No. 19
Sleeptimer Sleeptimer switches the TV to standby after a pre-defi ned period of time. Picture You can always switch off your TV earlier or reset the sleeptimer during Video 1 Sound the countdown. Video 2 Setup Component Press SLEEP to set the sleep timer. Features HDMI 1 Sleep Off Language HDMI 2 USB Sleep timer display appears on the TV screen. HDMI 3 Press SLEEP repeatedly to change the amount of time until shut off. BACK OK Back Select View / Block Sleep 120min. 3 Press Î or ï and then pres
Summary of the content on the page No. 20
Summary of TV ratings Summary of US movie ratings Rating Description Age rating Content rating TV-Y : Appropriate for children of all ages None NR Not rated. with themes and elements suitable for G Movies with a mild content, suitable for all ages. children aged 2-6. PG Mo vies for which parental guidance is recommended. TV-Y7 : Programs designed for children age 7 [FV (Fantasy Violence)] They may contain a few racy or violent scenes or and older. maybe some bad language. TV
