Summary of the content on the page No. 1
Register your product and get support at
www.philips.com/support
32PFL3506
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User Manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right side of the TV cabinet
Summary of the content on the page No. 2
Contents 9 Connect devices 27 1 Notice 4 Connection overview 27 Selecting your connection quality 28 2 Important 5 Connecting your devices 29 Product information 5 Screen care 5 Environmental care 5 10 Troubleshooting 31 Regulatory notices 5 Downloading an electronic copy 31 Contact us 31 3 Your TV 6 Side controls and indicators 6 11 Notes for the use of USB devices 32 Remote control 6 12 Specifi cations 32 4 Get started 8 Supplied accessories 8 13 Warranty 33 Mounting stand onto TV 8 Positionin
Summary of the content on the page No. 3
Return your Product Registration Card or register online at www.philips.com/support today to get the very most from your purchase. Registering your model with Philips makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/support to ensure: *Product Safety Notification *Additional Benefits By registering your product, you'll receive notification Registering your prod
Summary of the content on the page No. 4
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6. Clean
Summary of the content on the page No. 5
Modifi cations 1 Notice The FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by Philips Consumer Electronics may void the user’s authority to operate the equipment. Specifi cations are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective Cables owners. P&F USA reserves the right to change products at any time Connections to this device must be made with
Summary of the content on the page No. 6
Environmental care 2 Impor tant Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/support to ensure : • Product Safety Notifi cation The packaging of this product is intended to be recycled. Contact your By registering your product you receive notifi cation - directly from local authorities for information about how to recycl
Summary of the content on the page No. 7
Remote control 3 Y our TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at www.philips.com/support a Side contr ols and indicators b s c * r d e q p e d f c g b o h a a Standby indicator / remote control sensor b . POWER n i Switches the TV on or puts it in standby mode. The TV is not powered off completely unless it is physically unplugged. c CHANNEL + / − j Switches to the next or previous chann
Summary of the content on the page No. 8
a . (Standby-On) Switches the TV on or puts it in standby mode. The TV is not powered off completely unless it is physically unplugged. b SOURCE Selects connected devices. c FORMAT Selects a picture format (see ‘Changing picture format’ on page 16). d SAP Digital Mode (DTV) • Press to select the audio language. Analog Mode (TV) • Press to select the audio mode. e FREEZE Press to pause screen image. f OK Activates a selection or accesses the menu. g Î ï Í Æ (Navigation buttons) Navigates through
Summary of the content on the page No. 9
Positioning the TV 4 Get started Warning • Do not insert the AC power cord into the power socket outlet before all the connections are made. Supplied accessories • Large screen TVs are heavy. 2 people are required to carry and handle a large screen TV. • Before you move the TV, disconnect attached cables to prevent damage to connectors. • Remote Control In addition to reading and understanding safety instructions, consider • 2 x AAA, 1.5V Batteries the following before positioning your TV
Summary of the content on the page No. 10
If you connect a set-top box through RF IN / OUT Connecting the antenna or cable If the TV is connected to a cable box or satellite set-top box via a coaxial connection, set the TV to channel 3 or 4, or to the channel specifi ed by the service provider. cable cable antenna t antenna t RF cable RF cable set-top bo set-top box x IN IN RF cable RF cable IN IN IN OUT If you connect to an antenna Any DTV programs that are broadcast in your area can be received for If you connect a set-top bo
Summary of the content on the page No. 11
Managing cables Plugging in the AC power cord Route your antenna cable and all other cables through the cable W arning management tie at the back of the TV. The holder helps keep your cables tidy and easily manageable. • Verify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable management tie as illustrated below. Connect the AC power cord plug to the power outlet. Ensure that the
Summary of the content on the page No. 12
Í Æ Press or 5 times to select the side of the pictures that is the most Switching on and initial setup pleasing to you. then press OK. Before you switch on the TV, check that the AC power cord is properly Left side Right side connected. Press . POWER at the right side of the TV, or press . on the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Initial Setup Initial Setup English Select your menu language
Summary of the content on the page No. 13
Switching channels 5 Use your TV This section helps you perform basic TV operations. Switching on your TV and putting it in standby mode Press CHANNEL + / − on the side of the TV. For digital channels, press a number (1 to 135) followed by a dot “ ” and then the corresponding • sub channel number (1 to 135). e.g. 108.30. • Press CH + / − or enter a number on the remote control. To switch on • Press PREV CH to return to the previously viewed channel. . . • Press POWER at the side of the
Summary of the content on the page No. 14
Still mode Adjusting v olume You can pause the image shown on the TV screen. Press FREEZE to pause the image shown on the TV screen. Freeze • The sound output will not be paused. • If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted. • The still function will be released after 5 minutes. To cancel still mode, press any button except .(standby-On). Watching channels from a set-top box To watch channels fro
Summary of the content on the page No. 15
Watching a Blu-ray disc Switching audio mode This section describes how to switch audio language in digital mode and To watch a Blu-ray Disc how to switch audio in analog mode. 1 Insert a Blu-ray Disc into your player. DTV 2 Press ► (play) on the remote control of the Blu-ray Disc player. 1 Press SAP to display the currently selected language and the » The Blu-ray Disc might automatically play on the TV. number of available languages. If the picture does not appear 11.1 11.1 English 1/3 English
Summary of the content on the page No. 16
Summary of picture settings 6 Use more of your TV The following picture settings can be confi gured. Depending on the format of the picture source, some picture settings are not available. • [Auto Picture]: Sets all picture settings to the factory default. Changing picture and sound settings • [Brightness]: Adjusts the intensity and details of dark areas. • [Contrast]: Adjusts the intensity of bright areas, keeping dark areas You must set [Home] in [Location] (refer to page 21). unchanged. O
Summary of the content on the page No. 17
For 4:3 video signal Changing pictur e format Press FORMAT on the remote control. 1 [ ] Normal [16:9] 2 Press Î or ï to select a picture format and press OK to confi rm your choice. Summary of picture formats [Movie Expand] Display modes can be selected when the broadcasting station is sending 16:9 or 4:3 video signal. And 3 types of display modes can be selected for PC input signal. For 16:9 video signal [ ] Wide [Zoom] Normal Display a 4:3 picture at its original size. Sidebars appear on both
Summary of the content on the page No. 18
[ ] TV Speakers Using your TV as a PC monitor This option will allow you to select the audio output from the Use an HDMI-DVI cable or an HDMI-DVI adaptor to connect a PC to unit’s speakers. If you connect this TV to an external amplifi er your TV. For sound, add an audio cable with a stereo mini jack. which is compatible with HDMI CEC, you can use volume controls on this TV to control volume on the external amplifi er. Caution Press Î or ï to select the desired option, then press OK. • Before y
Summary of the content on the page No. 19
Sleeptimer You can always put your TV in standby mode earlier or reset the Picture Video sleeptimer during the countdown. Sound Component Setup Press SLEEP to set the sleep timer. HDMI 1 Features Sleep Off HDMI 2 Language HDMI 3 Sleep timer display appears on the TV screen. USB 40.1 DTV Press SLEEP repeatedly to change the amount of time (in increments of 30 minutes up to 120 minutes). BACK OK Select View/Block Back Sleep 120min • Each press of SLEEP will increase the time by 30 minutes. 3
Summary of the content on the page No. 20
Summary of TV ratings Summary of US movie ratings Age rating Content rating Rating Description TV -Y : Appropriate for children of all ages with None NR Not rated. themes and elements suitable for children G Mo vies with a mild content, suitable for all ages. aged 2-6. PG Mo vies for which parental guidance is recommended. TV-Y7 : Progr ams designed for children age 7 and [ FV] They may contain a few racy or violent scenes or older. (Fantasy Violence) maybe some bad language. TV
