NEC PX-50XR4A user manual

Summary of the content on the page No. 1

PX-50XR4A
Model Information
For the operation of your plasma monitor,
refer to “Operation Manual”.
NEC Solutions (America), Inc.

Summary of the content on the page No. 2

IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. 17. Tilt/Stability - All televisions must comply with 2. Keep these instructions. recommended international global safety standards for 3. Heed all warnings. tilt and stability properties of its cabinets design. 4. Follow all instructions. • Do not compromise these design standards by 5. Do not use this apparatus near water. applying excessive pull force to the front, or top, of 6. Clean only with a dry clo

Summary of the content on the page No. 3

PRÉCAUTIONS IMPORTANTES DE SÉCURITÉ A lire avant de faire fonctionner l’appareil 1. Lire ces instructions. 17. Tous les téléviseurs doivent être conformes aux normes 2. Garder ces instructions. inter-nationales de sécurité préconisées pour les 3. Respecter tous les avertissements. propriétés de sta-bilité et d’inclinaison dans la conception 4. Suivre toutes les instructions. des meubles. 5. Ne pas utiliser cet appareil près de l’eau. • Ne pas compromettre ces normes de conception en 6. Nettoyer

Summary of the content on the page No. 4

Important Information Warning NOTE: Not for use in a computer room as defined in the Standard When you connect a computer to this monitor, use an RGB for the Protection of Electronic Computer/ Data Processing cable including the ferrite core on both ends of the cable. Equipment ANSI/NFPA 75. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not This equipment has been tested and found to comply with conform to mandatory FCC standards.

Summary of the content on the page No. 5

Recommandations importantes Avertissement Attention Ne pas utiliser dans une salle d’ordinateurs telle que définie Cet modèle est fait pour être utilisé avec les accessoires dans la Norme pour la protection des ordinateurs optionnels suivants. Toute utilisation avec d’autres électroniques/appareils de traitement des données ANSI/ accessoires optionnels peut entraîner une instabilité pouvant NFPA75. causer des blessures. Nom du fabricant: NEC Plasma Display Corporation DOC avis de conformation En

Summary of the content on the page No. 6

Specifications Screen Size 43.5"(H)
24.5"(V) inches 1106(H)
622(V) mm 1.5" 2.3" (38) diagonal 50" 48.1" (1222) (58) Aspect Ratio 16 : 9 Resolution 1365(H)
768(V) pixels 43.5" (1106) Pixel Pitch 0.032"(H)
0.032"(V) inches 0.81(H)
0.81(V) mm Color Processing 4,096 steps, 68.7 billion colors Signals Synchronization Range Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120 Hz (automatic : step scan) 3.8" (96) Input Signals RGB, NTSC (3.58/4.43), PAL (B,G,M,N), 1 1 1 Bezel col

Summary of the content on the page No. 7

Table of Signals Supported Supported resolution 2, 3, 4 • When the screen mode is NORMAL, each signal is converted to a 1024 dots
768 lines signal. (Except for * ) • When the screen mode is TRUE, the picture is displayed in the original resolution. 3 • When the screen mode is FULL, each signal is converted to a 1365 dots
768 lines signal. (Except for * ) Computer input signals supported by this system Sync Polarity Presence Screen mode Vertical Horizontal RGB Dots
lines Model 5 DVI Memo

Summary of the content on the page No. 8

*1 Only when using a graphic accelerator board that is capable of displaying 852
480. *2 This signal is converted to a 1024 dots
640 lines signal. *3 The picture is displayed in the original resolution. *4 The aspect ratio is 5:4. This signal is converted to a 960 dots
768 lines signal. *5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the RGB mode prepared for the input signals listed in the table above. *6 To conne