Summary of the content on the page No. 1
VEC1098A_Manual_082606 8/26/06 12:56 PM Page 12
VEC1098A
FIVE YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Vector Products, Inc., regarding this product. There is no other warranty, other than those
described herein. Any implied warranty of merchantability or fitness for a particular purpose on this product
is limited in duration to the duration of this warranty.
Fully Automatic Electron
Summary of the content on the page No. 2
VEC1098A_Manual_082606 8/26/06 12:56 PM Page ii IMPORTANT SAFETY INSTRUCTIONS Figure Figure ADAPTER (B) WARNINGS 1A 1B 1. RISK OF EXPLOSIVE GAS MIXTURES — WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS IMPORTANT THAT YOU GROUNDING READ THIS MANUAL EACH TIME BEFORE USING YOUR CHARGER AND FOLLOW THE GROUNDING MEANS INSTRUCTIONS EXACTLY. PIN (A) 2. To reduce risk of battery explosion, follow thes
Summary of the content on the page No. 3
VEC1098A_Manual_082606 8/26/06 12:56 PM Page iv 5. For negative-grounded vehicle, connect POSITIVE (RED) clamp from battery charger to POSITIVE (POS, P, +) ungrounded post of battery. Connect NEGATIVE (BLACK) clamp to vehicle chassis or TABLE OF CONTENTS engine block away from battery. Do not connect clip to carburetor, fuel lines, or sheet-metal body parts. Connect to heavy gauge metal part of the frame or engine block. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 4
VEC1098A_Manual_082606 8/26/06 12:56 PM Page 2 Stage Two — Absorption Charge maintains the maximum possible charge at a Controls and Indicators constant, safe, predetermined voltage. During this phase, the charging voltage remains CONTROL PANEL DIGITAL READOUT constant, while the actual charging current is reduced to allow for the maximum proper CIRCULATING PATTERN internal chemical energy transfer. At the end of Stage 2, the charger will automatically move into Stage 3 charge mode. Stage Thr
Summary of the content on the page No. 5
VEC1098A_Manual_082606 8/26/06 12:56 PM Page 4 OPERATING INSTRUCTIONS AC POWER INDICATOR - When connected to an AC outlet, digital display shows circulating pattern to Ensure that all installation and operating instructions and safety indicate power is on. Disconnect charger after use. precautions are understood and carefully followed by anyone FAULT CODES installing or using the charger. Follow the steps outlined in “Important INTERNAL SHORTED CELL BATTERY - Cannot be charged. Have battery
Summary of the content on the page No. 6
VEC1098A_Manual_082606 8/26/06 12:56 PM Page 6 4. Remove battery from vehicle. MAKE SURE THAT THE BATTERY HAS GOOD the microprocessor, and the unit will stop charging if the selected rate is too fast VENTILATION. The process causes the release of hydrogen and oxygen. An or too slow for battery size or condition. accumulation of these gases presents a real danger of explosion. As the battery nears full charge, the unit’s output will automatically drop to a 5. Open the battery cap, if removabl
Summary of the content on the page No. 7
VEC1098A_Manual_082606 8/26/06 12:56 PM Page 8 before using RECONDITION Mode. Observe the Digital Display for any codes. This APPROXIMATE CHARGING TIMES initial charge will check the battery for shorted cells (F01), open cells (F03) or battery The 50/30/15/4 Amp Smart Battery Charger will automatically adjust the too low to accept a charge (F02), and to ensure the battery can take a charge. If charge rate as the battery becomes charged and stop when the battery is fully code (F03) is displaye
Summary of the content on the page No. 8
VEC1098A_Manual_082606 8/26/06 12:56 PM Page 10 TROUBLESHOOTING Display Indications/Common Problems/Possible Solutions No Functions • Check and make sure the charger is plugged into a live 110/120 volt AC outlet. • Follow the steps outlined in the Operating Instructions section. F01 — Internal Shorted Cell Battery If the battery being charged has an internal shorted cell, the F01 will show. We recommend taking your battery to a certified automotive service center for evaluation. F02 — Bad Ba
