Summary of the content on the page No. 1
Operating Instructions
TV
+
Individual46 Compose F ull-HD
+
Individual 40 Compose Full-HD
233–32961.020
3 2 9 6 1 0 2 0
Summary of the content on the page No. 2
Contents Remote Control – TV Functions ............................................................... 3 Electronic Programme Guide ................................................................. 28 Electronic Programme Guide – EPG ...............................................................28 Control unit front side of the device ....................................................... 4 Configuring EPG ........................................................................................
Summary of the content on the page No. 3
Remote Control – TV Functions Switch on/off (Page 18) .............................................................. Sound off/on – to standby mode ..................................................(page 11) (Page 50) ..................... LED display for current operating mode (1 Switch over to radio mode .....................(page 11; page 4) (Page 10; page 50) .............................Switch over to TV mode (Page 50) .................................Switc
Summary of the content on the page No. 4
Control unit front side of the device Button M: Call the menu in the menu: up/down Display: The mains switch is = Standby on the bottom of the TV = Operation = Operation without on-screen display On/Off button: (Radio, EPG data capture or timer recording) Switch on from the standby mode Switch off from the standby mode Button +: Button – : Station up Station down in the menu: to the right DR+ in the menu: to the left Display DR+: Button R: (1 DR+ = Digital Recorder
Summary of the content on the page No. 5
Connections rear side of the device Factory settings: Common Interface 1 (CI-Slot 1) AV1: DVDplayer AV2: DVD recorder Common Interface 2 (CI-Slot 2) You can change this during the initial installation (page 11) or in USB connection (USB stick/card reader) the connection wizard (page 5). Before you connect other devices or make any changes, please start Headphones connection the connection wizard (page 5) S-VHS connection (AVS) and the sound components wizard
Summary of the content on the page No. 6
Welcome Thank you! About this operating manual At Loewe, we combine the highest standards of technology, design and For many questions concerning the technology you will find an answer user friendliness. This applies equally for TV, video and accessories. in the index of your TV set. If your question concerns TV set operation, you can access a function directly from the index of the TV set. Owing to Your new TV set is equipped for
Summary of the content on the page No. 7
Welcome Programming and managing recordings Operating convenience with wizards The recording wizard can be called quickly via the timer overview and This TV set offers user prompting with wizards that take you through the helps you to program a video recording with a video recorder, DVD re- settings step-by-step. corder, or theintegr atedDigital Recor der(see page 46). Youcan return to thepr eviousstep orexit thewizar d at any time. St
Summary of the content on the page No. 8
For your safety For your own safety and to prevent unnecessary damage to your device, Power supply read and comply with the following safety instructions: The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and Proper use and environmental conditions frequency as that specified on the rating plate; use the mains cable This TV set is designed exclusively for reception and reprodu
Summary of the content on the page No. 9
For your safety Environmental protection Repairs and accessories Energy consumption Your TV set is equipped with an eco-standby power supply. In the standby Never remove the back of the TV set yourself. Only have your TV device mode, the power consumption drops to low power (see technical data on repairedor serviced by authorised television technicians. page 54). If you want to save even more energy then switch the device Only use or
Summary of the content on the page No. 10
AAA LR03 Initial installation Installing the TV set Connecting the TV set First prepare the chosen installation solution for your TV set. See the Connecting to the mains installation instructions of the wallmount supplied. See Accessories (page ➠ Note theposition of themains connectionin 55)for other installation possibilities. IndividualCompose 40 / 46. Removing the protective foil Remove the cover forthe connections. Connectthe TV set toa
Summary of the content on the page No. 11
Initial installation Turning the set on/off First installation wizard Switching the TV set to standby mode First installation after switching on for the first time This wizard starts automatically after the set is switched on for the first Activate the mains switch on the bottom left of the set. time, however it can also be called later manually in the TV index, see Repeat initial installation on page 14. The display in the control panel on the front
Summary of the content on the page No. 12
Initial installation Explanations of the setting possibilities: Startsear ch Startthe automatic station searchwith OK. First TV stations, then radio stations are searchedfor . Location Selectthe country for country-specific pre-settings. The stations found in the automatic search are divided of TV set into the appropriate station blocks depending on the previously selected antenna cables (signal sources). Sub- Antenna/cable (analogue): analoguestations
Summary of the content on the page No. 13
Initial installation Operating convenience Positioning/aligning DVB-T antenna General information on menu operation If you are receiving one or more DVB-T stations with picture and sound Use the MENU button to call menus for the various modes. Additional interference then you should change the installation location and align- menuscan be called dir ectlywith the r emotecontr ol. ment of the antenna. Ask your dealer to tell you which cha
Summary of the content on the page No. 14
Operating convenience The info display The index in the TV set The info display shows a content-based info text for each menu item at You can start all wizards and many operating functions directly from the top edge of the screen to help you in making the settings. In conjunc- this point. The complete function scope of the TV set can thus be easily tion with the index itcr eates aconvenient contr olsystem. understood. Alphabetic sortin
Summary of the content on the page No. 15
Operating convenience TV menu – Overview diagram TV menu Picture Sound Connections Settings (1 Picture adjustment Sound mode New devices/modifications Station (1 (2 (1 Search wizard Contrast DPLII mode Sound components Manual adjustment (1 Colour intensity Sound adjustment Antenna DVB Change stations Colour temperature Headphone volume Digital Link Plus Select/change favourites Brightness Loudness Miscellaneous Parental lock Manual adjustment of AV standard Sharpness more... Timer functions (
Summary of the content on the page No. 16
Daily operation With the station list Select station ➠ Innormal TVoper ation,without further displays,no With the keys P+ and P– on the remote control favouritesselected: P+/P–station up/down. OK call Station list. The station display with sound identification is displayed briefly. Station list Sorting COMP. IN 5 hr-fernsehen ➠ If favourites are selected, the station is switched over HDMI1/DVI numerically 6 Phoenix HDMI2/DVI 7 B
Summary of the content on the page No. 17
Daily operation With the favourites lists Explanation of the icons following station names: Digital DVB-T station (terrestrial via antenna) You can save and call your favourite stations in 6 favourites lists (e.g. for DigitalD VB-C station (via cable) multiple users). Each favourites list can contain up to 99 stations. After initial installation, 10 stations from the station list are already stored in DigitalD VB-S station (via satellite)
Summary of the content on the page No. 18
Daily operation Explanations of the sound settings: Adjusting the sound Soundmode Select the number of speakers you want to hear. The Switching sound off/on selection depends on the connected sound components (frompage 9) and on thetr ansmittedaudio signal. Sound off; ➠ If the number of speakers appears in brackets, the Soundon: Pressbutton again or set volume V+. sound of missing speakers is transmitted by the existing speakers (virtual
Summary of the content on the page No. 19
Picture Here you can adjust among other things: Contrast, colour, brightness, picture adjustment, sharpness, picture format. Daily operation TV menu Adjusting the picture INFO END Picture adjustment Picture (personal values, TV digital) Here, you can switch between the preset standard values for contrast, colour Picture adjustment intensity, colour temperature, brightness, focus and digital noise reduction OK Standard values (TV digital) Personal values (TV digital) Call TV menu. and your own
Summary of the content on the page No. 20
Daily operation The Panorama picture format can be switched between Button functions proportionallycorr ect and format fillingr eproduction. Each operating mode of the TV set (TV, Radio, Teletext, EPG, or Picture Dark margins are visible on the right and left of the picture in Picture) has a separate menu and separate functions for the coloured inpr oportionallycorr ectr eproduction. buttons. The assignment of the coloured buttons is
