Summary of the content on the page No. 1
Operating instructions
TV
+
Individual 40Selection F ull-HD
233–32959.022
3 2 9 5 9 0 2 2
Summary of the content on the page No. 2
Contents Electronic Programme Guide ................................................................. 30 Remote Control – TV Functions ............................................................... 3 Electronic Programme Guide – EPG ...............................................................30 Control unit front side of the device ....................................................... 4 Configuring EPG ........................................................................................
Summary of the content on the page No. 3
Remote Control – TV Functions Switch on/off (page 0) ............................................................. Sound off/on – to standby mode ..................................................(page 11) (page 5 ) .................... LED display for current operating mode (1 Switch over to radio mode ..............................(page 11; 6) (page 10; 5 ) ......................................Switch over to TV mode (page 5 ) ............................
Summary of the content on the page No. 4
Control unit front side of the device Button M: Call the menu Display: in the menu: up/down The mains switch is located on the bottom = Standby of the set in the middle = Operation = Operation without on-screen display On/Off button: (Radio, EPG data capture or timer recording) Switch on from the standby mode Switch off to the standby mode Button +: Station up in the menu: to the right Button – : DR+ Station down in the menu: to the left Display DR+: Button R: DR+ =
Summary of the content on the page No. 5
Connections rear side of the device Factory settings: Common Interface 1 (CI-Slot 1) AV1:D VDplayer AV2:D VD recorder Common Interface 2 (CI-Slot 2) You can change this during the initial installation (page 11) or in USB connection the connection wizard (page 7). (USB stick/card reader) Before you connect other devices Headphones or make any changes, please start connection the connection wizard (page 7) and the sound components wizard S-VHS connection (A
Summary of the content on the page No. 6
Welcome Thank you! About this operating manual At Loewe, we combine the highest standards of technology, design and For many questions concerning the technology you will find an answer user friendliness. This applies equally for TV, video and accessories. in the index of your TV set. If your question concerns TV set operation, you can access a function directly from the index of the TV set. Owing to Your new TV set is equipped for
Summary of the content on the page No. 7
Welcome Programming and managing recordings Operating convenience with wizards The recording wizard helps you to program a video recording with a video This TV set offers user prompting with wizards that take you through the recorder, DVD recorder, or the integrated Digital Recorder (see page 48). settings step-by-step. Youcan r eturnto the pr evious step orexit thewizar dat any time. Station list The station list is a list of all s
Summary of the content on the page No. 8
For your safety For your own safety and to prevent unnecessary damage to your device, Power supply read and comply with the following safety instructions: The wrong voltage can damage the set. This equipment must only be connected to a mains power supply which has the same voltage and Proper use and environmental conditions frequency as that specified on the rating plate; use the mains cable This TV set is designed exclusively for reception and reprodu
Summary of the content on the page No. 9
For your safety Environmental protection Repairs and accessories Energy consumption Your TV set is equipped with an eco-standby power supply. In the standby Never remove the back of the TV set yourself. Only have your TV device mode, the power consumption drops to low power (see technical data on repairedor serviced by authorised television technicians. page 57). If you want to save even more energy then switch the device Only use or
Summary of the content on the page No. 10
AAA LR03 Initial installation Installing the TV set Connecting the TV set Install as manually rotatable table unit with the Screen Table Stand Connecting to the mains included. Remove the cover forthe connections. SeeA ccessories (page 58) for other installationpossibilities. Connectthe TV set to a 0-40V outlet: First plug the small plug of the mains cable into the Removing the protective foil mains connection on the rear of the TV, then plug the
Summary of the content on the page No. 11
Initial installation Turning the set on/off First installation wizard Switching the TV set to standby mode First installation after switching on for the first time This wizard starts automatically after the set is switched on for the first Press the mains switch on the bottom of the set. time, however it can also be called later manually in the TV index, see Repeat initial installation on page 15. The display in the control panel on the front of the
Summary of the content on the page No. 12
Initial installation Explanations of the setting possibilities, including the retrofittable LNC Normally, you do not need to change the values for high frequencies and low band, unless the LNC (LNB) of your satellite satellite reception: Low Band / system uses a different oscillator frequency (important Location Select the countryfor country-specific pre-settings. HighBand forthe fr equencydisplay). ofTV set If UK or IRL is selected for the
Summary of the content on the page No. 13
Initial installation Digital Link If you have registered and connected a recorder in the Positioning/aligning DVB-T antenna Plus connection wizard, the Digital Link Plus transmission If you are receiving one or more DVB-T stations with picture and sound begins at the end of the sound components wizard. If interference then you should change the installation location and align- a Digital Link Plus capable recorder is connected, the ment o
Summary of the content on the page No. 14
Operating convenience General information on menu operation The info display Menus for the individual operating modes (TV, Radio, PIP, EPG, Teletext, The info display shows a content-based info text for each menu item at PhotoViewer and Digital Recorder) are called with the MENU button. Other the top edge of the screen to help you in making the settings. In conjunc- menuscan be opened with other buttons onthe remote control. tionwith the
Summary of the content on the page No. 15
Operating convenience The index in the TV set The Assist+ menu You can start all wizards and many operating functions directly from The most important additional functions of the TV set can be called this point. The complete function scope of the TV set can thus be easily directly with the Assist+ menu. understood. Open Assist+ Alphabetic sorting is preceded by the items Language, Integrated features and Repeat initial installation. Call Assist+men
Summary of the content on the page No. 16
Operating convenience TV menu – Overview diagram TV menu Picture Sound Connections Settings (1 Picture adjustment Sound mode New devices/modifications Stations (1 (5 (1 Search wizard Contrast Dolby PLII mode Sound components Manual adjustment (1 Colour intensity Sound adjustment Antenna DVB Change stations Colour temperature Headphone volume Digital Link Plus Select/change favourites Brightness Loudness Miscellaneous Parental lock Manual adjustment of AV standard Sharpness more... Timer func
Summary of the content on the page No. 17
Operating convenience Radio menu – Overview diagram Radio menu Stations Sound Timer functions (1 Sound mode Search wizard Switch off today only (5 Dolby PLII mode Manual adjustment Switch off daily Sound adjustment Change stations One-time reminder Headphone volume Select/change favourites Wake up Mon-Fri Loudness Wake up Sat more... Wake up Sun Auto volume Wake up with Maximum volume Wake up signal volume Switch on volume Volume adjustment for current station Balance Other menus – Overview di
Summary of the content on the page No. 18
Daily operation With the station list Select station ➠ In normal TV operation, without further displays, no With the keys P+ and P– on the remote control favourites selected: P+/P– stationup/down. OK call Station list. The station display with sound identification is displayed briefly. Station list Sorting ➠ If favourites are selected, the station is switched over COMP. IN 5 hr-fernsehen HDMI1/DVI numerically 6 Phoenix inthe favourites
Summary of the content on the page No. 19
Daily operation With the favourites lists Explanation of the icons following station names: DigitalD VB-Tstation (terr estrialvia antenna) You can save and call your favourite stations in 6 favourites lists (e.g. for Digital DVB-C station (via cable) multiple users). Each favourites list can contain up to 99 stations. After initial installation, 10 stations from the station list are already stored in DigitalD VB-S station (viasatel
Summary of the content on the page No. 20
Daily operation Explanations of the sound settings: Adjusting the sound Sound mode Select the number of speakers you want to hear. The Switching sound off/on selection depends on the connected sound components (from page 41) and on the transmittedaudio signal. Soundoff; ➠ If the number of speakers appears in brackets, the Soundon: Pr essbutton again or set volume V+. sound of missing speakers is transmitted by the existing speakers (virtual). Set
