Summary of the content on the page No. 1
PLASMA TV
OWNER’S MANUAL
32PC5DVC
Please read this manual carefully before operating
your set.
Retain it for future reference.
Record model number and serial number of the set.
See the label attached on the back cover and quote
this information to your dealer
when you require service.
ENERGY STAR is a set of power-saving
guidelines issued by the U.S.
Environmental Protection Agency(EPA).
As an ENERGY STAR
Partner LGE U. S. A.,Inc.
has determined that this
product meets the
ENERGY STAR guide
Summary of the content on the page No. 2
Summary of the content on the page No. 3
WARNING / CAUTION WARNING / CAUTION To prevent fire or shock hazards, do not expose this product to rain or moisture. FCC NOTICE TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO Class B digital device USER SERVICEABLE PARTS INSIDE. REFER TO This equipment has been tested and found to comply QUALIFIED SERVICE PERSONNEL. with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmf
Summary of the content on the page No. 4
Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual O Ow wner M ner Manual anual SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS Important safety instructions shall be provided with each apparatus. This information shall be given in a separate booklet or sheet, or be located before any operating instructions in an instruction for installation for use an
Summary of the content on the page No. 5
w e O n r Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Owner Manual Use only with the cart, stand, tripod, bracket, of the appliance, and have the cord replaced 10 or table specified by the manufacturer, or sold with an exact replacement part by an authorized with the apparatus. When a cart is used, use servicer. Protect the power cord from physical caution when moving the cart/apparatus or mechanical abu
Summary of the content on the page No. 6
CONTENTS WARNING / CAUTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 PICTURE CONTROL SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Picture Size (Aspect Ratio) Control . . . . . . . . . . . . . . . . . . 32 Preset Picture Settings INTRODUCTION - Picture Mode - Preset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Feature of this TV . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - Color Tone
Summary of the content on the page No. 7
TIME SETTING Clock Setting - Auto Clock Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53 - Manual Clock Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Auto On/Off Time Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55 Sleep Time Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56 Auto Shut-off Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 8
INTRODUCTION FEATURE OF THIS TV LG's own special digital image generator, consisting of a full digital image processor, six different main picture quality factors. TM HDMI , the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing." 6
Summary of the content on the page No. 9
PREPARATION POWER NPUT TV INPUT SOUND TIMER SAP PICTURE SOUND TIMER 12 3 12 3 45 6 45 6 78 9 78 9 - 0 FAV - 0 FAV ADJUST ADJUST VOL MUTE CH VOL MUTE CH CC CC BACK EXIT MENU BACK EXIT ENTER PREPARATION ACCESSORIES Ensure that the following accessories are included with your product. If an accessory is missing, please contact the dealer where you purchased the product. User must use shielded signal interface cables (D-sub 15 pin cable) with ferrite cores to maintain standard compliance for the pr
Summary of the content on the page No. 10
PREPARATION PREPARATION FRONT PANEL INFORMATION Here shown may be somewhat different from your TV. NOTE: If your product has a protection tape attached, remove the tape. And then wipe the product with a cloth (If a polishing cloth is included with your product, use it). Remote Control Sensor Power/Standby Indicator Illuminates red in standby mode. Illuminates green when the set is switched on. INPUT MENU ENTER VOL CH ENTER VOL INPUT MENU CH POWER INPUT MENU ENTER VOLUME CHANNEL Button Button
Summary of the content on the page No. 11
PREPARATION BACK PANEL INFORMATION Here shown may be somewhat different from your TV. 9 2 3 4 RS-232C IN RGB IN COMPONENT IN 1 (CONTROL & SERVICE) (PC) ANTENNA/CABLE IN AUDIO IN HDMI/DVI HEADPHONE AV IN IN (RGB/DVI) 8 3 7 6 EXCLUSIVE SERVICE 5 1 6 ANTENNA/CABLE IN AV IN (Audio/Video) Connect over-the air signals to this jack. Connect audio/video output from an external device to these jacks. Connect cable signals to this jack. 2 7 HEADPHONE INPUT RS-232C IN (CONTROL & SERVICE) PORT Plug the he
Summary of the content on the page No. 12
PREPARATION PREPARATION STAND INSTALLATION Here shown may be somewhat different from your TV. Carefully place the product screen side down on 1 a cushioned surface that will protect product and screen from damage. Assemble the product stand with the product as 2 shown. Install the 4 bolts securely, in the back of the 3 product in the holes provided. BACK COVER FOR WIRE ARRANGEMENT Arrange the cables as shown picture. 10
Summary of the content on the page No. 13
PREPARATION ATTACHING THE TV TO A WALL You should purchase necessary components to prevent TV from falling off of the stand. Here shown may be somewhat different from your TV. We recommend that you set up the TV close to a wall so it cannot fall over if pushed backwards. Additionally, we recommend that the TV be attached to a wall so it cannot be pulled in a forward direction, potentially causing injury or damaging the product. Caution: Please make sure that children don’t climb on or hang
Summary of the content on the page No. 14
PREPARATION PREPARATION DESKTOP PEDESTAL INSTALLATION For proper ventilation, allow a clearance of 4 inches on all four sides from the wall. 4 inches 4 inches 4 inches 4 inches CAUTION Ensure adequate ventilation by following the clearance recommendations. G G PROTECTION COVER When installing the wall-mounted unit, use the protection cover for desk-type stand installation. 12
Summary of the content on the page No. 15
PREPARATION ANTENNA OR CABLE CONNECTION 1. Antenna (Analog or Digital) Wall Antenna Socket or Outdoor Antenna without a Cable Box Connections. For optimum picture quality, adjust antenna direction if needed. Multi-family Dwellings/Apartments Wall (Connect to wall antenna socket) Antenna Socket ANTENNA/CABLE IN RF Coaxial Wire (75 ohm) Outdoor Antenna Single-family Dwellings /Houses (VHF, UHF) Copper Wire (Connect to wall jack for outdoor antenna) Be careful not to bend the bronze wire when conne
Summary of the content on the page No. 16
EXTERNAL EQUIPMENT SETUP EXTERNAL EQUIPMENT SETUP To prevent the equipment damage, never plug in any power cords until you have finished connecting all equipment. HD RECEIVER SETUP This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. When connecting Component cable 1. How to connect GB IN COMPONENT IN PC) ( ) Conn
Summary of the content on the page No. 17
EXTERNAL EQUIPMENT SETUP When connecting HDMI cable 1. How to connect HDMI-DTV OUTPUT Connect the digital set-top box to H HD DM MII/ /D DV VII IIN N 1 jack on the set. No separated audio connection is necessary. 2 HDMI supports both audio and video. 1 2. How to use RS-232C IN RGB IN (CONTROL & SERVICE) (PC) Turn on the digital set-top box. ANTENNA/CABLE ( ) Refer to the owner’s manual for the digital set-top box. IN AUDIO IN HDMI/DVI Select H HD DM MII input source by using the IIN NP PU
Summary of the content on the page No. 18
EXTERNAL EQUIPMENT SETUP EXTERNAL EQUIPMENT SETUP When connecting HDMI to DVI cable L R DVI-DTV OUTPUT 2 1 RS-232C IN RGB IN COMPONENT IN (CONTROL & SERVICE) (PC) ANTENNA/CABLE IN HDMI/DVI AUDIO IN HEADPHONE AV IN IN (RGB/DVI) EXCLUSIVE SERVICE 1. How to connect Connect the DVI output of the digital set-top box to the H HD DM MII/ /D DV VII IIN N jack on the set. 1 ( ( ) ) Connect the audio output of the digital set-top box to the A AU UD DIIO O IIN N R RG GB B/ /D DV VII jack on the set. 2
Summary of the content on the page No. 19
EXTERNAL EQUIPMENT SETUP DVD SETUP When connecting Component cable 1. How to connect ( ) Connect the video outputs Y, PB, PR of the DVD to the 1 ( ( ) ) C CO OM MP PO ON NE EN NT T IIN N Y Y,, P PB B,, P PR R jacks on the set. Match the jack colors GB IN COMPONENT IN (PC) ( ) Y = green, PB = blue, and PR = red . Connect the audio outputs of the DVD to the 2 AUDIO IN ( ( ) ) C CO OM MP PO ON NE EN NT T IIN N L L,, R R jacks on the set. HEADPHONE AV IN RGB/DVI) EXCLUSIVE SERVICE 2. How to
Summary of the content on the page No. 20
EXTERNAL EQUIPMENT SETUP EXTERNAL EQUIPMENT SETUP When connecting HDMI cable 1. How to connect HDMI-DVD OUTPUT Connect the HDMI output of the DVD to the 1 H HD DM MII/ /D DV VII IIN N jack on the set. No separated audio connection is necessary. 2 HDMI supports both audio and video. 1 2. How to use RS-232C IN RGB IN (CONTROL & SERVICE) (PC) Select H HD DM MII input source by using the IIN NP PU UT T button on the remote control. ANTENNA/CABLE IN Refer to the DVD player's manual for operatin