Summary of the content on the page No. 1
LCD TV
MODEL: 26LC2D
OWNER’S MANUAL
Internet Home Page : http://www.lge.com
http://www.lg.ca
ENERGYSTAR is a set of power-saving
Please read this manual carefully before operating your set.
guidelines issued by the U.S.
Retain it for future reference.
Environmental Protection Agency(EPA).
Record model number and serial number of the set.
See the label attached on the back cover and quote
As an ENERGY STAR
this information to your dealer
Partner LGE U. S. A.,Inc.
when you require service.
ha
Summary of the content on the page No. 2
Warning Warning Warning CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of suffi- cient magnitude to constitute a risk of electric shock to persons.
Summary of the content on the page No. 3
Owner's Manual Safety Instructions Safety Instructions Safety Instructions WARNING : To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus. IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifi
Summary of the content on the page No. 4
Safety Instructions 12. Use only with a cart, stand, tripod, bracket, or table 14. Refer all servicing to qualified service personnel. specified by the manufacturer, or sold with the appa- Servicing is required when the apparatus has been ratus. When a cart is used, use caution when moving damaged in any way, such as power supply cord or the cart / apparatus combination to avoid injury from plug is damaged, liquid has been spilled or objects tip-over. have fallen into the apparatus, the apparatu
Summary of the content on the page No. 5
Contents Contents Contents 2 Warning 3~4 Safety Instructions 7 Accessories / Optional Extras 8 Controls 9 Connection Options 10~11 Remote Control Key Function 12 Attaching the TV to a wall 13 Desktop Pedestal Installation 14 Basic Connection 15 Antenna or Cable Connection 16~17 VCR Setup 18~19 DVD Setup External 20~21 HDSTB Setup Equipment 22 External AV Source Setup Connections 22 AV Out Setup 23 Digital Audio Output 24~26 PC Setup 27 Turning on the TV 27 Volume Adjustment 27 Channel Selection
Summary of the content on the page No. 6
Contents 41 Manual Clock Setup 41 Auto Clock Setup Time Menu 42 On/Off Timer Setup Options 42 Sleep Timer 43 Auto Off 44 Aspect Ratio Control Option Menu 45 Caption/Text Features 46 Caption Option Lock Menu Options 47~48 Parental Lock Setup 49~53 External Control Device Setup 54~55 IR Codes 56 Programming the Remote 57~58 Programming Codes 59~60 Troubleshooting Checklist 61 Maintenance 62 Product Specifications 6 Reference Operation
Summary of the content on the page No. 7
INPUT MODE TV POWER TV INPUT DVD RATIO VCR COMP1 COMP2 HDMI RGB-PC EZ PIC EZ SOUND ADJUST INFO CC MENU SAP EXIT TIMER IMER ENTER TER FLASH BACK BA FLASH CK VOL CH CH MUTE UTE 12 3 3 45 6 78 9 0 FAV Introduction Introduction Introduction Accessories Accessories Ensure that the following accessories are included with your product. If any accessory is missing, please contact the dealer from where you purchased the product. User must use shield signal interface cable (D-sub 15 pin cable) with fe
Summary of the content on the page No. 8
Introduction Controls Controls - This is a simplified representation of front panel. - This picture shown below may be somewhat different from your TV. CH CH CHANNEL (D, E) Buttons VOLUME (F,G) VO VOL L Buttons ENTER Button ENTER ENTER MENU Button M MENU ENU R INPUT Button INPUT INPUT (Power) Button Remote Control Sensor Power/Standby Indicator • illuminates red in standby mode. • illuminates green when the set is switched on. 8
Summary of the content on the page No. 9
AV AV A AV V AV AV COMPONENT COMPONENT COMPONENT I IN N O OUT UT I IN 1 N 1 IN OUT IN 1 AV AV AV AV COMPONENT COMPONENT OUT IN 1 OUT IN 1 IN IN Introduction Connection Options Connection Options - This picture shown below may be somewhat different from your TV. S-VIDEO Input Provides better picture quality than the video input. VIDEO Input Connects the video signal from a video device. AUDIO Input 11 Connections are available for listening to stereo sound from an external device. 10 7 SERV
Summary of the content on the page No. 10
Introduction Remote Control Key Functions Remote Control Key Functions TV INPUT In AV 1-2, Component 1-2, RGB-PC, HDMI1/DVI or HDMI2 input sources, screen returns to the last TV channel. INPUT MODE TV TV POWER INPUT External input modes rotate in regular sequence: TV, AV1-2, INPUT DVD Component 1-2, RGB-PC, HDMI1/DVI or HDMI2. RATIO VCR (AV 1-2, Component 1-2, RGB-PC , HDMI1/DVI or HDMI2 input sources are linked automatically, only if these are con- COMP1 COMP2 HDMI RGB-PC nected.) EZ PIC EZ SO
Summary of the content on the page No. 11
Introduction TV, DVD, VCR Selects the remote operating mode: TV, VCR, DVD. Select other operating modes, for the remote to operate external devices. COMP1 Directly, select Component1 input. COMP2 Directly, select Component2 input. HDMI Directly, select HDMI1/DVI input. Directly, select RGB input. RGB-PC EZ PIC Adjust the factory preset picture depend on the viewing environment.(red) p.33 G G EZ SOUND Select the appropriate type of sound for type of program.(green) p.38 G G ADJUST Adjust the s
Summary of the content on the page No. 12
Installation Installation Installation Attaching the TV to a wall Attaching the TV to a wall We recommend that you set up the TV close to a wall so it cannot fall over if pushed backwards. Additionally, we recommend that the TV be attached to a wall so it cannot be pulled in a forward direction, poten- tially causing injury or damaging the product. Caution: Please make sure that children don’t climb on or hang from the TV. Insert the eye-bolts (or TV brackets and bolts) to tighten the prod
Summary of the content on the page No. 13
Installation Desktop Pedestal Installation Desktop Pedestal Installation For proper ventilation, allow a clearance of 4inches on each side from the wall. 4 inches 4 inches 4 inches 4 inches CAUTION G G Ensure adequate ventilation by following the clearance recommendations. This picture shown below may be somewhat different from your TV. Power Supply Short-circuit Breaker GROUNDING Ensure that you connect the earth ground wire to prevent possible electric shock. If grounding methods are not possi
Summary of the content on the page No. 14
Basic Connection Basic Connection Connect the cables as necessary. 1 After connecting the cables neatly, arrange the cables to the Cable Holder. To connect an additional equipment, see the External equipment Connections section. Cable holder CABLE MANAGEMENT Reinstall the CABLE MANAGEMENT as 2 shown. Bundle the cables using the supplied 3 twister holder. How to remove the CABLE MANAGEMENT CABLE - Hold the CABLE MANAGEMENT with both hands MANAGEMENT and pull it upward. Do not hold the CABLE MA
Summary of the content on the page No. 15
COMPONENT AV AV COMPONENT AV AV OUT OUT IN IN 1 IN IN 1 COMPONENT AV AV COMPONENT AV AV OUT OUT IN IN 1 IN IN 1 COMPONENT AV AV COMPONENT AV AV OUT IN 1 OUT IN 1 IN IN AV OUT COMPONENT IN AV IN 1 COMPONENT IN AV OUT AV IN 1 Installation External Equipment Connections External Equipment Connections NOTE: All cables shown are not included with the TV Antenna Or Cable Connection Analog and Digital TV signals provided on antenna - Antenna or Cable Service without a Cable Box Connection. SERVICE -
Summary of the content on the page No. 16
COMPONENT AV AV OUT IN 1 IN COMPONENT AV AV OUT IN IN 1 COMPONENT AV AV OUT IN 1 AV IN COMPONENT AV IN OUT IN 1 Installation VCR Setup - To avoid picture noise (interference), leave an adequate distance between the VCR and TV. - Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen. When connecting with an antenna 1 Connect the RF antenna out socket of the VCR to 2 VCR the ANTENNA/CABLE IN
Summary of the content on the page No. 17
COMPONENT AV AV IN OUT IN 1 COMPONENT AV AV IN OUT IN 1 SERVICE RGB IN (PC) AUDIO IN REMOTE (RGB/DVI) CONTROL IN HDMI IN 2 1(DVI) ANTENNA/ CABLE IN RS-232C IN (CONTROL & SERVICE) Installation VIDEO AUDIO DIGITAL OPTICAL AUDIO OUT ( ) S-VIDEO VIDEO AUDIO When connecting with an S-Video cable VCR ANT IN 1 Connect the S-VIDEO output of the VCR to the S- VIDEO input on the set. The picture quality is S-VIDEO OUT ANT OUT (R) AUDIO (L) VIDEO OUTPUT improved; compared to normal composite
Summary of the content on the page No. 18
COMPONENT AV AV COMPONENT AV AV IN OUT IN 1 IN OUT IN 1 COMPONENT AV AV COMPONENT AV AV IN OUT IN 1 IN OUT IN 1 VIDEO AUDIO HDMI IN 2 DIGITAL OPTICAL 1(DVI) AUDIO OUT ANTENNA/ ( ) CABLE IN S-VIDEO VIDEO AUDIO Installation DVD Setup When connecting with a S-Video cable DVD S-VIDEO (R) AUDIO (L) 1 2 AUDIO VIDEO DIGITAL OPTICAL AUDIO OUT (MONO ) S-VIDEO VIDEO AUDIO 1 Connect the S-VIDEO output of the DVD to the S-VIDEO input on the set. 2 Connect the audio outputs of the
Summary of the content on the page No. 19
COMPONENT COMPONENT AV AV COMPONENT AV AV IN OUT IN 1 IN OUT IN 1 Installation When connecting with a component cable B R (R) AUDIO (L) DVD 1 2 AUDIO VIDEO HDMI IN 2 DIGITAL OPTICAL 1(DVI) AUDIO OUT ANTENNA/ (MONO ) CABLE IN S-VIDEO VIDEO AUDIO 1 Connect the video outputs (Y, PB, PR) of the DVD to the COMPONENT IN VIDEO1 jacks on the set. 2 Connect the audio outputs of the DVD to the COMPONENT IN AUDIO1 jacks on the set. 3 Turn on the DVD player, insert a DVD. 4 Select Component
Summary of the content on the page No. 20
COMPONENT COMPONENT AV AV OUT IN IN 1 COMPONENT AV AV IN OUT IN 1 Installation HDSTB Setup - This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. When connecting with a HDMI cable SERVICE SERVICE RGB IN (PC) (PC) 1 Connect the HDMI output of the digital set-top AUDIO IN REMOTE REMOTE (RGB/DVI) HDMI IN CONTROL IN 2
