ATD Tools atd-5928 user manual

Summary of the content on the page No. 1

ATD-5928
RECHARGEABLE 12 VOLT 22 AMP/HOUR JUMP START
OWNERS MANUAL
 



• 1700 PEAK AMPS/700 CRANKING AMPS OF STARTING POWER.
• STARTS CARS, TRUCKS, RV’s AND BOATS WITHOUT THE NEED OF ANOTHER VEHICLE OR AC POWER CORDS.
• 12V DC SOCKET WITH OVERLOAD PROTECTION PROVIDES POWER FOR ANY 12V APPLIANCE.
• PROVIDES UP TO 50-HOURS OF DC POWER WHEN USED WITH 12V DC APPLIANCES.
• ALLOWS 12V DC APPLIANCES TO BE USED IN REMOTE SITES AND/OR IN EMERGENCIES WHEN COMMERCIAL POWER IS NOT AVAILABLE.
•

Summary of the content on the page No. 2

INTRODUCTION YOUR POWER PACK UNIT IS DESIGNED AS A COMPACT, DURABLE AND PORTABLE JUMP START SYSTEM FOR 12 VOLT DC VEHICLES AND BOATS. THIS SELF-CONTAINED SYSTEM WILL START MOST VEHICLES AND BOATS WITHOUT THE NEED FOR A HOST VEHICLE OR 120V AC POWER SUPPLY. THIS SYSTEM CAN ALSO BE USED AS A SAFE, PORTABLE SOURCE OF 12V DC ELECTRIC POWER IN REMOTE LOCATIONS AND/OR IN EMERGENCIES. THE POWER PACK UNIT HAS AN EASY-TO-READ, COLOR-CODED BATTERY METER THAT INDICATES CHARGE LEVEL. A 12V DC SOCKE

Summary of the content on the page No. 3

WARNINGS • ALWAYS WEAR EYE PROTECTION WHEN WORKING ON OR AROUND LEAD-ACID BATTERIES. IF SPLASHED WITH BATTERY ACID: IMMEDIATELY FLUSH AFFECTED AREA SUCH AS FACE AND PARTICULARLY THE EYES WITH CLEAN WATER. CONTINUE FLUSHING FACE AND EYES UNTIL MEDICAL HELP ARRIVES. • LEAD-ACID BATTERIES GENERATE HYDROGEN GAS DURING NORMAL OPERATION. MORE GAS IS GENERATED WHEN THE BATTERY IS CHARGING. HYDROGEN GAS IS: 1. EXPLOSIVE 2. POISONOUS TO BREATHE 3. HIGHLY FLAMMABLE • TO AVOID PO

Summary of the content on the page No. 4

120V AC/12V DC CHARGING : PLUG THE 120V AC/12V DC CHARGING ADAPTER INTO A WALL OUTLET AND INTO THE RECEPTACLE ON YOUR NEW POWER PACK UNIT. CHARGE THIS DEVICE FOR AT LEAST 4 HOURS OR UNTIL THE METER SHOWS A FULL (14- TO 15-V DC) CHARGE WHEN THE RED ROCKER SWITCH IS DEPRESSED. THE RECHARGING CONVERTER CIRCUIT UNIT HAS AN AUTOMATIC CUT-OFF CIRCUIT SO THE INTERNAL BATTERY CANNOT BE OVERCHARGED. TO RECHARGE YOUR POWER PACK UNIT BATTERY FROM 120V AC FOLLOW THESE STEPS : 1. PULL THE PLUG COVER F

Summary of the content on the page No. 5

    JUMP-STARTING: FOR OPTIMUM PERFORMANCE, WHEN USING YOUR POWER PACK UNIT TO JUMP START A VEHICLE OR BOAT, PLEASE READ AND FOLLOW THESE STEP-BY-STEP INSTRUCTIONS: 1. SWITCH THE ENGINE OF THE VEHICLE OR BOAT TO BE JUMP-STARTED TO “OFF”. 2. CONNECT THE RED (+) “ALLIGATOR” CLAMP TO THE RED (+) POSITIVE BATTERY TERMINAL. 3. CONNECT THE BLACK (-) “ALLIGATOR” CLAMP TO A NON-MOVING METAL PART OF THE ENGINE, NOT TO THE (-) NEGATIVE BATTERY TERMINAL. 4. TURN POWER PACK UNIT SWITCH TO “ON”. 5.

Summary of the content on the page No. 6

ATD-5928 14 12 13 11 10 9 8 7 6 5 19 18 15 4 1 3 16 2 17 ITEM# ORDERING PART# DESCRIPTION ITEM# ORDERING PART# DESCRIPTION 1 PRT5928-01 FIXING BOARD, ON/OFF SWITCH 11 PRT5928-11 CASE 2 PRT5928-02 TEST SWITCH 12 ATD5904 BATTERY, 12V/22AH 3 PRT5928-03 KNOB, ON/OFF SWITCH 13 PRT5928-13 BACK COVER 4 PRT5928-04 COVER, CIGARETTE 14 PRT5928-14 SCREW 5 PRT5928-05 VOLTMETER 15 PRT5928-10 CLAMP, RED & BLACK WITH 4GA CABLE 6 PRT5928-06 FRONT PANEL 16 PRT5928-16 SCREW 7 PRT5928-07 FIXING BOARD, VOL