Hitachi L32C205 user manual

Summary of the content on the page No. 1

Owner’s Guide
Model L32C205
32” Class (31.51” Diagonal)
Thank you for purchasing this Hitachi product. Please read these instructions carefully.
For additional assistance please call 1-888-333-1899(U.S.A. or Puerto Rico), or 01-800-700-4321(Mexico)
or visit our website at www.hitachi.us/tv.
Keep this owner’s guide for future reference.
Record the model number and serial number of your LCD Television for future reference.
This information is located on the back of the television.
MODEL NUMBER

Summary of the content on the page No. 2

Summary of the content on the page No. 3

Summary of the content on the page No. 4

Summary of the content on the page No. 5

Summary of the content on the page No. 6

SAFETY PRECAUTIONS The unit emits heat when in operation. Do not place any covers or blankets on the unit, this may cause overheating. Do not block ventilation holes, or set up near radiators. Do not place in direct sunlight. When placing on a shelf leave 4 inches (10 cm) free space around the entire unit. 4 inches 4 inches Notes when mounting the LCD TV on a wall If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV for advice, and have the equipment pr

Summary of the content on the page No. 7

The below figures are for reference only,please refer to the actual units to determine the appearances. Every hole of the pedestal must be fastened with screws! 1.Lay the soft cloth on a table which can hold the weight of the whole TV. 2.Put the TV on the cloth with its back upwards and the LCD downwards. 3.Take out the pedestal,and insert the pedestal into the TV then put the pedestal,to relevant position of the TV set,until all the holes match each other completely. 4. Fasten the p

Summary of the content on the page No. 8

Summary of the content on the page No. 9

End User License Agreement

Summary of the content on the page No. 10

POWER COMPONENT

Summary of the content on the page No. 11

Summary of the content on the page No. 12

Antenna connections If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see Cable TV connections. Combination VHF/UHF Antenna (Single 75 ohm cable) Antenna Jack 75 ohm Coaxial Cable Cable TV connections This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer “premium pay channels” where the signal is scrambled. De

Summary of the content on the page No. 13

Starting setup TO SELECT DIGITAL CHANNELS – button followed by the remaining number. will assist you to specify the Air/Cable setting and program Example, to select channel 15-1, press 1, 5, –, 1, then press your channels automatically. SELECT. • If a channel is selected with only audio content, “Audio IMPORTANT: Make sure that the antenna or cable TV system only” will be displayed on the screen. connection is made. • If a channel is selected with a weak digital signal, “Weak Signal or Cha

Summary of the content on the page No. 14

EXIT EXIT EXIT EXIT

Summary of the content on the page No. 15

Aspect Ratio EXIT EXIT EXIT EXIT

Summary of the content on the page No. 16

RGB ( "PC Standby" being only available in RGB input.)

Summary of the content on the page No. 17

Summary of the content on the page No. 18

Summary of the content on the page No. 19

Summary of the content on the page No. 20

To connect a HDMI or a DVI device to the unit The HDMI/DVI input receives digital audio and uncompressed video from a HDMI device or uncompressed digital video from a DVI device. When you connect to a DVI device with a HDMI-to-DVI adapter cable, it transfers only video signal. Separate analog audio cables are required. Back of the unit To DVI output RGB/DVI AUDIO Input Audio cord (not supplied) DVI device HDMI - to - DVI adapter cable (HDMI type A connector) (not supplied) To HDMI/DVI IN HDM