Summary of the content on the page No. 1
ELECTRONIC
AIR PURIFICATION
SYSTEM
Eliminator
Series
SE400E and SE800E
• INSTALLATION
• OPERATION
• SERVICE
Electrostatic Precipitators for
Commercial Applications
101 McNeill Road • Sanford, NC 27330
(919) 775-2201 • Fax: (919) 777-6399 • (800) 884-0002
www.trioninc.com
MANUAL PART NO. 154385-002 • September 2001
1
Summary of the content on the page No. 2
Contents Section I – Design Page 1. Introduction……………………….. 3 2. The Filter System………………… 3 3. Specifications…………………….. 4 Section II - Installation 1. Installation………………………… 5-6 2. Diagrams………………………….. 7 Section III – Servicing and Maintenance 1. Servicing / Maintenance………… 8 2. Parts List………………………….. 9 3. Exploded Views………………….. 10 Section IV - Reference 1. Wiring Diagram SE400E………… 11 2. Wiring Diagram SE 800E……….. 12 This manual provides information for installation, operation and maintenance
Summary of the content on the page No. 3
2. The Filter System Eliminator SE Series There are two filters in your air cleaner - Section I – Design THE PRE-FILTER: This is the mechanical filter that lies behind the inlet grill. It is 1. Introduction designed to remove large particles and can be washed many times before replacement. The Trion Eliminator SE400E & SE800E are commercial air purifiers that have been THE ELECTROSTATIC FILTER: This is the specifically designed to remove airborne deep aluminum assembly (Collector Cell) poll
Summary of the content on the page No. 4
Eliminator SE Series 3. Specifications Model SE400E SE800E Dimensions Depth: 9.5” Depth: 9.5” Width: 22.5” Width: 22.5” Length: 22.5” Length: 46.12” Installation Surface mounted, recessed into suspended ceiling, or wall (SE400E only) mounted. Weight 42 lbs. / shipping 48 lbs. 80 lbs. / shipping 86 lbs. Input Power 120 Volts, 1 Phase, 60 Hz 120 Volts, 1 Phase, 60 Hz Power Consumed 1.8 Amps, 155 Watts 3.4 Amps, 270 Watts Controls Hard-wired remote control Hard wired remote control with 3-speed se
Summary of the content on the page No. 5
g) Make electrical connections as detailed in next Eliminator SE400E & SE800E section. h) Re-install cell and prefilter. Section II – Installation i) Close access door and unit is ready for operation. 1. INSTALLATION SOLID CEILNG MOUNTING CAUTION: To mount the unit to a solid ceiling, proceed as follows: ELECTRONIC AIR CLEANERS a) Unpack the unit, open filter access door CANNOT BE USED IN AREAS WHERE and remove prefilter and cell (see filter COMBUSTIBLE GASES OR VAPORS removal in section 2).
Summary of the content on the page No. 6
Hard wired remote control Two sets of wiring are required to connect the unit. Main power to the unit is 120V, 60Hz, 1Ph, rated 5 Amp - Live, Neutral and Ground. A 5-conductor 5 Amp rated cable is required from the unit to remote control. Run the 5-conductor cable and the main power connection through the cable entry knockouts (see Fig. 5) in the cabinet and connect to the input terminal block (Fig. 6) as shown in the wiring diagram on page 10 and 11. Mount the remote control in the desired
Summary of the content on the page No. 7
2. Diagrams FIGURE 1. FIGURE 2. FIGURE 4. FIGURE 3. FIGURE 6. FIGURE 5. 7
Summary of the content on the page No. 8
Section III – Service and Maintenance 1. SERVICING AND MAINTENANCE Beyond an occasional wipe down with a damp cloth, the units need little in the way of maintenance. However, the units are designed to collect airborne dirt and from time to time will require routine servicing to remove the accumulation. The service interval varies considerably between applications, but typically will range from six weeks in a busy bar up to several months in a quiet office. During normal operation, the unit will
Summary of the content on the page No. 9
2. PARTS LIST Item Part Number Description Qty/Unit Qty/Unit SE400E SE800E 1 454027-001 Cabinet Assembly, SE400E 1 - 2 454028-001 Cabinet Assembly, SE800E - 1 3 453844-001 Cell Access Cover 1 - 4 453844-003 Discharge Cover 1 2 5 453845-001 Cell Access Cover - 2 6 153853-001 Hinge Pin 2 4 7 453855-001 Grill 4 6 8 453856-001 Corner 4 4 9 453857-001 Grill Filler - 2 10 253863-001 Pre-filter 1 2 11 441730-103 Collector Cell 1 2 12 150685-001 Cell Retaining Clip 1 2 13 353842-001 Cell Latch 1 2 14 15
Summary of the content on the page No. 10
3. Exploded Views SE400E SE800E 10
Summary of the content on the page No. 11
Section IV – Reference 1. WIRING DIAGRAM SE400E 11
Summary of the content on the page No. 12
2. WIRING DIAGRAM SE800E WARRANTY All Trion air cleaners are warranted for component failure and workmanship for a period of three years after purchase. Do not return defective parts without prior permission from the factory. Contact your local Trion Distributor or Trion Customer Service Department at 800-884-0002 or Fax 800-458-2379 to obtain material return authorizations and service information. 101 McNeill Road • Sanford, NC 27331-0760 Customer Service: (800) 884-0002 • Fax: (800) 458-2379
