Vector Power On Board VEC012POB user manual

Summary of the content on the page No. 1

VEC012POB_ManualEN_042506 5/19/06 4:14 PM Page 8
VEC012POB
TWO YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth all the
responsibilities of Power On Board regarding this product. There is no other warranty, other than those
described herein. Any implied warranty of merchantability or fitness for a particular purpose on this
product is limited in duration to the duration of this warranty.
This Power On Board product is

Summary of the content on the page No. 2

VEC012POB_ManualEN_042506 5/19/06 4:14 PM Page ii Inflator Safety IMPORTANT SAFETY INSTRUCTIONS 1. Never attempt to disable or block the inflation and deflation ports while pump is operating. WARNINGS 2. Never cover unit at any time. 1. RISK OF EXPLOSIVE GAS MIXTURES — WORKING IN THE VICINITY OF A LEAD-ACID 3. Never leave the pump unattended while in use. BATTERY IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING 4. Never allow sand, small rocks or other debris to be sucked into the inf

Summary of the content on the page No. 3

VEC012POB_ManualEN_042506 5/19/06 4:14 PM Page iv TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Control and Function Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Using the Jump-Starter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Summary of the content on the page No. 4

VEC012POB_ManualEN_042506 5/19/06 4:14 PM Page 2 Control and Function Guide 1. Turn OFF vehicle ignition and all accessories (radio, A/C, lights, connected cell phone chargers, etc.). Place vehicle in “park” and set the emergency brake. 5 4 6 2. Make sure the Jump-Starter Power Switch is turned to OFF. 12 3 3. Remove jumper clamps from clamp tabs. Connect the red clamp first, then 7 11 the black clamp. 2 8 4.Procedure for jump-starting a NEGATIVE GROUNDED SYSTEM (negative battery terminal is

Summary of the content on the page No. 5

VEC012POB_ManualEN_042506 5/19/06 4:14 PM Page 4 (approximately 15 minutes, depending on ambient temperatures), as CAUTIONS it may overheat. In such event, inflator will automatically shut down • If the audible Reverse Connection Polarity Alarm sounds after clamps are connected and restart after a cooling down period of approximately 15 minutes. to vehicle battery, reverse clamp connections. Inflating Tires or Products With Valve Stems • If vehicle fails to start, turn OFF the ignition, turn

Summary of the content on the page No. 6

VEC012POB_ManualEN_042506 5/19/06 4:14 PM Page 6 Charging/Recharging Fuse Replacement (DC Charging Adapter) For maximum battery life, we recommend the Jump-Start System be kept fully 1. Remove the plug from the accessory outlet. Remove the gold cap by turning charged at all times. If the battery is allowed to remain in a discharged state, counterclockwise and lifting off. battery life will be shortened. 2. Remove the center pin and spring. Remove the fuse. Note: Recharging battery after each