Summary of the content on the page No. 1
Precautions
The lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated “dangerous voltage”
within the product’s enclosure that may be of sufficient magnitude to constitute
a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operation and servicing instructions in the
literature accompanying the appliance.
For Customer Use:
Enter
Summary of the content on the page No. 2
Precautions WARNING: To prevent fire or shock hazard, do not expose this device to rain or moisture. Dangerous high voltage is present inside the enclosure. Do not open the cabinet. Note: If the product suddenly has no response or powers off, an electrostatic discharge may be the cause. In this circumstance, please follow the procedures below for recovery: • Unplug the unit. Wait 30 seconds. • After 30 seconds, plug the unit in and turn it on again. FCC Statement: This device complies with
Summary of the content on the page No. 3
Important Safety Instructions Warnings and precautions To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely, and keep it nearby for future reference. Important Safety Instructions 1. Read Instructions: All the safety and operating instructions should be read before the product is operated. 2. Retain Instructions: The safety and opera
Summary of the content on the page No. 4
Important Safety Instructions Antenna Safety Instructions If an outdoor antenna is connected, follow the precautions below: • An outdoor antenna should not be located in any area where it could come in contact with overhead power lines, or any other electric light or power circuits. • When installing an outdoor antenna system, extreme caution should be taken to prevent contact with power lines. Direct contact with power lines may be fatal and should be avoided at all costs. Section 810 of Nati
Summary of the content on the page No. 5
Table of Contents Table Of Contents Precautions Important Safety Instructions Main Feature-----------------------------------------------------------------------------------------------------------------------------1 Package Contents-----------------------------------------------------------------------------------------------------------------2 Unit View---------------------------------------------------------------------------------------------------------------------3 Remote Control ---------
Summary of the content on the page No. 6
Main Features Multiple Mode TV AV1 AV2 S-VIDEO COMPONENT1 COMPONENT2 DVD HDMI1 HDMI2 HDMI3 VGA High Quality Property High Resolution Adopt an MPEG2 decoding format to achieve horizontal resolution more than 500 lines. Superior sound Built-in Dolby Digital decoder to output high quality sound effects. Screen Support the picture size of a normal screen (4:3) and a wide screen (16:9) LCD (Liquid Crystal Display) TFT liquid crystal display tec
Summary of the content on the page No. 7
Package Contents Please make sure the following items are included with your product. If any item is missing, contact your dealer. a. b. c. a, Main Unit b, Power Cord & RCA Cable c, Remote Control Unit 2
Summary of the content on the page No. 8
Unit View 1 9 10 4 5 11 6 12 13 7 14 8 3 2 1. TFT SCREEN Present high resolution pictures 2. POWER INDICATOR Lights blue in the standby/power-on mode, 3. REMOTE SENSOR Sense the remote control signal. 4. SOURCE Select a working mode. 5. MENU 15 Display the system setup menu. ANTIN AC 100V-240V 50Hz/60Hz 6. CH+/- 16 Press to skip channels. 18 7. VOL+/- Adjust sound output level. 8. POWER Press to turn on/off the player. 17 9. Disc Slot 10. Card Slot 11. USB Port 1
Summary of the content on the page No. 9
Remote Control Remote Control Drawing 21 1 1. POWER Turn the unit on or off (standby). 2. Numeric Keypad 2 Input numberic data. Access the TV channel directly. 22 3 3. Sub-channel Selector <-> This button is usually used with the numeric keypad 4 23 5 to tune to a channel substation (e.g., 4-1, 4-2). 24 6 25 e.g. To tune to channel 13-2, press these keys in 26 7 27 sequence: <1>, <3>, <–>, <2>. 8 28 4. Skip Backward Repeatedly press this button to skip backward through
Summary of the content on the page No. 10
Remote Control 21. OPEN/CLOSE In the DVD mode, press this button to take in/out disc automatically. 22. RETURN Reveal the previously viewed channel. 23. Skip Forward Repeatedly press this button to skip forward through DVD playback. 24. SLOW Press this button to have current playback advanced in a slow motion, repeatedly press this button to change advance speed. You can press Play/Pause to pause current playback, and then repeatedly press this button to
Summary of the content on the page No. 11
Remote Control Remote Control Preparation • Remove the battery compartment cover located on the rear of the remote control. Insert 2 x “AAA” batteries, making sure to match their polarities (+/-) to the markings on the inside of the compartment. Replace the cover. • Batteries in the remote will last for approximately 6 months under the normal use. Replace the batteries if the remote control does not work. Do not mix old with new batteries, or different types of
Summary of the content on the page No. 12
Cable Connections Figure. Cable connections Antenna/Power Connection 1. Connect TV RF sources to the antenna port. TV RF signals include: receiving antenna/CATV net. You can use 75 Ohm coaxial cable to connect outdoor antenna. 2. Insert one end of the supplied power cord to the player’s power jack and the other end to the 110-240V AC wall outlet. AC 100V-240V 50Hz/60Hz IMPORTANT NOTICE Wall Outlet 100~240V 1. Be sure to have all necessary connections properly done before connect the power su
Summary of the content on the page No. 13
Cable Connections Coaxial Output - Digital Audio Output Connector When MPEG audio or Dolby Digital audio is played, Dolby Digital bitstream or MPEG audio bitstream is sent to the player’s digital audio output connector. When the player is connected to a Dolby or MPEG audio decorder via this output socket, you can enjoy theater-quality audio in your home. A coaxial audio cable is required when a Dolby Digital decoder or MPEG audio decoder is used. The mentioned cable is not included with this
Summary of the content on the page No. 14
Cable Connections HDMI 1/2/3 Input Unit Rear Panel HDMI1,2 Connection HDMI (High Definition Multimedia Interface) is a new type of connection that transmits digital audio and video signals simultaneously over a single cable. A HDMI cable is required for AC 100V-240V 50Hz/60Hz the HDMI connection. These HDMI input connectors are capable of receiving video at resolutions up to 1080p (1080- progressive). External AV Source External AV Source Unit Side Panel HDMI3 Connection Component 1/2 I
Summary of the content on the page No. 15
Cable Connections S-Video Input The S-Video port is capable of accepting signals from standard video sources. (e.g., cable/satellite boxes, DVD players, VCRs, etc.) AC 100V-240V 1. Connect the S-Video port b 50y Hz/ 6t 0Hh z e S-Video cable to input the video signal. S-Video cable is not included with this product 2. Connect the L, R port by the white/red plug of the supplied AV cable to input the audio signal. External AV Source RCA Input The CVBS port is capable of accepting signals fr
Summary of the content on the page No. 16
TV Function TV Function Preparations 1. Connect cables.(Refer to the “Cable Connections” section for details). 2. Press POWER to turn on the player. 3. Press SOURCE to select the TV signal mode. a. Press the SOURCE button to display the Input Source menu. b. Press the UP or DOWN buttons to browse the mode options. c. Press OK to select a mode option. 4. Press the CH+/- buttons to skip channels. Or you can press the number buttons to input channels directly. For an initial use, you need to s
Summary of the content on the page No. 17
TV Function Menu Description Picture Menu ITEM DESCRIPTION Picture Mode Setup the picture mode. (Custom, Vivid, Standard, Sports, Theater, Energy Saving). Contrast Adjust the display contrast Brightness Adjust the display brightness Color Adjust the display color Tint Adjust the display tint Sharpness Adjust the image sharpness Display Press the right direction button to access the following options. Settings Color Temp. - Set the color mode as Normal/Warm/Cool Screen Mode -
Summary of the content on the page No. 18
TV Function Menu Description Option Menu ITEM DESCRIPTION Parental Controls - Press the right direction button to access Enter Password. Input the 4-digit password to display parental control menu. The initial password is 0000. Change Password - To change the password, input the old password - -> input the new password- - >verify again. Please remember the password since the player’s reset function would not revert the password. System Lock - Set the system lock funtion on/of
Summary of the content on the page No. 19
TV Function Menu Description Channel Menu ITEM DESCRIPTION Air/Cable Setup the antenna type as Air or Cable. Auto Scan Search channels automatically. Select this option, press the right button to start searching, press MENU to stop. Favorite Make the favorite channels collection. Select this option, press the right direction button to access the Favorite List. In the Favorite List, press the up/down direction button to select the desired channel. Press OK to set it as a
Summary of the content on the page No. 20
AV Function AV Function The player’s AV input function enables the user to view programs from external input sources. 1. Connect the external AV signal source. Refer to the “Cable Connection” section for details 2. Press the SOURCE button to select the relevant AV mode System Setup Menu Various features can be preset through the system menu. • Press the MENU button to display the system menu. • Press the left/right direction button to select the desired sub-menu, p
