Summary of the content on the page No. 1
-
TF TV2609
-
TF TV3209
Summary of the content on the page No. 2
LCD TV A Wide Array of Screen Settings You can choose different screen settings depending on the type of program you are watching or the surrounding conditions (the lighting or the outside weather conditions). You can switch between the Sport, Movie, Music and Normal options, or you can configure the screen settings yourself. A Wide Array of Sound Settings You can choose an optimal sound setting for the type of program you are watching. You can switch between the Music, Movie, News and Normal op
Summary of the content on the page No. 3
FCC Compliance Statements Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
Summary of the content on the page No. 4
Important Safety Instruction 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with a dry cloth. 7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. ) 9 Do not defeat the safety purpose of the p
Summary of the content on the page No. 5
Precaution External Television Antenna Grounding If an outside antenna or cable system is connected to the television equipment, be sure the antenna or cable system is electrically grounded to protect against voltage surges and built-up static charges. Section 810 of the National Electrical Code provides information about proper electrical grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-
Summary of the content on the page No. 6
Precaution The unit should not be placed in an enclosed installation such Do not use the unit in direct sunlight and keep it away from as a bookcase or limited-space rack unless proper ventilation heaters, stoves, and other sources of heat. is provided. Do not use the unit near water, oil or inflammables. During storm conditions (especially when there is lighting) unplug your TV set from the main electrical outlet and antenna. Do not use a damaged plug and do not let the power cord Do not conn
Summary of the content on the page No. 7
Precaution Do not use or store inflammable substances near the unit. Place the unit away from the wall for well ventilation. Place the antenna away from the electric wire, not to touch Do not touch the plug with wet hands. even though it falls down by wind. Be sure to insert the plug tightly. Hold the plug, not the cord, If an outside antenna is connected to the unit, do not let when disconnecting the plug from the wall outlet. the rain water get into the unit by bending or antenna wire sealin
Summary of the content on the page No. 8
Table of Contents Precaution ...................... 5 Sound Mode Settings ................ 26 Unpacking your TV.................. 9 Custom Sound Mode Settings............ 26 Inserting Batteries in the Remote Control .... 9 Sound Balance Settings .............. 27 Viewing the Control Panels (Front View)...... 10 Automatic Volume Control Settings ........ 27 Viewing the Control Panels (Rear View)...... 11 Sound (Digital Broadcasting) Settings ...... 28 Remote Control.................... 12 Sound (
Summary of the content on the page No. 9
Unpacking your TV Please make sure the following items are included with your TV set. If any items are missing, contact your dealer. Accessories Remote Control & Batteries (AAA x 2) Operating Instructions Power Cord Inserting Batteries in the Remote Control You must insert or replace the batteries in the remote control when you purchase the TV or when you find that the remote control is no longer operating correctly. Push the “▽” mark at the back of the remote control and pull 1 forward slight
Summary of the content on the page No. 10
Viewing the Control Panels Front View Right Side 1 2 3 4 Volume adjustment 1 2 Channel selection Input TV/AV selection 3 5 4 MENU selection 5 Power Remote control sensor 6 6 Power Indicator Status Indicator Status Red Stand-by Green Power on 10
Summary of the content on the page No. 11
Viewing the Control Panels Rear View ( ) Connection Cables Optional : not included 4 3 HDMI Connector DVI/PC Sound Cable 4 HDMI/DVI Connector Component Signal Cable 10 6 9 Digital Sound Connector Sound Cable 7 8 S-Video Connector AV Cable 11 PC Cable 5 Coaxial Cable Bottom Side 1 AC Power Input Terminal 7 S-Video Input Terminal 2 Service Port 8 External Terminals 1, 2 3 PC(DVI) Sound Input Terminal 9 Component Sound Input Terminals 1, 2 4 HDMI/DVI Input Terminal 10 Component Video Input Terminal
Summary of the content on the page No. 12
Remote Control - Make sure there are no objects between the remote control and its sensor. - Do not place the remote control near a heater or in damp place. 1 INPUT 12 POWER - Displays a menu of all available input sources. 13 CH-LIST - Also used to confirm your choice in the - Press to see the channel list on-screen menu. 14 AIR/CABLE 2 S.MODE - Press to select AIR/CABLE channels - Press to change to a preset sound mode 15 FAV 3 P.MODE - Watch your favorite channels - Press to change to a prese
Summary of the content on the page No. 13
Connecting an Antenna There are internal and external types of antennas. Rear of the TV Cable Television Network or Air Connecting an Antenna Caution Use a coaxial cable to connect the rear panel of the TV's [AIR] 1 ☛ lIf the signal is too weak to be received by or [CABLE] terminals and the wall mount or external antenna. the TV, purchase an additional wavelength amplifier for better reception. ☛ Setting up an UHF antenna will receive When an Air signal is required,
Summary of the content on the page No. 14
Connecting a VCR External devices may have different terminals for the same functions. VCR Rear of the TV Sound Cable Video Cable or S-Video Connector Useful Tips Connecting the video / sound cables ☛ If there is a terminal called [S-Video Output], connect the TV [S-Video Input] terminal to the 1 Connect the antenna cable to the Antenna input of the rear panel of the VCR. VCR [S-video output] terminal. Connect the sound cable to the [Video2 / S-Video Input Use the vid
Summary of the content on the page No. 15
Connecting an HDMI Connection Rear of the TV DVD (Home Theater) HDMI Connector What is HDMI ? Connecting via HDMI ☛ HDMI ( (H Hi ig gh h- -D De ef fi in ni it ti io on n M Mu ul lt ti im me ed di ia a I In nt te er rf fa ac ce e) ) : : A next generation interface that connects the 1 Connect the [HDMI/DVI input] terminal at the back of the TV and the digital audio and video signals using only one [HDMI] terminal of the external device. cable without compression. The soun
Summary of the content on the page No. 16
Connecting a PC PC Rear of the TV PC Sound Cable PC Cable Useful Tips Connecting a PC ☛ Audio output is only available for PCs with a sound output terminal 1 Connect the [PC input] and the PC monitor output using a PC video cable. Connect the [PC sound input] and the PC audio output using a PC sound 2 cable. After this is completed, turn on the power of the TV and the PC. 3 Watching a PC screen on a TV Turn on the PC and check if your PC settings are correct. 1 PC ■ If they are not cor
Summary of the content on the page No. 17
Automatic Channel Settings Any receivable channels can be memorized automatically. Press [MENU]. -The menu will appear. 1 Press [ ] and move to , then press [OK]. 2 -The menu will appear. Press [ ] and move to , then Press [OK]. 3 -The menu will appear. Press [ ] to move to the type of Antenna connection, and press [OK]. 4 -The menu will appear. Press [ ] to check the status, then press [OK]. 5 -The men
Summary of the content on the page No. 18
Antenna Settings Press [MENU]. -The menu will appear. 1 Press [ ] and move to , then press [OK]. 2 -The menu will appear. Press [ ] to move to , then press [OK]. 3 -The menu will appear. Press [ ] to select Air or Cable. 4 Press [EXIT] to exit the menu. 5 Useful Tips ☛ A An n a ai ir r s si ig gn na al l i is s t tr ra an ns sm mi it tt te ed d v vi ia a V VH HF F/ /U UH HF F o ov ve er r t th he e a ai ir r. . A An na al lo og g i is s N NT T
Summary of the content on the page No. 19
Adding favorite channels This function is to help users to select their favorite channels as quickly as possible. Press [FAV]. Go to Menu-Favorite channels and press the [FAV] button to check your favorite channels in the list. Adding a channel to the favorite channel list Press [MENU]. -The menu will appear. 1 Press [ ] and move to , then press [OK]. 2 -The menu will appear. Press [ ] to move to , then press the [OK] button. 3 -The menu will be
Summary of the content on the page No. 20
Current Program Information You can check the current time and channel information. (This is only available for digital broadcasts) Press [GUIDE]. Press [GUIDE] to view the program guide for the current channel. The default for the basic broadcasting guide should be set to . (The Program Guide may change without notice by the broadcast station.) Press [GUIDE]. 1 -The Current Guide will appear. Press [ ] to move to , then press [OK]. 2 -The menu will disappear and i
