Summary of the content on the page No. 1
INTEGRATED DIGITAL HD READY COLOUR TELEVISIONS
42WLU530HID
Operating Instructions
Summary of the content on the page No. 2
TABLE OF CONTENTS 1.Important Information ...............................................................1 1.1-Cleaning the screen and cabinet... .......................................................1 1.2-Disposing of your TV at the end of service life... ...................................1 1.3-Superior features of your integrated digital television ............................1 1.4-Receiving digital broadcasting channels ...............................................1 1.5-Changing the plug.
Summary of the content on the page No. 3
Important Information 1 LCD panels are produced with state-of-the-art technology. However, there may be missing or lit spots on the screen under certain circumstances. That does not mean that the product is faulty. 1.1-Cleaning the screen and cabinet... After powering off, wipe the screen and the cabinet clean with a soft and dry cloth. We recommend that you do not use patented polishes or solvents on the screen or cabinet since they may cause damage. 1.2-Disposing of your TV at the end of
Summary of the content on the page No. 4
1.5-Changing the plug The supplied mains cable already has a mains plug fitted, however should you need to replace it at any time please refer to the appropriatte wiring information below for your particular cable. As the colours in the mains lead of this IMPORTANT appliance may not correspond with the coloured markings identifying the The wires in the mains lead are coloured terminals in your plug, proceed in accordance with the following code: as follows: Blue - Neutral The wire which is col
Summary of the content on the page No. 5
2 Features of your new television Thank you for buying this television which is designed to give you many years of satisfactory service. You may already be familiar with using a television but do please take time to read these instructions. They are designed to familiarise you with the tv’s many new features and to ensure you get the vary best out of your purchase. 2.1-Special Features • Compatible with cable broadcasts • Wide angle of vision • PIP (Picture in Picture) from AV • Scart socket
Summary of the content on the page No. 6
3 Important Safety Instructions This symbol is used to warn the user about the “dangerous voltage” contained inside the TV that may create a risk of electrical shock. This symbol is used to remind the user important usage and service instructions supplied with the TV. 1) Please READ the operating • Never install the TV into closed places instructions before using such as bookcases or cabinets unless MANUAL the TV for the first time. adequate ventilation is provided. 2) Please observe the
Summary of the content on the page No. 7
10) Never operate your Note: Do not use defective sockets. Make TV close to water. sure that the plug is firmly inserted into Operating your TV, the socket. If the plug remains loose, for example, near a then it can cause fire due to arcing. Refer bathtub, washbasin, to an electrician to have your socket wet basement and swimming pool can replaced. cause fire or electric shock. 13) Make sure that the mains • Do not allow your TV lead is not stepped on and to get wet. Never pour that there
Summary of the content on the page No. 8
18) Wipe the TV cabinet Note 1: This is a Class A product. clean with a soft and dry During operation, the TV can cause radio cloth. Wipe dust from the interference. In this case the user may screen gently with a soft have to remedy this. Please contact your cloth. Stubborn stains specialist dealer. can be cleaned with a cloth slightly moistened Note 2: Electromagnetic fields can cause with soap and lukewarm water. Never temporary performance degradation. This use solvents such as thinner
Summary of the content on the page No. 9
4 Start Remove your television carefully from its Note1:Your TV does not have a seperate box. You can keep the packaging of your on/off switch, therefore to switch the power television to use in future. completely off (i.e. not on standby), switch off or unplug the TV at the mains Items supplied with your television: socket. Instruction Manual Note2: Your TV is equipped to Mains lead operate with TV buttons in case Remote control your R/C is broken or the batteries 2 Batteries are exhau
Summary of the content on the page No. 10
5 Your new television 5.1-TV Control Panel Program Down/Up button or Volume Level Down/Up button or or or Stand by indicator Menu button / Source selection button Bright light: TV is in Stand-by or or Dimmed light: TV is On On-Off / Standby button No light: Power Cable is not connected. 5.2-Rear and Side External Connections or 11-Component video input (Pr) 1-Power input 12-Component audio input (L) 2-AV1 scart 13-Component audio input (R) 3-AV2 scart 14-SPDIF Digital audio output 4-Aerial inp
Summary of the content on the page No. 11
5.3-Remote Control Stand-by mode On/Off button Temporary sound mute (Mute) button AV modes selection menu button Picture Format selection button PAT (Picture and Teletext) Mode ZOOM mode selection button Subtitle selection button (D) Sound selection button (D) Numeric buttons Favorite channel selection button (D) Page Stop button in Txt mode (Hold) EPG selection button (D) Question/Answer button in Txt mode (Reveal) Information button Index page button in Txt mode MENU button Exit menu button Re
Summary of the content on the page No. 12
6 Performing the initial power-on settings 6.1.4-Performing the Volume setting 6.1-TV controls You can adjust the volume of your 6.1.1-Temporary on/off (STAND-BY) television by using the VOL+/VOL- buttons on your remote control. When you press the red STAND- BY button located on the upper left hand side of your remote control 6.1.5-Temporary sound mute (MUTE) while your television is switched To temporarily mute the sound of on, the sound and the picture will your television, press the MU
Summary of the content on the page No. 13
SETUP 6.2-Turning on the TV and AUTO TUNING Setting the Channels MANUAL TUNING FIRST TIME INSTALLATION When you turn on your television for the first time, FIRST TIME INSTALLATION CHECK AERIAL CABLE IS CONNECTED. PRESS OK KEY TO CONTINUE message is displayed. If the aerial connections are SELECT MENU BACK correct, press OK button to continue. COUNTRY SELECTION menu will be Select AUTO TUNING tab and displayed. Select the country by using confirm by pressing the OK button. Up/Down, Lef
Summary of the content on the page No. 14
Add Channels : With this option, the new 6.3.2-Manual tuning of channels and channels in the frequency which is desired to storing in the memory be manually searched will be scanned and In digital mode: Press MENU added to the existing channel list. button, MAIN MENU will be Replace Channels : With this option, you displayed. Select SETUP tab with can update the existing channel list with the Down movement button and modifications made by the broadcaster. confirm with the OK button. SE
Summary of the content on the page No. 15
Note: You can also access the Favourite 6.3.3.1-Displaying Television and Lists menu from the scroll down menu of Radio channel lists and selecting Digital Features menu. the channels 6.3.4-Electronic TV Guide (EPG) When the program table menu is opened, all TV and radio channels If it is supported by the broadcaster, the stored in the list are displayed. electronic TV guide gives information about You can navigate between the the programs of the next 8 days (for digital channels wit
Summary of the content on the page No. 16
6.3.5-Digital Features Access Control Lock/Unlock Channels To enter digital features menu, select Change PIN FEATURES tab from the main menu by using Up/Down movement buttons. Select DIGITAL FEATURES tab from FEATURES menu by using Up/Down movement buttons and press OK button to confirm. DIGITAL FEATURES menu will be Select Back displayed. Digital Features Lock/Unlock Channels: Select Lock/ Language Settings Access Control Unlock Channels tabs from Access User Interface Options Control me
Summary of the content on the page No. 17
Analogue mode. Press the MENU button on 6.3.5.5-Favourite Lists your remote control. Select SETUP tab with Please see 6.3.3.2-Creating favorite channel Down movement button and confirm with list for detailed explanation of this feature. OK button. Setup menu is displayed. Select PROGRAM NO tab by pressing 6.3.5.6-Common Interface Module the Up/Down movement buttons in Setup To receive subscrıption channels you will menu, enter the channel number to be need to purchase a conditional acces
Summary of the content on the page No. 18
6.4.2-Manual tuning of channels and 6.4.2.2-If you do not know the storing in the memory channel number 6.4.2.1-If you already know the Press the MENU button. Move channel number (See page 31) to the SETUP menu by pressing the Down movement button in Press the MENU button. Move to the the Main Menu and confirm your SETUP menu by pressing the Down selection with the OK button. movement button in the Main Menu and Setup menu will be displayed. Select the system in which you SETUP woul
Summary of the content on the page No. 19
after this program number. After setting is 6.4.4-Program Table complete, press the EXIT button to exit the Press the MENU button. Move to the menu. PROGRAM TABLE tab by pressing the 6.4.4.3-Skipping a stored channel Down movement button in Main Menu and confirm your selection with the OK button. In the event that you do not wish Program Table menu will be displayed. to see certain programs while navigating through the channels using the PR+/PR- buttons, PROGRAM TABLE then you can use th
Summary of the content on the page No. 20
7 Settings of Your New Television sound of the program. Options in the SRS 7.1- Sound Menu Settings menu become active when the SRS function is selected. You may perform volume settings Note: SRS menu will not be active if the by using the VOL+ or VOL- SRS is not selected from the Sound mode buttons on your television or the tab. VOL+/VOL- buttons on your remote control. You can perform 7.1.4-AVL (Automatic Volume other Sound settings by entering Limiting) the Sound menu. For this, p
