Toyota KIT #250-4221 user manual

Summary of the content on the page No. 1

;!T~i!;;;~;:;
:!:i::!!!!
KIT #250-4221
I. Route Cable Assembly through vehicle's grommet on
Driver's side next to Brake Booster into passenger
compartment above ductwork so that a smooth curve is
made and it does not interfere with any moving parts.
2. Remove (2) M6 Bolts securing pedal assembly. Install
Bracket-Cable using (2) M6 Bolts previously
loosened.
3. Remove the Snap-In Adaptor from Cruise Control
Kit.
4. Remove the Adjustable Sleeve from the Cruise
Control Module Cable and discard.
5.

Summary of the content on the page No. 2

7116" BOX END WRENCH NUT & WASHER CRUISE CONTROL ASSEMBLY 1/4" .20 MODULE CABLE FIGURE 3 7. To use the Snap-In Adaptor, it will be necessary to fonn threads on the end of the Cruise Control Module Cable. This is accomplished by placin.g the 1/4" -20 Nut and Washer Assembly on the end of the Cruise Control Module Cable with your fingers, then use a 7/16" box end wrench and turn clockwise, until the desired amount of threads have been fonned as shown in Figure 3. . 8. After the threads have been f