Summary of the content on the page No. 1
JE4208
42” LCD TV User's Guide
Please observe all safety precautions when using this product.
Please read this manual carefully before using this product.
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Safety Precautions Power Supply Warnings Do not plug several Do not use a damaged Insert the power plug Do not touch the power devices into the same power cord or plug or a fully into the outlet. plug with wet hands. outlet. loose outlet. A loose or improperly Doing so may result in Doing so may cause Doing so may result in inserted power plug electric shock. the outlet to overheat fire or electric shock. may result in fire. and start a fire. Be sure to ground the unit. Do not bend the power cor
Summary of the content on the page No. 4
Installation Warnings Do not place the unit on an Do not place containers with Do not place the unit where it Do not use or store flamm unstable surface, such as a liquids such as flower vases, is exposed to rain, excessive able or combustible materials wobbly stand or sloped table, or soft drink cans, or medicine moisture or grease. near the unit. on any surface whose area is bottles or small metallic objects smaller than the bottom area of on top of the unit. Doing so may result in fire the un
Summary of the content on the page No. 5
Safety Precautions Use and Maintenance Warnings Disconnect the power Do not allow children to Never disassemble or modify Do not insert any metal the unit in any way. Do not cord from the wall outlet climb or hang on the unit. objects, such as a screwdriver, attempt to service the unit during an electrical storm. paper clip, or bent wire into yourself. the ventilation openings or The unit could topple Not doing so may result A/V terminals. over onto a child and Doing so may result in fire in f
Summary of the content on the page No. 6
Safety Precautions Important Safety Instructions Warnings and Precautions To prevent any injuries, the following safety precautions should be observed in the installation, use, servicing and maintenance of this equipment. Before operating this equipment, please read this manual completely, and keep it nearby for future reference. 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with a
Summary of the content on the page No. 7
Safety Precautions Important Safety Instructions 13) Unplug this apparatus during lightning storms or when unused for long periods of time. 14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. • Apparatus shall n
Summary of the content on the page No. 8
Safety Precautions Important Safety Instructions WARNING TO PREVENT DAMAGE WHICH MAY RESULT IN FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Caution : - These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. - Any changes or modifications not expressly approved by the party respons
Summary of the content on the page No. 9
User Guidance Information Names of each part Front View 1 2 3 4 5 Channel/Program + , - Button Source Button - Input Source Select Button Menu Button - OSD Menu Display Button Power Button Volume + , - Button Accessories The configuration of the components may look different from the following illustration. -/-- User's Guide DTV EPG MTS CC V-CHIP SCALE Power Cord AV Cable Battery 1.5V( AAA 2) User's Guide Remote Control 9
Summary of the content on the page No. 10
User Guidance Information Names of each part Back View 4 1 HDMI jack AV1 AUDIO(L/R) and VIDEO jacks RF jack 7 PC and AUDIO jack 5 AV2 AUDIO(L/R) and VIDEO jacks 2 POWER ON/ OFF jack 8 Y, Pb, Pr jack 9 3 6 S - VIDEO jack AC input jack 10 AUDIO(L/R) output jacks Power on To turn on the LCD TV Press on the back of the LCD TV to first. Power off Be sure to turn off the power and unplug both units from the wall outlet before making any connections. 10
Summary of the content on the page No. 11
User Guidance Information Mounting on a Desktop Your LCD TV can be mounted on a Desktop as shown in the figure above. This is not floor-standing unit. Installation Precautions Wall Mounting Please secure enough space for safe use. (Please refer to A and B.) Installation of the LCD TV in an improperly ventilated location can cause a fire or damage to the LCD TV due to increased temperature. 4 inch A 4 inch 4 inch (Mounting on a wall) 2.67 inch Contact your dealer to purchase the "Adjustable-angle
Summary of the content on the page No. 12
User Guidance Information Installing an Antenna For connecting to ATSC or NTSC broadcasts Wall Jack with F-Connector RF Coaxial (Round) Antenna Cable Analog+Digital 75 Ω external Antenna Press SOURCE button on the remote control to select TV, then press RIGHT button to confirm. Then you can receive the ATSC/NTSC signal. 12
Summary of the content on the page No. 13
Summary of the content on the page No. 14
User Guidance Information Remote Control -/-- MTS Press MTS to select Stereo, EPG SAP or Mono. Press EPG to display the Note: This button can only be program guide. used under NTSC mode. DTV V-CHIP DTV EPG MTS Press DTV to display the Press V-CHIP to choice the rating DTV(ATSC) OSD menu during DTV(ATSC) mode. CC V-CHIP SCALE SCALE CC Cycles among scale mode: Close Caption 16:9, ZOOM1, ZOOM2, 4:3, PANORAMA. 14
Summary of the content on the page No. 15
User Guidance Information Precautions Avoiding Remote Control Problems 1. Check the polarity (+,-) of the batteries in the remote control. 2. Check that the batteries have power. 3. Check that the LCD TV is powered and that it is properly plugged in. 4. Check if any three-wavelength lamp, special fluorescent or neon sign is turned on near the LCD TV. Inserting Batteries in the Remote Control 1. Open the cover completely. 2. Insert the two supplied batteries (AAA, 1.5V). Ensure that the polariti
Summary of the content on the page No. 16
Connection VCR Connections Connecting to the Composite terminal Connection terminals of other equipments differ by manufacturer and model. < VIDEO > (R) (L) Composite Cable Connect the LCD TV's Composite In terminal to the VCR's Composite Out terminal using the Composite cable. (Make sure the color of the terminals and the color of the cable are the same) Connecting to the S-Video terminal < VIDEO > (R) (L) S-Video Cable Use the S-Video cable for higher picture quality. Watching Video Tape SOURC
Summary of the content on the page No. 17
Connection Satellite/ Cable TV Set-Top Box Connections Connecting to the Composite terminal In order to watch Cable TV, Subscribe to your local Cable TV company and install a separate receiver(Set-Top-Box) Connection terminals of other equipments differ by manufacturer and model. < Cable broadcasting receiver > (R) (L) Composite Cable Connect the LCD TV's Composite In terminal to the cable broadcasting receiver Composite Out terminal using the Composite cable. (Make sure the color of the termin
Summary of the content on the page No. 18
Connection DVD Connections Connecting to the component terminal Connection terminals of other equipments differ by manufacturer and model. < DVD > Y Pb Pr (R) (L) Component Audio cable Component connection cable 1. Connect LCD TV's Y, Pb, Pr terminal to DVD's Video Out terminal using the external cable. 2. Connect LCD TV's Audio terminals (left & right) in AV 1 to DVD's Audio Out terminal using the Audio cable. 3. It must match the component connection cable Y, Pb, Pr between the LCD TV and DVD
Summary of the content on the page No. 19
Audio Amplifier Connections
Summary of the content on the page No. 20
Basic Use Powering the LCD TV Power on/ off Press on the back of the LCD TV to first. To turn the LCD TV on : Press the "POWER" button. To turn the LCD TV off : Press "POWER" button on the LCD TV. To turn on/off by remote control : Press the “POWER” button of remote control. Selecting Input Source You can select between the TV signal and the input signal of other equipments connected to the TV. Use this function to switch to the input source you wish to view. SOURC
