Summary of the content on the page No. 1
4-187-903-11(1)
Setting Up
LCD
Watching TV
Digital Colour TV
Additional Information
Operating Instructions
KDL-60LX903 / 40LX903
Summary of the content on the page No. 2
Notes on Digital TV function NOTICE FOR • Any functions related to Digital TV ( ) will only work in countries or CUSTOMERS IN areas where DVB-T (MPEG-2 and H.264/MPEG-4 AVC) digital terrestrial THE UNITED signals are broadcast or where you have access to a compatible DVB-C (MPEG- KINGDOM 2 and H.264/MPEG-4 AVC) cable service. Please confirm with your local A moulded plug complying with BS1363 is dealer if you can receive a DVB-T signal fitted to this equipment for your safety and wh
Summary of the content on the page No. 3
Table of Contents Checking the accessories ..............................................................................................................3 Inserting batteries into the remote .................................................................................................3 Setting Up Attaching the Table-Top Stand (except KDL-60LX903).................................................................4 Connecting an antenna (aerial)/Set Top Box/recorder (e.g. DVD recorder)...........
Summary of the content on the page No. 4
Setting Up Adjusting the viewing angle of Attaching the Table-Top the TV (except KDL-60LX903) Stand (except KDL- This TV can be adjusted within the angles 60LX903) shown below. 1 Refer to the supplied Table-Top Stand leaflet for proper attachment for some 0º 6º TV models. 2 Place the TV set on the Table-Top Stand. 3 Fix the TV to the Table-Top Stand according to the arrow marks that guide the screw holes using the 1 4 supplied screws. Remove screw as Install screw into shown. the top
Summary of the content on the page No. 5
Setting Up � Ensure that there are no objects in front of the TV. IR Sensor Connecting an antenna (aerial)/Set Top Box/ recorder (e.g. DVD recorder) Connecting a Set Top Box/recorder 3D Sync Transmitter (e.g. DVD recorder) with SCART Intelligent Presence Sensor � Do not expose the Intelligent Presence Sensor to direct sunlight or other strong light, as malfunction may occur. Set Top Box/recorder (e.g. DVD recorder) ~ � Right Angle Type Universal SCART Lead is recommended for this connection
Summary of the content on the page No. 6
~ 3 Tie the wood screw and the machine � For KDL-40LX903, after connecting cables, screw with a strong cord (not supplied). install the bottom cover and stand rear cover. Detaching the terminal cover Bundling the cables ~ � A cable holder is available for KDL-40LX903. To bundle the cables, follow steps 3 to 5. ~ � After connecting cables, re-attach the terminal cover to the TV. Preventing the TV from toppling over ~ � Do not bundle the AC power cord (mains lead) together with other cables.
Summary of the content on the page No. 7
Setting Up Programme Sorting: Changes the order of Performing the initial set-up analogue channels stored in the TV. 1 Press F/f to select the channel you want to move to a new position, then press . 2 Press F/f to select the new position for the channel, then press . ~ � You can also tune channels manually. 1 Connect the TV to your AC power Detaching the Table-Top outlet (mains socket). Stand from the TV 2 Check the ENERGY SAVING ~ SWITCH setting is on (z). � Remove the stand rear cover a
Summary of the content on the page No. 8
Watching TV To watch programmes Turn on the TV. 1 1 Switch ENERGY SAVING SWITCH 2 on (z). 2 Press 1 on the TV to turn on the TV. GUIDE Select a mode. 2 OPTIONS HOME Select a TV channel. 3 3 Using Digital Electronic Programme Guide Press GUIDE in digital mode to display the programme guide. z � The number 5, N, PROG + and AUDIO buttons on the remote have a tactile dot. Use the tactile dots as a reference when operating the TV. To utilise the TV’s features HOME button OPTIONS button Press to
Summary of the content on the page No. 9
Watching TV To use i-Manual Operating instructions are built into your BRAVIA TV and can be displayed on the screen. To learn more about your TVs features you can access your i-Manual with the touch of a button. Press i-MANUAL. 1 1 Press G/g/F/f/ to select items. 2 2 x Welcome to i-Manual x Fun Features with Connected Equipment x “BRAVIA” TV Features Introduces how to connect optional equipment. x Watching TV x Parts Description Introduces convenient features such as EPG Guide, Favourites, e
Summary of the content on the page No. 10
To use 3D Glasses Before use: Remove the battery’s insulating sheet before using the product for the first time. Parts and components Pouch (2) 3D Glasses (2) 1 Slide switch 4 IR sensor Set the switch for a comfortable fit. Set Receive signals from the 3D Sync both the switches on either side for a Transmitter. comfortable fit. Close the temple frames This part receives IR slightly inwards to set the switch. (infrared rays) from the 3D Sync Transmitter. Increases the width of the glasses IR
Summary of the content on the page No. 11
Watching TV Replacing the battery If the LED indicates low battery power, replace the battery. Use a CR2032 battery. Open the battery cover. Push here Battery and remove (CR2032) the battery at an angle. Coin, etc. * Align the � mark and the � ( ) mark. ~ � When opening or closing the battery cover, make sure the coin, etc., is properly inserted in the groove of the battery cover. Precautions for use � The 3D Glasses are operated by receiving infrared rays from the 3D Sync Transmitter. Mis-op
Summary of the content on the page No. 12
Additional Information Troubleshooting Check whether the 1 (standby) indicator is flashing in red. When the 1 (standby) indicator is flashing The self-diagnosis function is activated. 1 Count how many times the 1 (standby) indicator flashes between each three second break. For example, the indicator may flash three times, go off for three seconds, then flash again three times. 2 Press 1 on the TV to turn it off, disconnect the AC power cord (mains lead), and inform your dealer or Sony servic
Summary of the content on the page No. 13
Additional Information Specifications System Panel system LCD (Liquid Crystal Display) Panel TV system Analogue: Depending on your country/area selection: B/G/H, D/K, L, I Digital: DVB-T2/DVB-T/DVB-C Analogue: PAL, PAL60 (only video input), SECAM, NTSC3.58, NTSC4.43 (only video input) Colour/video system Digital: MPEG-2 MP@ML/HL, H.264/MPEG-4 AVC MP/HP@L4 Analogue: VHF: E2–E12/UHF: E21–E69/CATV: S1–S20/HYPER: S21–S41 Channel coverage D/K: R1–R12, R21–R69/L: F2–F10, B–Q, F21–F69/I: UHF B21–B69 Di
Summary of the content on the page No. 14
Model name KDL- 60LX903 40LX903 Wall-Mount Bracket: SU-WL500 (KDL-60LX903) Optional accessories SU-WL700 (KDL-40LX903) Wall-Hanging Bracket: SU-WH500 3D Glasses: TDG-BR100 TDG-BR50 1 * Specified standby power is reached after the TV finishes necessary internal processes. 2 * 4 hours a days and 365 days a year ~ � To save power consumption – when you reduce backlight setting (the brightness of the screen), the power consumption reduce. – the “Eco” settings (e.g. “Power Saving”, “Idle TV Standby”)
Summary of the content on the page No. 15
Additional Information Installing the Accessories (Wall-Mount Bracket) To Customers: For product protection and safety reasons, Sony strongly recommends that installing of your TV be performed by Sony dealers or licensed contractors. Do not attempt to install it yourself. To Sony Dealers and Contractors: Provide full attention to safety during the installation, periodic maintenance and examination of this product. Your TV can be installed using the SU-WL500 (KDL-60LX903 only), or SU-WL700 (exc
Summary of the content on the page No. 16
TV installation dimensions table Screen centre point Unit: cm Length for each mounting angle Display Screen centre Model Name dimensions dimension Angle (0 °) Angle (20 °) KDL- AB C DE FGH 60LX903 144.0 90.6 3.1 50.3 12.1 38.6 85.0 52.1 Figures in the above table may differ slightly depending on the installation. WARNING The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of the TV. Refer to “Specifications” (page 13) for its weight. G
Summary of the content on the page No. 17
Additional Information Screw and Hook locations diagram/table Model Name Screw location Hook location KDL-60LX903 e, j a Screw location Hook location When installing the Mounting Hook on the When installing the TV onto the Base Bracket. TV. a b* c* * Hook location “b” and “c” cannot be used for the models. (Continued) GB 17
Summary of the content on the page No. 18
SU-WL700 (except KDL- 60LX903) Installing on a wall Precautions Be sure to install the Wall-Mount Bracket securely to the wall following the instructions in this as well ~ as the manual provided with the Wall-Mount � Do not attach the bottom cover and terminal Bracket. The numbers given in the parentheses cover. indicate the installation steps described in the 6 Place the Spacers. instruction manual provided with Wall-Mount Bracket. 1 Remove the four screws, and be sure to store them in a
Summary of the content on the page No. 19
Additional Information TV installation dimensions table Screen centre point Unit: cm Display Screen centre Length for each mounting angle Model Name dimensions dimension Angle (0 °) Angle (20 °) KDL- AB C DE FG H 99.4 65.2 8.9 43.4 7.5 33.8 61.0 49.5 40LX903 Figures in the above table may differ slightly depending on the installation. WARNING The wall that the TV will be installed on should be capable of supporting a weight of at least four times that of the TV. Refer to “Specifications” (page
Summary of the content on the page No. 20
� It is strongly recommended that you use � Do not use the supplied mains lead on a Sony wall-mount bracket in order to any other equipment. Safety provide adequate air-circulation. � Do not pinch, bend, or twist the mains lead excessively. The core conductors Installed on the wall may be exposed or broken. Information 30 cm � Do not modify the mains lead. � Do not put anything heavy on the mains lead. Installation/Set-up 10 cm 10 cm � Do not pull on the mains lead itself when Install and u
