Summary of the content on the page No. 1
Muratec MFX-2530
Operating Instructions
Summary of the content on the page No. 2
Find your serial number and write it down Please note that your machine’s serial num- ber is located on the bar code label as shown on the drawing at right. Use the blank at Bar code label the bottom of this column to copy this down for scanner before you set up your machine. Bar code label for printer Note: The IC label and ID label do not con- tain serial number information. Close up, the bar code label looks something like this, but with a different set of numbers: Please copy down your machi
Summary of the content on the page No. 3
Welcome …
Summary of the content on the page No. 4
Trademarks Muratec, the Muratec logo and all Muratec product names contained herein are trademarks of Muratec America, Inc. ENERGY STAR is a registered mark of the United States Environmental Protection Agency. Copyright Copyright © 2001 by Muratec America, Inc, All rights reserved. ® As an ENERGY STAR partner, Muratec America, Inc., has deter- ® mined that this product meets the ENERGY STAR guidelines for energy efficiency. Energy saving Your machine can save the energy with its Energy Saving M
Summary of the content on the page No. 5
Regulatory information If problems arise United States of America If any of your telephone equipment is not operating properly, you should immediately remote it from your telephone line, as it may cause harm to the telephone network. If the telephone company notes a problem, they may temporarily Federal Communications Commission (FCC) information stop service. When practical, they will notify you before this disconnection. If advance notice is not feasible, you will be Ringer Equivalence Number
Summary of the content on the page No. 6
Limited warranty This warranty is made by Muratec America, Inc. (hereafter referred to as “Muratec”). This warranty is EXCEPT AS EXPRESSLY SET FORTH ABOVE, AND EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, MURATEC valid only on Muratec products purchased and used in the United States of America. This warranty MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES applies to the product only while owned and used by the original purchaser (“Custom
Summary of the content on the page No. 7
Safety information Laser Safety For the United States This is a digital machine which operates by means of a laser. There is no possibility CDRH regulation of danger from the laser, provided the machine is operated according to the instruc- tions in this manual. This machine is certified as a Class 1 Laser product under the Radiation Since radiation emitted by the laser is completely confined within protective hous- Performance Standard according to the Food, Drug and Cosmetic Act of 1990. ing,
Summary of the content on the page No. 8
Before using your Muratec machine Clean Where to set up your machine Dust buildup can damage your machine. Follow these guidelines when setting up your machine: Periodically clean your machine as described in the operating instructions. Do not use a dust cover, which can cause damaging overheating. Away from direct sunlight To avoid overheating, set up your machine away from direct sunlight or a heater. Near a phone jack Your machine uses a standard (modular) telephone jack, also known as an RJ-
Summary of the content on the page No. 9
Power requirements General Precautions Plug in the power cord Never disassemble your machine! Plug the power cord carefully and completely into a Disassembling your machine can cause serious wall outlet. Do not leave any portion of the electrical injury to you and damage to your machine. If service cord’s metal plugs exposed. Doing so could cause a is required, call your authorized Muratec dealer. fire and poses a risk of electrical shock. Do not share an extension cord Keep away from liquids co
Summary of the content on the page No. 10
Do not put furniture or equipment on Storing and handling toner bottle the power cord To avoid damage to your machine and to assure the best performance possible, fol- Do not put anything on or over the electrical power low these guidelines when storing and handling toner bottles: cord, and do not route the power cord under rugs or carpets. Doing so can damage the power cord or fax, and can cause fire or electrical shock. Store the toner bottle Store toner bottles at a constant temperature withi
Summary of the content on the page No. 11
Introduction Thank you for choosing the Muratec MFX-2530. Symbol and terms (Operating tips) The Muratec MFX-2530 is a multi-function machine, combining fac- In this manual, the following symbols and terms are used, please make sure you simile and copier features. know what they mean. These instructions are divided into the following sections. CAUTION This symbol indicates how to avoid personal injury. Important: This describes conditions or incorrect operations that could cause “Getting starte
Summary of the content on the page No. 12
About and symbol and symbols indicate the direction of your document. When the document has a length longer than its width, we use symbol . When the document has a length shorter than its width, we use symbol . viii
Summary of the content on the page No. 13
Table of contents Regulatory information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i Language settings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.17 Limited warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .ii Getting started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.17 Laser Safety . . . . . . . . . . .
Summary of the content on the page No. 14
Last copy job . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.17 Advanced fax features Mixed length copy . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.18 Autodialer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.11 Duplexed copies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2.19 Using one-touch
Summary of the content on the page No. 15
Programming regular polling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.56 J. Printing of the machine setting list . . . . . . . . . . . . . . . . . . . . . . . . . .4.10 Programming a batch transmission . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.57 K. Settings for printer controller (Option) . . . . . . . . . . . . . . . . . . . . . . .4.10 Programming an F-Code transmission . . . . . . . . . . . . . . . . . . . . . . . . . .3.57 L. Print the list of do
Summary of the content on the page No. 16
Getting started Parts of the machine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.1 Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.4 Panel display (Liquid Crystal Display) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.6 Power On . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 17
Getting started Parts of the machine Note: Any terms used here that are unclear to you right now will be explained in Side cover — Open this to fix printout jams in the cassette. detail in the coming pages. 5 Bypass tray — Use this when you want to copy onto transparency film, 14 6 13 12 thick paper, envelopes or post cards. 15 16 Printer cover release (R1) — Pull up this to open the printer cover. 11 7 17 Printer cover — Open this to fix printout jams or change the drum cartridge. 8 1 10 Fuser
Summary of the content on the page No. 18
Getting started ETHERNET jack — Where you plug in the network cable, when you use the 27 optional network printer controller. AC power jack — Where you plug in the AC power cord. 29 28 Paper tray — Where the received fax message or copied paper emerges. 29 19 28 20 21 27 22 23 24 25 26 Toner bottle cover — Open this to change the toner bottle. 19 RS-232C interface port — Where you plug in the RS-232C cable, when you 20 use the optional RS-232C interface kit. LINE / PHONE jack for option — Where
Summary of the content on the page No. 19
Getting started Options 3 Paper cassette (3rd, 4th, 5th) — Each cassette capacity is 550 sheets. 1 4 Large capacity cassette — Its capacity is 2,700 sheets. 2 Handset — Used for voice communication. 3 Shift tray — Shifts and sorts printed papers in sort copy. 4 5 6 2-Bin tray — Sorts copied papers and received fax messages. 5 Duplex unit — Used for duplex copy, booklet copy or duplex reception. 6 10 Printer controller and TWAIN driver — Adds the PC printer feature and 7 the scanner feature to yo
Summary of the content on the page No. 20
Getting started Control panel 3 45678910 12 11 2 1 23 22 21 20 19 18 17 16 15 14 13 COMMUNICATION light — Glows when the fax machine is communicating with CONTRAST — Press to adjust the contrast level. 1 another machine. MEMORY RECEIVE light — Glows when the machine is receiving an incoming RESOLUTION — 2 fax document into its electronic memory. In Fax mode: RESOLUTION Numeric keypad — Just like the numeric keys on a regular tone-dialing Press to toggle among the three resolution modes and 256-
