Metra Electronics 95-7418 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS FOR PART 95-7418
APPLICATIONS
2002-2004 Nissan Altima
95-7418
KIT FEATURES
• DDIN Head Unit Provision
• STACKED ISO DIN Head Unit Provision
KIT COMPONENTS
A) Trim Plate
A
TOOLS REQUIRED:
Flat Blade Screwdriver I Phillips Screwdriver
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2004 METRA ELECTRONICS CORPORATION

Summary of the content on the page No. 2

95-7418 TABLE OF CONTENTS Dash Disassembly ............................................................................ 1 Kit Assembly ................................................................................. 2-3 Final Assembly ................................................................................. 4

Summary of the content on the page No. 3

DASH DISASSEMBLY 95-7418 2002-2004 NISSAN ALTIMA 1 Disconnect the negative battery terminal to prevent an accidental A short circuit. 2 Unclip and remove the trim panel surrounding the climate controls. (Figure A) 3 Remove (1) Phillips screw (bottom right side of panel) securing the panel surrounding the radio then unclip and remove the panel. (Figure B,C) 4 Remove (4) Phillips screws securing radio to remove. (Figure D) B 5 Remove the screws securing the factory brackets to the radio and remov

Summary of the content on the page No. 4

KIT ASSEMBLY 95-7418 DOUBLE DIN HEAD UNIT PROVISION Snap the 95-7418 trim plate into the 1 radio trim panel. (Figure A) A Install from rear Slide the DDIN radio unit into the 2 factory brackets and secure the unit to the brackets using the screws supplied with the head unit. (Figure B) B 2

Summary of the content on the page No. 5

KIT ASSEMBLY 95-7418 STACKED ISO DIN HEAD UNIT PROVISION Snap the 95-7418 trim plate into the 1 radio trim panel. (Figure A) A Install from rear 2 Slide the stacked ISO DIN units into the factory brackets and secure the units to the brackets using the screws supplied with the head unit. (Figure B) B 3

Summary of the content on the page No. 6

FINAL ASSEMBLY 95-7418 FINAL ASSEMBLY Locate the factory wiring harness in the dash and make the connection as shown. 1 Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) Re-connect the negative battery terminal and test the unit for proper operation. 2 3 Reassemble radio and dash assemblies in reverse order of disassembly. FINAL WIRING CONNECTIONS Make wiring

Summary of the content on the page No. 7

95-7418 NOTES 5

Summary of the content on the page No. 8

95-7418 INSTRUCTIONS 1-800-221-0932 www.metraonline.com © COPYRIGHT 2004 METRA ELECTRONICS CORPORATION INST95-7418 REV. 09/06/07