Summary of the content on the page No. 1
INSTALLATION INSTRUCTIONS FOR PART 95-6511
APPLICATIONS
Chrysler
Aspen 2008-09/Sebring 2007-10
Town and Country 2008-10/300/300c 2008-10
Dodge
Avenger 2007-10/Caliber 2009-10/Challenger 2009-10
Charger 2008-10/Dakota 2008-10/Durango 2008-09
Grand Caravan 2008-10/Journey 2009-10*
Magnum 2008-09/ Nitro 2007-10/Ram 1500 2009-11/Ram 2500/3500 2010-11
Jeep
Compass 2009/Commander 2008-10/Grand Cherokee2008-10/Patriot 2009
Liberty 2008-10/Wrangler 2007-10*
*(Modifications to radio cavity required)
Mits
Summary of the content on the page No. 2
95-6511 TABLE OF CONTENTS Dash Disassembly - Chrysler Aspen 2008-2009/Dodge Durango 2008-2009 . . . . . . . . . . .. . . 1 - Chrysler Sebring 2007-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 2 - Chrysler Town and Country 2008-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . .3,4 - Chrysler 300/300C 2008-2010 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 - Dodge Avenger 2007-2010 . . . . . . . . . .. . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 3
1 2 3 4 5 6 4 1 2 3 5 6 95-6511 DASH DISASSEMBLY CHRYSLER ASPEN 2008-2009 DODGE DURANGO 2008-2009 A 1 Disconnect the negative battery ter- minal to prevent an accidental short POWER OUTLET circuit. 2 Unsnap and remove storage cup holder assembly. (Figure A) 3 Remove (2) screws from bottom edge of center dash trim panel. Unsnap and remove the panel. (Figure B) 4 Remove (4) screws securing the B radio. Unplug and remove radio. 12 (Figure C) 9 3 6 Continue to kit assembly. POWER OUTLET C 12 9 3 6
Summary of the content on the page No. 4
95-6511 DASH DISASSEMBLY CHRYSLER SEBRING 2007-2010 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip entire panel surrounding radio including a/c vents and clock. Unplug and remove panel. (Figure A) 3 Remove (4) 7MM screws securing radio. Unplug and remove radio. (Figure B) B Continue to kit assembly. 2
Summary of the content on the page No. 5
95-6511 DASH DISASSEMBLY CHRYSLER TOWN AND COUNTRY 2008-2010 DODGE GRAND CARAVAN 2008-2010 A Disconnect the negative battery ter- 1 minal to prevent an accidental short circuit. 2 Remove (2) screw covers facing up above radio then remove the (2) Phillips screws exposed. (Figure A) 3 Lift up on panel above radio then remove (2) Phillips screws exposed at front edge of radio trim panel. (Figure B) B 4 Remove (3) plastic push pins per side of bottom trim panel then slide panel toward rear of van to
Summary of the content on the page No. 6
95-6511 DASH DISASSEMBLY CHRYSLER TOWN AND COUNTRY 2008-2010 DODGE GRAND CARAVAN 2008-2010 D 5 Remove (2) Phillips screws exposed at bottom edge radio trim panel. (Figure D) 6 Unclip and remove entire panel sur- rounding radio including climate con- trols, vents and clock. (Figure E) 7 Remove (4) Phillips screws securing radio. (Figure F) Continue to kit assembly. E F U SEEK SEEK SCAN TIME INFO RW FF PUSH ON PUSH AUDIO/SELECT AM LIST MUSIC FM TYPE DISC SEL;ECT VOLUME TUNE/SCROLL AUX SET 12 3
Summary of the content on the page No. 7
1 2 3 4 5 6 95-6511 DASH DISASSEMBLY CHRYSLER 300/300C 2008-2010 DODGE MAGNUM 2008-09/CHARGER 2008-10 1 Disconnect the negative battery ter- A minal to prevent an accidental short circuit. 2 Unsnap and remove center dash trim panel. (Figure A) 5 1 2 3 4 6 3 Remove (4) screws securing the radio. Disconnect and remove the radio. (Figure B) Continue to kit assembly. B 5
Summary of the content on the page No. 8
95-6511 DASH DISASSEMBLY DODGE AVENGER 2007-2010 A Disconnect the negative battery ter- 1 minal to prevent an accidental short circuit. 2 Unclip and remove the center console trim panel. (Figure A) 3 Unclip the center dash trim panel. (Figure B) 4 Remove (4) screws securing the radio. Disconnect and remove the B radio. (Figure C) 5 Remove (3) screws securing the radio rear support bracket and remove the bracket. (Figure D) Continue to kit assembly. C D U SEEK SEEK SCAN TIME INFO RW FF PUSH ON PU
Summary of the content on the page No. 9
95-6511 DASH DISASSEMBLY DODGE DAKOTA 2008-2010 A Disconnect the negative battery ter- 1 minal to prevent an accidental short circuit. 2 Unclip and remove the trim panel surrounding the radio. (Figure A) 3 Remove (4) Phillips screws securing B the radio. (Figure B) U SEEK SEEK SCAN TIME INFO RW FF Continue to kit assembly. PUSH ON PUSH AUDIO/SELECT AM LIST MUSIC FM TYPE DISC SEL;ECT VOLUME TUNE/SCROLL AUX 3 5 SET 12 4 6 AUX MITSUBISHI RAIDER 2008-09 A 1 Disconnect the negative battery ter- m
Summary of the content on the page No. 10
95-6511 DASH DISASSEMBLY DODGE NITRO 2007-2010 JEEP LIBERTY 2008-2010 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip entire panel surrounding radio and climate controls, including a/c 5 6 3 4 1 2 vents. Unplug and remove panel. (Figure A) 3 Remove (4) 7MM screws securing radio. Unplug and remove radio. (Figure B) B Continue to kit assembly. 5 6 3 4 1 2 8
Summary of the content on the page No. 11
95-6511 DASH DISASSEMBLY DODGE JOURNEY 2009-10 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. OFF 2 Unclip and remove the entire factory radio trim panel including the a/c PUSH PUSH PUSH controls. (Figure A) PUSH ON PUSH AUDIO/SELECT AM LIST TIP: Open the compartment door at the MUSIC FM TYPE VOLUME DISC SEL;ECT TUNE/SCROLL AUX SET 12 3 4 5 6 AUX top of the radio trim panel. OUTLET POWER OUTLET 3 Remove (4) 7MM screws securing radio to dash to remove. (F
Summary of the content on the page No. 12
95-6511 DASH DISASSEMBLY JEEP COMMANDER/GRAND CHEROKEE 2008-2010 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unsnap and remove the small trim around the console shifer. (Figure A) 3 Unsnap and remove the larger trim around the console shifter. (Figure B) 4 Remove one Phillips screw from inside the small storage pocket in the B lower dash, between the power outl- lets. (Figure C) 5 Unsnap and remove the dash panel from around the radio (including cli-
Summary of the content on the page No. 13
95-6511 DASH DISASSEMBLY JEEP WRANGLER 2007-2010 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 1 2 3 4 5 6 2 Unclip and remove the lower center trim below a/c controls. (Figure A) 3 Remove (2) Phillips screws exposed behind lower center panel. (Figure A) 4 Unclip and remove the upper center trim starting towards the rear of the B panel. (Figure A) 5 Remove (2) Phillips screws exposed behind upper center panel. (Figure A) 6 Unclip and remove entire panel s
Summary of the content on the page No. 14
95-6511 DASH DISASSEMBLY DODGE CALIBER 2009-10 DODGE CHALLENGER 2009-10 JEEP COMPASS 2009 JEEP PATRIOT 2009 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. Unsnap and move shifter trim to the side. 2 (Figure A) 3 Unsnap center dash trim panel (do not remove until climate controls are removed). (Figure A) 4 Remove (4) Phillips screws holding cli- mate control panel to backside of the center dash panel. 5 Remove (4) 7MM screws securing radio. Unplug and remove
Summary of the content on the page No. 15
115V AC 150W 95-6511 DASH DISASSEMBLY DODGE RAM 1500 2009-11 DODGE RAM 2500/3500 2010-11 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (1) T25 Torx screw in the compart- 2 ment next to the cup holders. (Figure A) 3 Remove (2) Phillips screws in the pocket below the climate control in the front of the center console. (Figure B) B 4 Remove (2) 9/32” screws in the cup holders. (Figure C) 5 Push down on the collar below the shifter then pull the shif
Summary of the content on the page No. 16
115V AC 150W 115V AC 150W 95-6511 DASH DISASSEMBLY DODGE RAM 1500 2009-11 DODGE RAM 2500/3500 2010-11 7 Unclip and remove the trim panel from the F accessory socket on the radio trim panel, then remove (1) T25 Torx screw. (Figure F) 8 Remove (2) T25 Torx screws from the top of the radio trim panel. (Figure G) 9 Unclip and remove the entire radio trim panel including the climate controls. (Figure H) Remove (4) 9/32” screws securing the 10 radio. (Figure I) Continue to kit assembly. G H I 14
Summary of the content on the page No. 17
95-6511 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Attach the Double DIN brackets/trim plates to the Double DIN Radio using the screws supplied with the Radio. (Figure A) Continue to final assembly. STACKED ISO UNITS PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Attach the Double DIN brackets/trim plates to the stacked ISO units using the screws supplied with the units. (Figu
Summary of the content on the page No. 18
95-6511 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D Locate the factory wiring harness in the dash. Metra recommends using the 1 proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. Reassemble radio and dash assemblies in reverse order of disasse
Summary of the content on the page No. 19
95-6511 NOTES 17
Summary of the content on the page No. 20
95-6511 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 12/10/10 © COPYRIGHT 2009-10 METRA ELECTRONICS CORPORATION INST95-6511
