Summary of the content on the page No. 1
INSTALLATION &
OPERATION MANUAL
Digital Video Recorder
MV-DR3000
Before trying to connect or operate this product, please read this manual completely
Summary of the content on the page No. 2
SAFETY PRECAUTIONS All the following safety and operated instructions which will prevent harm or damage to the operator and other persons should be read before the unit is operated. INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. Th
Summary of the content on the page No. 3
CONTENTS 3.5.2 Mobile Rack HD Backup Operations 1. INTRODUCTION ................................. 4 (FOR REMOVABLE HDD MODEL ONLY) 1.1 Product Introduction................................4 ................................................................ 27 1.2 Product Features ....................................4 3.5.3 SD Card Backup Operations for 1.3. FRONT / REAR VIEW............................5 Removable HDD Model .......................... 28 1.3.1 Front View.....................
Summary of the content on the page No. 4
7.2.2 Mobile Rack (FOR REMOVABLE HDD MODEL)...................................................78 7.3 System Default......................................80 7.4 O.S.D Message.....................................81 7.5 Time Index Table...................................82 7.6 Specifications ........................................83 7.7 Compatible Multiplexer Devices............84 7.8 ScanIP ..................................................85 APPENDIX 1. – Using CD Discs (FOR CD-RW MODE
Summary of the content on the page No. 5
1. INTRODUCTION 1. INTRODUCTION 1.1 Product Introduction Refresh rate up to 60 IPS (50 IPS for This 1CH Triplex DVR is a storage media of PAL). digital video image, which uses hard disk Image quality selectable at 4 different drives instead of VCR tapes to store video. It levels for recording. enables you to enjoy the extreme flexibility of Event/Timer/Alarm recording mode. digital image archiving instead of clumsy tape Quick search by time, alarm, event, and management, and i
Summary of the content on the page No. 6
INTRODUCTION ( continued ) 1.3. FRONT / REAR VIEW 1.3.1 Front View FOR CD-ROM MODEL FOR REMOVABLE HDD MODEL 1 24 2a 2b 23 19 18 17 1 23 2 24 19 18 17 DISK A-rec T-rec DISK A-rec T-rec REW FF REW FF 20 20 21 21 SD Card SD Card 22 22 Power Monitor Display Search Setup Enter Play Pause Stop Rec Power Monitor Display Search Setup Enter Play Pause Stop Rec 7 16 8 10 9 15 13 12 11 14 4 3 5 6 7 16 8 10 9 15 13 12 11 14 4 3 5 6 1 1 CD-RW device compartment: Hard-d
Summary of the content on the page No. 7
3 PAUSE button: In a playback display, press this to freeze the display. During the freeze, press to display one frame/field of a picture at a time in the forward direction. (A green light is on the PAUSE mode.) 4 PLAY button: Press to play back a recorded video from the hard disk. (A green light shows in the PLAY mode.) 5 STOP button: Press to stop playing back a recorded video. (A green light goes on in the STOP mode.) 6 REC button: Push to start recording video into a hard di
Summary of the content on the page No. 8
The orange light indicates the hard-disk is retrieving a disk-full status. 20 Shuttle Ring: The shuttle can be moved forward and backward for playback in either direction. Turn this left to play a recorded video in the reverse direction at faster or slower speeds than the recorded speed. Turn this right to play a recorded video in the forward direction at faster or slower speeds than the recorded speed. 21 Jog Dial: This dial can act in both a forward and a backward direction, as well
Summary of the content on the page No. 9
1.3.2 Rear View 25 26 27 28 29 31 FROM MUX VIDEO MAIN MONITOR AUDIO RS-485 IN IN ETHERNET RS-232 10/100 OUT OUT TO TO ALARM I/O MUX'S VCR IN DC12V MONITOR 34 35 37 38 36 32 33 25 33 VIDEO IN Connector: This BNC connector is MONITOR Connector: The connector used to connect the video output from a provides the unit’s composite video or a camera or a MUX to the DVR. MUX’s live signal if connected to a display 26 device. FROM MUX MAIN MONITOR Connector: 34 This BNC connector is used
Summary of the content on the page No. 10
1.4 ALARM In / Out DISK FULL ALARM RESET ALARM OUT RECORD IN GROUND 5 4 3 2 1 9 8 7 6 ALARM IN SWITCH OUT NO CONNECTION NO CONNECTION The above figure is a rear view. recording speed as the DVR. 1. GND: Ground Contact. 7. NO CONNECTION 2. ALARM OUT (OUTPUT): This is an 8. NO CONNECTION alarm-output trigger. Connect this to 9. ALARM IN (INPUT): This is an alarm input, external devices such as buzzers or which can be programmed in the menu lights. system to Normally Op
Summary of the content on the page No. 11
2. INSTALLATION 2. INSTALLATION Camera 2.1 Basic Connection A. Connecting with a Single Camera Please set the MULTIPLEXER option to OFF on the REC SETTING page in the setup menu FROM MUX VIDEO MAIN MONITOR when it is connected with a single camera. AUDIO RS-485 IN IN ETHERNET RS-232 10/100 (Please refer to section 4.1 MULTIPLEXER.) OUT OUT TO TO ALARM I/O MUX'S VCR IN DC12V MONITOR Monitor Multiplexer B. Connecting with a Multiplexer IN Audio To match the multiplexer’s recordi
Summary of the content on the page No. 12
INSTALLATION ( continued ) D. Attaching an External Device to DVR Connect an alarm out, alarm input, and a peripheral device as shown in the diagram below. Lamp FROM MUX VIDEO MAIN MONITOR AUDIO RS-485 IN IN ETHERNET RS-232 10/100 OUT OUT TO TO MUX'S VCR IN ALARM I/O DC12V MONITOR Alarm Reset (Normally Open) 5 4 3 2 1 Ground 9 8 7 6 Alarm in (Normally Open) 2.2 Hard-disk Drive Installation the HD2 USAGE option to REC (please refer The DVR is equipped with two co
Summary of the content on the page No. 13
Table 3.2 B. Compatible hard-disk drives Manufacturer Model Capacity Rotation ST340810A 40G 5400 RPM Seagate ST380020A 80G 5400 RPM ST320014A 20G 5400 RPM ST340015A 40G 5400 RPM ST380012ACE 80G 5400 RPM ST3120025ACE 120G 5400 RPM ST340014A 40G 7200 RPM ST380011A 80G 7200 RPM ST380013A 80G 7200 RPM ST3120026A 120G 7200 RPM ST3160023A 160G 7200 RPM ST3200822A 200G 7200 RPM ST3250823A 250G 7200 RPM ST3400832A 400G 7200 RPM 4A160J0-1A 160G 5400 RPM Maxtor 4R080L0-1 80G 5400
Summary of the content on the page No. 14
8 Press the Display button once; the DVR will display the following sample message plus 2.4 Updating System Software the default display. Press the Display button 8 again; the unit will not display any OSD message. Press the button one more time to go back to the default display. 13 12 1+2 :59G 12.4 HR Please take the following steps to safely update it. QUALITY : BEST NTSC 1. Inserting your SD card into your SD card RATE :6HR 20 F/S reader. 9K MUX :ON 2. Plug yo
Summary of the content on the page No. 15
3. OPERATIONS 3. OPERATIONS This section shows you how to operate and (1) If an APPRO multiplexer is connected for use, manage the DVR when it gets in the way. you can program the REC time mode of the multiplexer by referring to the table below (each refresh rate refers to one REC time mode). 3.1 Configuring Recording Settings (2) For a multiplexer other than APPRO, please Recording time will vary depending on the connect the SW. OUT terminal in the 9-PIN image size, recor
Summary of the content on the page No. 16
OPERATIONS ( continued ) NTSC (MUX ON) Audio ON (11KHz) Possible Recording Time HDD=20GB ( hour ) BEST 3.5 4.4 6.6 11.0 23.6 N.A. N.A. N.A. N.A. N.A. N.A. Image HIGH 3.5 5.5 8.3 13.7 29.2 N.A. N.A. N.A. N.A. N.A. N.A. Quality STANDARD 3.7 7.4 11.0 18.1 38.2 N.A. N.A. N.A. N.A. N.A. N.A. BASIC 5.5 11.0 16.4 26.7 55.3 N.A. N.A. N.A. N.A. N.A. N.A. Refresh Rate (Field/Sec) 60 30 20 12 5.5 2.4 1.22 0.71 1/4 1/6 1/8 REC Time Mode 2 hr 4 hr 6 hr 12 hr 24 hr 48 hr 96 hr 168 hr 480
Summary of the content on the page No. 17
PAL (MUX ON) Audio OFF Possible Recording Time HDD=20GB ( hour ) BEST 3.6 5.4 8.1 13.5 24.4 46.1 89.5 154.6 545.2 816.5 1087.7 Image HIGH 3.6 6.7 10.1 16.9 30.5 57.6 111.8 193.2 681.5 1020.6 1359.7 Quality STANDARD 4.5 9.0 13.5 22.6 40.6 76.8 149.1 257.7 908.7 1360.8 1812.9 BASIC 6.7 13.5 20.3 33.9 61.0 115.2 223.7 386.5 1363.1 2041.2 2719.4 Refresh Rate (Field/Sec) 50 25 17 10 5.5 2.9 1.52 0.88 1/4 1/6 1/8 REC Time Mode 3 hr 6 hr 9 hr 12 hr 24 hr 48 hr 96 hr 168 hr 480 hr 720 hr 960
Summary of the content on the page No. 18
(2) Select the CLOCK / TIMER and press the 3.2 Recording Operations 15 This section details the way to record video Enter button to enter the CLOCK / into hard-disk drives. Before commencing with TIMER page. the recording function, please configure the (3) Select the TIMER－SET. 15 recording setting properly according to your (4) Press the Enter button to enter the REC needs. SCHEDULE table. 11 3.2.1 Manual Recording (5) You can set up by using the “<” button 14 Take the following s
Summary of the content on the page No. 19
MAIN MENU during the scheduled recording to stop it any RECORD ALARM / MOTION time. If you wish to continue the scheduled CLOCK/ TIMER COMMUNICATION DISK 6 recording, press the REC button to SYSTEM proceed. GOTO ALARM/ MOTION PAGE Note : You can proceed to start the scheduled ALARM/ MOTION recording from the current time if it is in the ALM OPERATION : ON REC RATE : 30 F/S scheduled interlude as soon as setting is REC QUALITY : BEST AUDIO : OFF comple
Summary of the content on the page No. 20
NOTE: The status of recording operations when an alarm takes place is shown in the diagrams below. 1 Manual or Externally Triggered Recording Alarm Takes Place Actual Recording Speed Normal Alarm Normal 2 Timer Recording Alarm Takes Place Actual Recording Speed Normal Alarm Normal 3 Timer Recording Alarm Takes Place Actual Recording Speed Normal Alarm 4 Timer Recording Alarm Takes Place Actual Recording Speed Alarm Normal 19
