Summary of the content on the page No. 1
INSTALLATION INSTRUCTIONS FOR PART 95-3302
APPLICATIONS
GM
MULTI KIT
(see models list inside)
95-3302
KIT FEATURES
• Double DIN Mount Radio Provision
• Stacked ISO Mount Radio Provision
• Painted To Match Factory Dash
KIT COMPONENTS
A) Double DIN Housing • B) Double DIN Brackets
B
A WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• See www.metraonline.com for specific interface applications
Antenna Adapter:
• 40-GM10 - GM antenna adapter 1988-up
• 40-CR10 - Chrysler anten
Summary of the content on the page No. 2
95-3302 TABLE OF CONTENTS Dash Disassembly Chevrolet Saturn - Cobalt 2005-2010 . . . . . . . . . . . . . . . .1 - Aura 2007-2009 . . . . . . . . . . . . . . . . . .9 - Equinox 2005-2006 . . . . . . . . . . . . . 2 - Ion 2006-2007 . . . . . . . . . . . . . . . . . . .10 - HHR 2006-2010. . . . . . .. . . . . . . . . . . . 3 - Sky 2006-2009 . . . . . . . . . . . . . . . . ...11 - Malibu 2004-2007 . . . . . . . . . .. . . . .4,5 - Vue 2006-2007 . ... ... .... .... . . ..12 - Malibu 2008-2010 . .
Summary of the content on the page No. 3
95-3302 DASH DISASSEMBLY Chevrolet Cobalt 2005-2010/Pontiac G5 2007-09 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip and remove trim panel from above glove box. (Figure A) 3 Unclip upper edge of panel below steering column and let hang. Not B necessary to remove completely. (Figure B) 4 Unclip and remove small trim panel to right of ignition switch. (Figure C) 5 Unclip and remove trim panel sur- rounding radio and climate controls. (Figure D) C 6
Summary of the content on the page No. 4
95-3302 DASH DISASSEMBLY Chevrolet Equinox 2005-2006 Pontiac Torrent 2006 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unsnap panel below power window switch and remove. Note: This allows you to unplug the window switch easier. (Figure A) B 3 Unsnap and remove entire panel sur- rounding radio and shifter. (Figure B) 4 Remove (4) 9/32 screws securing radio. Unplug and remove the radio. (Figure C) Continue to kit assembly. C 2
Summary of the content on the page No. 5
95-3302 DASH DISASSEMBLY Chevrolet HHR 2006-2010 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip and remove entire panel sur- rounding radio and a/c controls including the a/c vents. (Figure A) 3 Remove (8) 9/32” screws securing radio and a/c control to remove radio. (Figure B) Continue to kit assembly. B 3
Summary of the content on the page No. 6
95-3302 DASH DISASSEMBLY Chevrolet Malibu 2004-2007 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip and remove wood grain/paint- ed trim pieces from both sides of steering wheel. (Figure A) 3 Unclip and remove side panel from driver’s side of dash with door open B and remove (2) 7 MM screws. (Figure B) 4 Remove (2) 7 MM screws from bot- tom edge of panel below steering wheel, unclip panel and let hang. It is not necessary to completely remove panel
Summary of the content on the page No. 7
95-3302 DASH DISASSEMBLY Chevrolet Malibu 2004-2007 E 6 Unclip and remove side panel from passenger side of dash with door open and remove (2) 7 MM screws from behind panel. (Figure E) 7 Remove (2) 7 MM screws from bot- tom of glove box then open box and squeeze sides together to open fur- ther and remove the remaining (4) 7MM screws. Unclip the black vent F cover under the glove box then unclip and remove entire glove box assem- bly. (Figure F) 8 Unclip and remove trim panel sur- rounding radi
Summary of the content on the page No. 8
95-3302 DASH DISASSEMBLY Chevrolet Malibu 2008-2010 A 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unsnap and remove shifter trim. Note – start around shifter and be sure to pull down before back because this panel slides up under the radio/climate panels. (Figure A) 3 Remove (2) 8 mm screws from bottom of radio/climate panel. B 4 Unsnap and remove the climate/radio panel and upper vent trim panel together. (They can be separated after removel) (Figure
Summary of the content on the page No. 9
95-3302 DASH DISASSEMBLY Pontiac G6 2005-2009 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Open glove box and remove (6) screws from outer edge then unclip and remove box. (Figure A) 3 Remove (4) screws from panel below steering column. Unclip and B remove panel. (Figure B) 4 Unclip and remove center panel sur- rounding radio and A/C controls. (Figure C) 5 Remove (4) screws securing the radio. Unplug and remove the radio. (Figure D) C Continue to kit a
Summary of the content on the page No. 10
95-3302 DASH DISASSEMBLY Pontiac Solstice 2006-2009 1 Disconnect the negative battery ter- A minal to prevent an accidental short circuit. Manual transmission: 2 A. Lift up the lower edge of the instrument panel cluster trim plate enough to reach underneath and release the shift boot trim ring retaining tabs. (Figure A) B. Lift up on the shift boot and B loosen the setscrew to release the shift lever. (Figure B) 2 Automatic transmission: A. Unclip and remove shifter trim ring. (Figure C) 3 Uncli
Summary of the content on the page No. 11
95-3302 DASH DISASSEMBLY Saturn Aura 2007-2009 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip and remove shifter trim ring. (Figure A) 3 Unclip and remove the center con- sole trim panel, then remove (2) screws from bottom edge of dash trim panel. (Figure B) B 4 Unclip and remove the key switch trim ring, then unclip and remove dash trim panel. (Figure C) 5 Remove (2) screws securing the cli- mate controls. 6 Remove (4) screws securing the radio.
Summary of the content on the page No. 12
95-3302 DASH DISASSEMBLY Saturn Ion 2006-2007 1 Disconnect the negative battery ter- A minal to prevent an accidental short circuit. 2 Unclip radio trim panel. (Figure A) Unplug connectors from trim panel and remove panel. (Figure B) 3 Remove (4) screws securing the radio. Unplug and remove the radio. B Continue to kit assembly. 10
Summary of the content on the page No. 13
95-3302 DASH DISASSEMBLY Saturn Sky 2006-2009 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Unclip and remove side panel from driver’s side of dash with door open and remove (2) 7 MM screws. (Figure A) 3 Remove (2) 7 MM screws from bottom edge of panel below steering wheel, B unclip panel and remove panel. 4 Unclip and remove side panel from passenger side of dash with door open and remove (2) 7 MM screws from behind panel. (Figure B) 5 Open the glove b
Summary of the content on the page No. 14
95-3302 DASH DISASSEMBLY Saturn Vue 2006-2007 1 Disconnect the negative battery ter- A minal to prevent an accidental short circuit. 2 Grasp the front edge of the shifter trim panel and pull outward and upward. (Figure A) 3 Squeeze the locking tabs located at the front edge of the shifter trim panel together to release the front edge of the panel from the center console. (Figure B) 4 Pull upward on the panel to release the remaining clips, and remove trim B panel. 5 Remove (4) screws securing st
Summary of the content on the page No. 15
95-3302 KIT ASSEMBLY DOUBLE DIN MOUNT RADIO PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Slide the appropriate bracket into the trim plate aligning the holes in the trim plate to the clips on the bracket. (Figure A) 2 Slide the DDIN radio unit into the trim plate bracket assembly and secure the unit to the kit using the screws supplied with the head unit. (Figure B) 3 Aura, Cobalt, G5, HHR, Sky and Vue only: Cut and remove top mounting tabs on B each s
Summary of the content on the page No. 16
95-3302 KIT ASSEMBLY STACKED ISO MOUNT RADIO PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Slide the appropriate bracket into the trim plate aligning the holes in the trim plate to the clips on the bracket. (Figure A) 2 Slide the stacked ISO DIN units into the trim plate bracket assembly and secure the units to the kit using the screws supplied with the head units. (Figure B) 3 Aura, Cobalt, G5, HHR, Sky and Vue only: Cut and remove top mounting tabs on
Summary of the content on the page No. 17
95-3302 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disas
Summary of the content on the page No. 18
95-3302 NOTES 16
Summary of the content on the page No. 19
95-3302 NOTES 17
Summary of the content on the page No. 20
95-3302 INSTRUCTIONS www.metraonline.com 1-800-221-0932 REV. 05/03/10 © COPYRIGHT 2001-2010 METRA ELECTRONICS CORPORATION INST95-3302
