Summary of the content on the page No. 1
DVD + H.D.D.VIDEO RECORDER
HY-DVDR
INSTRUCTION MANUAL
Please read the I/M carefully before connection
-1-
DVR-ËμÃ÷Êé.p65 1 03-9-16, 15:18
Summary of the content on the page No. 2
TABLE OF CONTENTS SAFETY INFORMATION ------------------------------- 3 CHAPTER (For DVD Only) ----------------------- 14 FEATURES ------------------------------------------------4 SUB-T ------------------------------------------------- 14 PRECAUTIONS ------------------------------------------ 4 BOOK/MARK ---------------------------------------- 14 ACCESSORIES ------------------------------------------ 5 AUDIO SETTING(For VCD Only) ---------------- 14 FRONT PANEL ---------------------------------
Summary of the content on the page No. 3
SAFETY INFORMATION Dear customers, We take this opportunity to thank you for purchasing this DVR/DVD/VCD /CD Recorder player. We strongly recommend that you study carefully the operation instructions before attempting to operate the unit and that you have noted the listed precautions. Note This unit can be used only where the power supply is 240V 50Hz. Caution uDVR/DVD/VCD/CD RECORDER PLAYER IS A CLASS 1 LASER PRODUCT. HOWEVER THIS DVD/CD PLAYER USES A VISIBLE LASER BEAM WHICH COULD CAUSE HAZARD
Summary of the content on the page No. 4
FEATURES PRECAUTIONS More functions than DVD player: cord. Video playback,hard disc record, family entertainment uRemove the dust, dirt, etc. on the plug at regular intervals. Two different optional input modes :AV,RFTV signal. uIf the unit has been dropped or damaged, turn off the Two different modes output:Composite video,S-video. power and disconnect the AC power cord. Digital audio output: optical/coaxial output jack. uIf you find smoke, bad smells or noises from the unit, 5.1 channel analog
Summary of the content on the page No. 5
ACCESSORIES Plese check and confirm the accessories: Remote Control 1 piece Instruction Manual 1 piece Battery 2 pieces Warranty card 1 piece 3-Way AV cable 1 piece FRONT PANEL 1. STANDBY switch 7. PLAY button 2. Disc tray 8. STOP buiion 3. Remote Control Sensor 9. REC button 4. VFD display 10. DVD button 5. Channel+/- button 11. TV/AV button 6. OPEN/CLOSE button 12.TIME SHIFT button -5- DVR-ËμÃ÷Êé.p65 5 03-9-16, 15:18
Summary of the content on the page No. 6
REAR PANEL 1.Video output jack 2. 5.1channel centre output jack 3. 5.1channel surround left output jack 4. 5.1channel front left output jack 5. Power Switch 6. TV antenna input jack 7. Exhausting Fan It is working when the unit is powered on. 8. S-VIDEO output jack 9. Optical output jack (Not available for TV channel) Outputs digital audio signals and can be connected to digital audio decoder or amplifer with optical input 10. Coaxial output jack (Not available for TV channel) Outputs digi
Summary of the content on the page No. 7
REMOTE CONTROL 1.OPEN/CLOSE button 2.TITLE button 3.A-B REPEAT button 4. SUB-T (Subtitle) button 5. NUMBER(0-9.+10.--)button 6.MUTE button 7.AUDIO button 8.REC button 9.CH+.CH- button 10.DISPLAY button 11. Direction button: 5(up) button, 6(down) button, 3 (left) button, 4(right) button 12.RETURN button 13.SLOW button 14.STOP button 15.FB button 16.FF button 17.ZOOM button 18.LANGUAGE button 19.VOL- botton 20.VOL+ botton 21.PREV button 22.NEXT button 23.STEP/PAUSE button 24.PL
Summary of the content on the page No. 8
PANEL DISPLAY 1. DVD disc mode indicator 10. Playback running indicator 2. playback indicator (DVD or HD) 11. DTS indicator 3. TV mode indicator 12. Dolby digital indicator 4. pause indicator 13. 14.TITLE Display or chapter Display 5. VCD/ CD disc mode indicator 15. Time Display(Hour) 6. Record indicator 16. 17.Time Display(Minute) 7. Time shifting indicator 18.19. Time Display (second) 8. SP (Standard recording mode) indicator 9. LP (Long play recording mode) indicator -8- DVR-ËμÃ÷Êé.p65 8 03-
Summary of the content on the page No. 9
BASIC CONNECTION uEnsure that the power switch of this unit and other equipment to be connected is turned off before commenc- ing connection uRead through the instructions before connecting other equipment uEnsure that you observe the color-coding when con- necting audio and video cords A: Connecting to TV set 1. TV set (not included) 2. DVR Record player 3. To S-video input connector of TV set (not included) 4. 75ohm Antenna input jack (antenna cable not included) 5. Video/Audio cord 6. To comp
Summary of the content on the page No. 10
BASIC CONNECTION C: Connecting to AV amplifier with 5.1 channel input connector supporting Dolby AC-3 or MPEG2 This DVR Recorder Player contains a Dolby(AC-3) or MPEG2 decoder.this enables the playback of DVR Recoder with Dobly digital,MPEG1/2 audio or linear PCM processing.When the player is connected to an AV amplifier with 5.1channel input connectors,theater quality audio could be enjoyed at your home when playing a disc recorded in Dolby digital,MPEG1/2 audip or linear PCM. you can enjoy the
Summary of the content on the page No. 11
BASIC CONNECTION D: Connecting to a decoder with Dolby digital (AC-3)processing or MPEG processing When DVDs recorded in Dolby digital or MPEG audio are played, Dolby digital bit stream or MPEG audio bit stream is output from the player’s OPTICAL digital audio output connector or COAXIAL digital audio output connector. When the player is connected to a Dolby digital decoder or MPEG audio decoder, you can enjoy theater-quality at your home.(see Graph E) Take off the protective cap of optical cab
Summary of the content on the page No. 12
REMOTE CONTROL PREPARATION Battery Installation Insert the batteries while observing the positive(+) and negative(-) polarities as Figure A Service life of batteries uThe batteries normally last for about one year although this depends on operation and for what operations the remote control is used. uIf the remote control unit fails to work even when it is operated near the player, replace the batteries uUse size AAAUM-4 batteries(2 pieces) Notes: uDo not use rechargeable (Ni-Cd) batteries uDo
Summary of the content on the page No. 13
OPERATIONS Preparation uTurn on TV set and select AV as the TV input SLOW uSwitch on the related equipment if the player has been Press SLOW button on remote control during playback connected to amplifier etc. of a disc and the unit works slow playing. There are 3 uMost of the functions are operated by remote control . levels of speed available:1/2, 1/4,1/8. Either the operation of the remote control or front panel Note: Some discs have no such function. will be affected when their buttons
Summary of the content on the page No. 14
OPERATIONS TITLE (DVD Only) DISPLAY Press TITLE button on remote control when during Press DISPLAY during playback to show the disc’s rel- playback,a title list on the disc (depends on discs)will be evant information on TV screen (such as playing time, displayed on TV monitor. tItle,chapter,playback status). Use direction button or number button to select your preferred title then press ENTER to start to play. PBC Press PBC button to open or close PBC play mode under CHAPTER (DVD Only) the norm
Summary of the content on the page No. 15
OPERATIONS 3.RECORD again to return to the upper level menu and the current AV INPUT RECORD selection and input will be stored. If you want to cancel You can transmit AV input video signal and stereo audio the current operation and return to the upper level menu signal to the unit and playback or record.And press TV/ in the course of input or selection, please press RETURN AV button and set the unit up to AV status. If you want to button. record the signal from AV input video and stereo audio,
Summary of the content on the page No. 16
SETUP 1. SYSTEM INFO: Display the information about the built-in hard 5. OSD LANGUAGE SETUP disc. ENGLISH OSD language is available. 2. SCAN DISC: To scan the hard disc, press ENTER button to 6. POWER ON MODE confirm the start of the scanning to the hard disc. Press the It is a setup to decide which status the unit is in when power on RETURN button to return to the upper level menu. NORMAL MODE: After started, the unit is in DVR starting status, 3. FORMAT DISC: To format the hard disc, press
Summary of the content on the page No. 17
APPENDIX APPENDIX Handling Precautions Maintenance PBC Hold the disc by the edge so the surface will not be soiled The language is indicated on TV screen to imply operation with fingerprints. Fingerprints, dirt and scratches can or disc information. cause skipping and distortion. Do not use record cleaning sprays, benzene, thinner, static Audio electricity prevention liquids or any other solvent. Language recorded on discs and the maximum Be careful not to drop or bend the disc. languages are up
Summary of the content on the page No. 18
APPENDIX APPENDIX DVR’s unique Time Shifting technology can resolve these can be copied directly to computer or other unit via vari- problems absolutely to eliminate your troubles. ous interfaces and will not cause copy loss for image and sound at all. First, please confirm the proper connection between DVR The information source stored in the hard disc can be and TV. Then, turn on the TV power. If your DVR output held flexibly and can be deleted at any time if it is signal has been connected to
Summary of the content on the page No. 19
FOR YOUR REFERENCE u Specification TV tuner Power requirement: AC240V, 50Hz uTV receive system:PAL B/G Power consumption 40W antenna impedance:75 un-balance. Signal system: PAL/NTSC utune receive frequency: Operating temperature range: +5~+35°C VHF-L:46.25~168.25MHz Operating humidity range: 5~90% (no condensation) VHF-H :175.25 ~447.25MHz UHF:455.25 ~855.25MHz Disc played 1. DVD-video disc Record part u12cm single-sided, single-layer uAudio S/N rate:(S/N) :80 dB u12cm single-sided, double-layer
Summary of the content on the page No. 20
FOR YOUR REFERENCE uTroubleshooting Check the chart below for a possible cause of the problem you are experencing before requesting service for this unit. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. Let the technician maintain the unit. symptom Possible reason Suggested solution No power l The power cord is not in the socket l Firmly insert the power cord into the socket Remote control doesn’t l The batteries have been exhaus
