Summary of the content on the page No. 1
SD-W1101 DVD-RAM
with REALmagic Hollywood+ Playback Card
Installation Instructions
Congratulations on your purchase of a Toshiba SD-W1101 DVD-RAM
drive and REALmagic Hollywood+ DVD/MPEG-2 Playback Card Kit.
The following information will help you in the simple installation of
your new DVD-RAM. If you are not replacing a presently installed SCSI
CD-ROM with the enclosed DVD-RAM, additional installation hardware
may be required. Refer to REALmagic Hollywood+ User’s Guide for
installation instruc
Summary of the content on the page No. 2
The follow steps must be performed to properly install your DVD-RAM. l Set DVD-RAM drive jumper settings. l Connect audio cable. l Install SCSI host adapter board. l Attach SCSI interface cable. l Connect power cable. l Mount DVD-RAM. SETTING JUMPERS The block of mode select jumpers are located on the rear of the DVD- RAM. If the jumper covers both pins on the jumper block, it is ON; if there is no jumper or only one of the pins is covered, the jumper is OFF. The jumper settings include SCSI ID
Summary of the content on the page No. 3
Test - This setting is for manufacturer use only. Do not jumper. Terminator ON/OFF - This jumper turns termination power ON or OFF. If you are connecting more than one SCSI device to your system, and the DVD-RAM is not at the end of the chain, then terminator jumper is not required. PLACING DVD-RAM INSIDE YOUR COMPUTER Now that you have set the jumpers, you are ready to install your DVD- RAM inside your computer. IMPORTANT: Disconnect power from your computer system before beginning installati
Summary of the content on the page No. 4
Daisy-Chaining - If the DVD-RAM you are installing is one of two or more SCSI devices you are connecting to your system, you will need to use a custom built SCSI interface cable. Remember that the terminator jumper on the DVD-RAM drive must have the jumper installed when the drive is the last device in the chain. Host Computer Interface I/F Card Connector SCSI Cable DVD-RAM DRIVE (see note 1) Terminator SD-W1101 CONNECTION (ONE DRIVE) SD-W1101 INTERNAL DRIVE(S) Host Computer SCSI Cable Interfa
Summary of the content on the page No. 5
Audio Cable (optional) - If you have a sound card and speakers, and would like to play audio CDs on your computer, you will need to get a sound cable. Contact AMC, our small parts supplier, at 888/262-9700. Sound cables are made for the sound card you are using and the DVD- RAM to which you are connecting. Make sure you have this information when purchasing a sound cable. The sound cable connects to your sound card at one end and the other end connects to the digital audio connector at the le
Summary of the content on the page No. 6
USING “WRITE DVD” After installing software, your DVD-RAM drive will be assigned two drive letters. One will be for “read only” media (a CD icon) and the other will be for “DVD-RAM” media ( a removable disk icon). Use your DVD- RAM drive just like any other drive on your system. If you want to copy a file from your hard drive to the DVD-RAM, just select file and drag and drop it onto DVD-RAM removable disk icon. DVD-RAM FRONT PANEL The photo illustrates the following features of the SD-W1101
Summary of the content on the page No. 7
DVD-RAM RECORDING CARTRIDGE When recording a DVD-RAM, you must use a “recording” cartridge. There are two types of cartridges: Type 1: • Cartridge is reversible (side A & B). • Disc cannot be removed from cartridge. • Cartridges are available with single-sided* or double-sided discs. Type 2: • Cartridge is not reversible (side A only). • Disc in cartridge can be removed and replaced. * Your SD-W1101 comes with a Type 1 single-sided cartridge. INSTALLING CARTRIDGE IN DVD-RAM Place cartridge insid
Summary of the content on the page No. 8
SD-W1101 SPECIFICATIONS Data Capacity DVD-RAM (single & double) 2.42 GB DVD-R 3.9 GB DVD-ROM SINGLE SIDED-SINGLE LAYER 4.7 GB DVD-ROM SINGLE SIDED-DOUBLE LAYER 8.5 GB DVD-ROM DOUBLE SIDED-SINGLE LAYER 9.4 GB DVD-ROM DOUBLE SIDED-DOUBLE LAYER 17 GB CD-ROM 650 MB Rotational Speed DVD-RAM 1,028-2,400 rpm DVD-ROM/DVD-R 1,200-2,800 rpm (single layer) 1,300-3,000 rpm (double layer/DVD-R) CD-ROM 3,516 rpm (16X) Transfer Rate DVD-RAM 1,350 KB/second DVD-ROM/DVD-R 2,700 KB/second CD-ROM 990-2,400 KB/seco
