Summary of the content on the page No. 1
INSTALL INSTRUCTIONS P-MID-1 w/P-MFK-5
MIDDLE PARTITION w/MOUNTING FILLER PANEL KIT
1997-2008 CHEVROLET/GMC FULL SIZE PASSENGER VANS
TOOLS REQUIRED:
Power drill Ratcheting wrench
Drill bit set Standard & Metric socket set
HARDWARE:
QTY DESCRIPTION PART #
5 ¼” x 1 ½” Hex head Lag Bolt GSM33062
6 ¼” x 1” Hex head Lag Bolt GSM33060
20 ¼-20 x ¾” Carriage Bolt GSM32000
12 ¼-20 Serrated Nut GSM30023
8 ¼-20 Nylock Nut GSM30016
1 5/16-18 Nylock Nut GSM30017
1 5/16-18 x 2” Hex Head
Summary of the content on the page No. 2
SUB ASSEMBLY: 1. Remove “C” pillar trim panel. This is necessary for driver side mounting bracket. 2. Position upper center filler to partition and mark mounting holes. 3. Drill 5/16” holes on marks. Always! Read all instructions before installing any Havis-Shields Equipment Corp products. Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with install kit INSTALLATION: 1. ATTACH PARTITION TO FLOOR: • Place part
Summary of the content on the page No. 3
serrated nuts. • Press partition as far forward and mark mounting holes where driver side mounting bracket and “C-pillar” come in contact. • Pre-drill 3/16” holes into “C-pillar”. • Attach bracket to C-pillar using (3) ¼” x 1” Hex head lag bolts. • Plastic trim panel must be notched around bracket to mount. 3. ATTACH PASSENGER SIDE MOUNTING BRACEKT: • Press partition as far forward as possible and holding bracket to partition (square tubing section) determine where to slot headline
Summary of the content on the page No. 4
5. ATTACH DRIVER SIDE UPPER LEXAN FILLER PANEL: • Position driver side ¼” lexan filler panel to partition so that minimal space is between the vehicles window, (or window guard) and the lexan filler. NOTE: It is necessary to keep a 1/8” gap between the window or guard and the filler to allow for expansion and contraction of the lexan during temperature fluctuations. • Drill (6) 5/16” holes evenly spaced through both the ¼” lexan filler panel and the partition frame. Attachi
