Havis-Shields Chevrolet Van Rear Air Vent Adapter Kit KK-C-VAK user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS for KK-C-VAK
CHEVROLET VAN REAR AIR VENT ADAPTER KIT

TOOLS REQUIRED:
Screw Driver Set Power Drill
Ratcheting Wrench Set Drill Bit Set
Standard Socket Set Safety Goggles

HARDWARE / COMPONENTS:
QTY DESCRIPTION PART #
1 Heat/Cool Adaptor box assembly KKM01152
1 Chevy Heat/Cool Box mounting channel KKM01147
1 Chevy Rear Air Hose Adapter KKM01148
10 Hose Clamps 3” GSM20045
2 4” Hose Clamps GSM20042
1 4” Diameter Hose

Summary of the content on the page No. 2

Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-524 Note: This procedure must be done PRIOR to the Kwik Kit installation and is recomme

Summary of the content on the page No. 3

Route HVAC 2 1/2” blower hoses to the Attach the “Y” duct hose adaptor to approximate locations with tape along the 8 foot front duct hose and ceiling where they will be installed into the connect both 4 foot hoses from “Y” ceiling insert after Kwik-Kit insert is to vents in driver and passenger side installed. Mount hoses with wire ties at front ceiling. This will provide a wall and ceiling corners only. Leave total of four ceiling vents. enough slack to reach hoses for permanent

Summary of the content on the page No. 4

Check that airflow through hoses is working properly. With hoses routed to locations, proceed to install Kwik-Kit unit until you come to the ceiling instructions. Be sure not to puncture the hoses with screws, drill bits, etc… Attach ceiling pieces on Kwik-Kit, routing hoses into the corresponding holes in Kwik-Kit ceiling. Pull through to minimize slack. Check airflow again. After Aluminum insert is installed and tested, attach cover plate to bench / wall to cover OEM