Havis-Shields C-VS-1200-F250-1 user manual

Summary of the content on the page No. 1

4
INSTALL INSTRUCTIONS C-VS-1200-F250-1
Vehicle Specific Console
2008 FORD F-250, 350, 450 and 550 Pickup and Cab Chassis Trucks

TOOLS REQUIRED:
Ratcheting wrench Phillips Screwdriver
Metric/Standard Socket Set T-20 Torx Driver bit
7/16” Wrench 7 mm Socket or Driver

INSTALLATION HARDWARE:
QTY DESCRIPTION PART #
1 ¼” X 1” Hex Bolt GSM33002B
5 ¼” X ½” Carria

Summary of the content on the page No. 2

OEM Dashboard Carefully remove the small dash Remove passenger side small panel that holds the lighter plug. panel. Use 7mm socket and remove dash Use 7mm socket and remove dash mount screw mount screw Unplug and remove complete Carefully detach upper dash panel Detach lower dash panel under upper dash panel. assembly from spring clips. steering column. Note: Installation can be done without complete removal, but install is easier when removed. Use 7mm socket and remove three

Summary of the content on the page No. 3

Console shipped unassembled Use 7mm socket and remove two center dash screws. Reuse these screws and attach lower console bracket. Assemble the two-piece dash Attach dash panel to console housing with three ¼” x ½” carriage bolts and adaptor panel with three (3) #8 x flange nuts. Do not tighten yet. ¼” Flat Head sheet metal screws. Attach console assembly with two Attach console housing to lower Attach Dash panel at lower OEM screws. Only attach two dash bracket with two ¼” x ½” pas

Summary of the content on the page No. 4

If truck has OEM center console, it will be a The cup holder on OEM console can be tight fit depending on control heads. This may temporarily removed to create more space during require installation of lower faceplates into installation. Remove two Phillips screws under console prior to console housing mounting. armrest and unclip gray plastic front cap. Optional cup holder model C-CUP2-E-C mounted Wire and mount all control heads. on side of console. Mount holes must be drilled in Note