Summary of the content on the page No. 1
H A N D B O O K C D 7 2
C D 8 2
Arcam Compact Disc players
Summary of the content on the page No. 2
Safety guidelines 9. Power sources Safety instructions Only connect the appliance to a power supply of the type This product is designed and manufactured to meet strict described in the operating instructions or as marked on the quality and safety standards. However, you should be aware of appliance. the following installation and operation precautions: 10. Power-cord protection 1. Take heed of warnings and instructions Power supply cords should be routed so that they are not likely You sho
Summary of the content on the page No. 3
Using this handbook This handbook has been designed to give you all the information you need to install, connect, set up and use the Contents Arcam CD72 or CD82 compact disc players. The CR-314 Safety guidelines 2 remote control handset supplied with this equipment is also Safety instructions 2 described, as it applies to operating the CD players. Safety compliance 2 Using this handbook 3 Safety Safety 3 Safety guidelines are set out on the inside front cover of this Models covered 3 handbo
Summary of the content on the page No. 4
Installation Remote input connection Positioning the unit It is not necessary to make any connection to this socket in Always place the CD player on a level, firm surface. Placing normal use. This connection is for ease of installation to multi- your player on a set of dedicated sorbothane isolation feet room remote control systems and is suitable for modulated will isolate the unit from its surroundings as well as absorbing IR commands. Contact your multi-room installer for more the vibra
Summary of the content on the page No. 5
Using your CD player COMPACT DISC PLAYER CD82 24 BIT DUAL MONO DACS TRACK LOAD PLAY STOP PAUSE POWER 1 2 3 4 5 6 7 POWER SKIP TRACK 1 7 Press this button to switch the CD player on and off. When first To start a CD with a track other than the first, press or powered up with no CD installed the display shows: to locate the desired track. To select another track during play, press or . The track is played automatically after selection. Pressing once --NO DISC-- returns to the start of the
Summary of the content on the page No. 6
Using the remote control CR-314 Remote Control Note that greyed-out buttons on the remote control are DVD- specific and are not used with the CD player. CD/DVD 0–9 keypad Ensure that CD mode is selected using the CD/DVD This allows direct access to individual tracks on the disc. To toggle button. The ‘CD’ LED above the CD/DVD select a track, press the corresponding keypad button and then button is lit briefly when CD mode is selected. press . For tracks greater than 9, enter the digits in seq
Summary of the content on the page No. 7
Technical specification Digital to Analogue conversion Physical CD72: 24-bit multilevel Delta-Sigma DAC Dimensions W430 x D290 x H84mm CD82: Dual mono 24-bit Wolfson DAC Weight Laser pick-up 3 beam CD72 4.6kg nett/6.1kg packed Laser wavelength 780nm CD82 5.5kg nett/7.0kg packed Numerical aperture 0.45 Power consumption 32VA maximum Dynamic range 106dB Signal to noise ratio (CCIR) >100dB Digital output connection 75 Ω co-axial Harmonic distortion (0dB, 1kHz) <0.005% optical TOSLINK Frequency
Summary of the content on the page No. 8
Guarantee Worldwide Guarantee It should be sent carriage prepaid by a reputable carrier -– NOT This entitles you to have the unit repaired free of charge, by post. No responsibility can be accepted for the unit whilst in during the first two years after purchase, at any authorised transit to the dealer or distributor and customers are therefore Arcam distributor provided that it was originally purchased advised to insure the unit against loss or damage whilst in from an authorised Arcam deal
