Philips PDCC-JH user manual

Summary of the content on the page No. 1

1
Quick Start Guide
2
User Manual
MCD196
Quick Start Guide
What’s in the Box?
You should find these items upon opening the box.
Remove the plastic
protective sheet
CLOCK
Remote control with
Quick Start Guide
Composite Video Cable
battery
MW antenna FM antenna User Manual
MCD196_98 QUG_Eng 1 13/2/07, 14:41

Summary of the content on the page No. 2

1 Connect the speaker cables. 2 Connect the FM and MW antennas. Tip See the User Manual for other TV 3 connection options. Connect the composite video cable to a TV. 4 Connect the power cords of the system and TV. TV A FM antenna MW antenna 3 A To listen to the sound of this DVD Player AM AERIAL through your TV, use the audio cables (white/ FM 2 AERIAL Speaker red-not supplied) to connect LINE OUT Speaker VIDEO OUT (right) VIDEO S-VIDEO (L/R) jacks of the DVD Player to the (left) SUB WOOFER DIGI

Summary of the content on the page No. 3

Setting the clock 1 MICR O THEA TRE MCD196 STANDBY-ON SOURCE In standby mode, press and hold DISPLAY/CLOCK SET on the system. DISPLAY/CLOCK SET DBB - VOLUME + SET DSC 2 iR PRESET When the hour digits flash, pressí/ëon the front panel or on the remote to set the AUX hours. TUNING PRESET 3 Press DISPLAY/CLOCK SET again and the minute digits flash. Then press í/ë on the front panel or on the remote to set the minutes. DVD/WMA-MP3-CD COMPATIBLE 4 PULL TO OPEN Press DISPLAY/CLOCK SET again to confirm

Summary of the content on the page No. 4

Playing a disc 1 Press OPEN•CLOSE 0 to open the disc tray and load in a disc, then press the same button again to close the disc tray. ➜ Make sure the label side of the disc is facing up. 2 Playback will start automatically. If not pressÉÅ. 3 To stop playback, press 9. Programming and tuning to radio stations 1 Press SOURCE (TUNER on the remote) to select tuner source. 2 Press PROG/ANGLE for more than two seconds to program all available stations in order of waveband. 3 Press PRESETí/ë until the