Dakota Digital DHC-2000 user manual

Summary of the content on the page No. 1

DHC-2000/DHC-2100 rev. C
Digital Height Control System
Right Rear GREEN BROWN
Left Front
SEN-03-1 SEN-03-1
Bag
Bag
OPTIONAL
REMOTE
CONTROL
Left Rear
PURPLE ORANGE Right Front
SEN-03-1
SEN-03-1 ANTENNA
Bag
Bag
ONLY USED WITH
PRESSURE ONLY OR
HEIGHT-PRESSURE
COMBINATION
Do not bundle or route the solenoid
and sensor wires together! Dakota Digital
DHC-2000
DIGITAL HEIGHT
CONTROL SYSTEM
To FRONT air
solenoid block
RIGHT FRONT DOWN (+) GREEN
LEFT FRONT DOWN (+) RED
RIGHT FRONT UP (+)

Summary of the content on the page No. 2

Introduction Congratulations, you have purchased one of the finest AIR-Ride Height Control Systems available. This system can: • use height sensors, pressure senders, or both height and pressure senders to monitor and control of all four corners of the vehicle with the option of monitoring the tank pressure. • have three different height presets for automatic up/down control, manual up/down control, and to completely empty the air bags. • be connected to an ARR-2000 remote transmitter

Summary of the content on the page No. 3

OPERATION / PROGRAMMING The auto height control system is active when both the large red power wire and the yellow accessory power wire are on. When the accessory power is off the display and height control will shut down to prevent draining the battery. The display unit has a 2 line, full character display with three switches on the left side and four switches on the right side. The left side switches select the presets. The right side switches allow manual control, change the dis

Summary of the content on the page No. 4

Manual Control / Setup Switches SETUP UP SETUP SELECT SETUP DOWN Setup Menus: To enter the setup mode, press and hold the Setup Select Switch while turning the key on. Use the top and bottom Setup Switches to scroll up and down through the menus. Use the Setup Select switch to select a menu item. The menus are: DONE - exit the setup routine REM - Remote system setup (operation mode and transmitter programming) SENSR - Sensor programming (adjusting for mechanical arm travel) SPEED

Summary of the content on the page No. 5

Changing the output speed: The output speed can be used to slow down systems with large air lines or high pressure tanks so that the system will operate more reliably and stop at the desired height with minimal overshoot. 1. Begin with the key off and then hold the left Setup Select Switch in while turning the key on. The display will show (“CODE” “AC44B”, aluminum control case)( “CODE” “AC48”, plastic control case). 2. Release the switch. The display will show “SETUP” “DONE”. 3. Press

Summary of the content on the page No. 6

Problem Possible cause Solution ---------------------------------------------------------------------------------------------------------------------------------------------------- Gauge will not light up RED wire does not have Connect to a location that has power. (red light is off) power. BLACK wire is not getting Connect ground to a different location. a good ground. Gauge will not light up YELLOW wire does not Connect to a location that has power (red