Summary of the content on the page No. 1
+
T
H
V
OSD
FF
PAUSE
C
/
V
R
A.MONITOR
C
DVD PLAYER
VIDEO CASETTE
RECORDER
USER'S GUIDE
For model:
HR-XVC1UJ
Hi-Fi
TV POWER
VCR DVD
OPEN/
DVD MENU MARKER RETURN CLOSE
DISPLAY A.TRK C.RESET ZERO RETURN
SEARCH
SUB TITLE ANGLE MODE
SP/EP
PLAY REPEAT
MODE ZOOM TITLE A-B
TV
POWER
INPUT
TV VOL
0 TIMER TV/VCR
PLAY
STOP
C
SKIP SKIP
/INDEX /INDEX
SET ENTER/ SET
SELECT
SET UP CANCEL
MENU
VCR/DVD/TV
For Customer Use:
Enter below the Model No. and Serial No. which are located on the rear of cabinet.
Summary of the content on the page No. 2
Dear Customer, CAUTION Thank you for purchasing the JVC DVD player video • When you are not using the DVD/VCR for a long period cassette recorder. Before use, please read the safety of time, it is recommended that you disconnect the power information and precautions to ensure safe use of your new cord from the AC outlet. DVD/VCR. • Dangerous voltage inside. Refer internal servicing to qualified service personnel. To prevent electric shock or CAUTIONS fire hazard, remove the power cord from the A
Summary of the content on the page No. 3
When the equipment is installed in a cabinet or a shelf, make MOISTURE CONDENSATION sure that it has sufficient space on all sides to allow for Moisture in the air will condense on the DVD/VCR when you ventilation (10 cm or more on both sides, on top and at the move it from a cold place to a warm place, or under rear). extremely humid conditions—just as water droplets form on the surface of a glass filled with cold liquid. Moisture When discarding batteries, environmental problems must be conden
Summary of the content on the page No. 4
CAUTION: THIS DIGITAL VIDEO PLAYER EMPLOYS A LASER SYSTEM. TO ENSURE PROPER USE OF THIS PRODUCT, PLEASE READ THIS USER'S GUIDE CAREFULLY AND RETAIN FOR FUTURE REFERENCE. SHOULD THE UNIT REQUIRE MAINTENANCE, CONTACT A JVC AUTHORIZED SERVICE CENTER. USE OF CONTROLS, ADJUSTMENTS OR THE PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. TO PREVENT DIRECT EXPOSURE TO LASER BEAM, DO NOT TRY TO OPEN THE ENCLOSURE. VISIBLE LASER RADIATION MAY BE PRE
Summary of the content on the page No. 5
*This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation or other rights owners and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation or other rights owners. Reverse engineering or disassemb
Summary of the content on the page No. 6
Features DVD/CD Player/Video Cassette Recorder • DVD/CD player with Video Cassette Recorder - Unique space saving design combines a DVD/CD player and a Hi-Fi Video cassette recorder. The DVD disc has much more capacity, but is the same size as the audio CD disc. Picture quality is higher than Super VHS. Audio quality is higher than audio CD. The DVD PLAYER can play back video CDs and audio CDs. • High Quality Picture - More than 500 lines(VCR mode: 230 lines) of Horizontal Resolution. It exceeds
Summary of the content on the page No. 7
Contents Before using your unit Disc Playback operation Important safeguards ....................................... 3 Disc ................................................................ 35 Power Source................................................... 5 Setting setup language .................................. 36 Features ........................................................... 6 Playback procedure ....................................... 37 Contents .......................................
Summary of the content on the page No. 8
Parts and functions Front VCR/DVD mode selector button PLAY button Cassette Loading Slot OPEN/CLOSE button STOP button Disc tray EJECT button PLAY STOP POWER CH EJECT OPEN/CLOSE REW FF REC DVD VCR VIDEO (M) L - AUDIO - R VCR/DVD Remote sensor POWER DVD indicator button CHANNEL +/– buttons REW (Rewind) button REC button AUDIO (L/R)/ VCR indicator FF (Fast Forward) button VIDEO IN jacks Rear AC power cord DVD OUTPUT DIGITAL AUDIO AUDIO S-VIDEO COMPONENT OPTICAL COAXIAL IN Y L VIDEO ( ) AN
Summary of the content on the page No. 9
Display Display window 1 2 3 4 11 5 6 10 9 8 7 No. Display Description 1 VCR VCR mode 2 Playback (lights) / Auto resume (flashes) 3 Still picture 4 DVD DVD disc is inserted. 5 CD CD is inserted. 6 PM Display for afternoon (lights out in the morning) Clock display (colon[ : ] flashes) 10 : 00 01 : 00 Counter display by hour/minute at VCR/DVD / by minute/second at CD Track number display for CD 2 7 TV channel display for VCR C002 CATV channel display C036 External input display L 8 Timer recording
Summary of the content on the page No. 10
+ T H OSD V FF PAUSE C / V A.MONITOR R C Remote control Page TV/VCR/DVD switch Switch to operate TV or VCR or DVD 18,36 POWER TV VCR DVD POWER Power on/off 18 DVD MENU Display menu of DVD software 45 MARKER Index for DVD 43 RETURN Remove DVD set up menu 47 OPEN/CLOSE Open or Close the tray 37 DISPLAY Change the front Display mode 27 OPEN/ A.TRK Digital AUTO TRACKING 26 DVD MENU MARKER RETURN CLOSE DISPLAY A.TRK C.RESET ZERO RETURN SUB TITLE Set Subtitle of a DVD disc 44 SEARCH SUB TITLE ANGLE MO
Summary of the content on the page No. 11
Remote control Inserting Batteries Open the battery compart- Install two "AA" batteries (supplied), Replace the compartment 1 23 ment cover in the direction of paying attention to the polarity cover. the arrow. diagram in the battery compartment. Battery precautions The precautions below should be followed when using batteries in this device: 1.Use only the size and type of batteries specified. 2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery com
Summary of the content on the page No. 12
Basic connections If you are using an antenna system, follow these instructions. If you are a cable (CATV) subscriber,skip ahead to page 14 for the proper connections. ANTENNA TO DVD/VCR CONNECTION The DVD/VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna system to a DVD/VCR. Find the type of antenna system you are using and follo
Summary of the content on the page No. 13
Basic connections DVD/VCR TO TV CONNECTION After you have connected the antenna to the DVD/VCR, you must connect the DVD/VCR to the TV. Below are 3 common methods of connecting your DVD/VCR to a TV. Find the type of TV you are using and follow the connection diagram. This DVD/VCR has a single 75 ohm output for connection to a TV. If your TV has separate VHF and UHF antenna inputs (numbers 2 and 3 below), use a splitter to connect the DVD/VCR to the TV for VHF and UHF reception. TV NOTE: If a VH
Summary of the content on the page No. 14
CATV (CABLE TV) connections Many cable companies offer services permitting reception of extra channels including pay or subscription channels. This DVD/VCR has an extended tuning range and can be tuned to most cable channels without using a cable company supplied converter box, except for those channels which are intentionally scrambled. If you subscribe to a special channel which is scrambled, you must have a descrambler box for proper reception. DVD/VCR 1 TV IN (ANT.) VHF/UHF Incoming Cable IN
Summary of the content on the page No. 15
CATV (CABLE TV) connections IMPORTANT: Make sure the TV/CATV menu option is set to the "CATV" mode. This DVD/VCR cannot receive scrambled programs since it does not contain a descrambler. In order to receive scrambled programs, your existing descrambler must be used. Descrambler boxes are available from cable companies. Consult your local cable company for more information concerning connection to their descrambler equipment. There are many ways to connect your DVD/VCR to a cable system. Below a
Summary of the content on the page No. 16
Playback Connection The exact arrangement you use to interconnect various video and audio components to the DVD/VCR is dependent on the model and features of each component. Check the Owner's Manual provided with each component for the location of video and audio inputs and outputs. Connect to a TV with Audio/Video Output Use the supplied AUDIO/VIDEO Cord. TV Audio (L) Output Video Output DVD/VCR DVD OUTPUT DIGITAL AUDIO AUDIO S-VIDEO COMPONENT OPTICAL COAXIAL IN Y L VIDEO ( ) ANT. R PB
Summary of the content on the page No. 17
Playback Connection Connect to a Stereo Amplifier with Audio Output If your TV has a COMPONENT VIDEO IN jack, you can connect the DVD/VCR to the TV with a COMPONENT cable (not supplied) as shown below. COMPONENT VIDEO output jack can send higher-quality video signal to a TV than S-Video output. COMPONENT VIDEO Cord (not supplied) To Component To Video Output Component AUDIO/VIDEO Cord (supplied) To Audio/Video Input Video Input To Audio/Video Output DVD/VCR Stereo Amplifier DVD OUTPUT DIGITAL AU
Summary of the content on the page No. 18
+ T H OSD V FF PAUSE C / V A.MONITOR R C Setting the Video Channel / Setting the language Setting the Video Channel When a TV is connected with the 75 ohm coaxial cable only. To view playback of a recorded tape, Press POWER to turn on the DVD/VCR. or to watch a program selected by 1 the VCR's channel selector, the TV Slide TV/VCR/DVD switch to VCR/DVD. Then press VCR to must be set to channel 3 or 4 (video 2 select the VCR mode. The VCR indicator on the front panel channel). will light. Set the
Summary of the content on the page No. 19
+ T H OSD V FF PAUSE C / V A.MONITOR R C Tuner Setting This DVD/VCR is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the DVD/VCR’s memory. In addition to normal VHF and UHF channels, this DVD/ VCR can receive up to 113 Cable TV channels. To use this DVD/VCR with an antenna, set the TV/CATV menu option to the TV mode. When shipped from the
Summary of the content on the page No. 20
+ T H OSD V FF PAUSE C / V A.MONITOR R C To ADD/DELETE channels / Noise elimination Preparation: To ADD/DELETE channels • Turn ON the TV and set it to the video input mode. You can add the channels you want • Make sure TV/VCR/DVD switch has been slided to VCR/DVD. or delete the channels you do not Then press VCR to select the VCR mode. (The VCR indicator want manually. will light) POWER TV Repeat the step 1 on page 19. VCR DVD CH SET UP 1 Then press or to select the TV CATV AUTO CH MEMORY
