Summary of the content on the page No. 1
OWNER’S GUIDE
INSTALLATION GUIDE
Slot-Type DVD Player
MODEL DV2000
Summary of the content on the page No. 2
2 © 2002 Directed Electronics, Inc.
Summary of the content on the page No. 3
Table of Contents Play Disc.................................................12 Limited One-Year Warranty. . . . . . . 4 Stop Disc ................................................12 Safety Instructions . . . . . . . . . . . . 5 Remove Disc............................................12 Region Management Information ...............5 Pause/Resume Play ..................................12 Important Safeguards . . . . . . . . . . 6 Volume Control.........................................12 When Driving
Summary of the content on the page No. 4
Limited One-Year Warranty For a period of ONE YEAR from the date of purchase, your authorized dealer to obtain the service charge for Directed Electronics, Inc. ("DIRECTED") promises to the your unit. original purchaser to repair or replace, free of cost, TO THE MAXIMUM EXTENT ALLOWED BY LAW, ALL with a comparable reconditioned model any DVD PLAY- ER (hereafter the "UNIT”), which proves to be defective WARRANTIES, INCLUDING BUT NOT LIMITED TO in workmanship or material defect under normal use,
Summary of the content on the page No. 5
Safety Instructions CAUTION: MOBILE DVD PLAYER IS A CLASS I LASER PRODUCT. HOWEVER THIS MOBILE DVD PLAYER USES A VIS- IBLE/INVISIBLE LASER BEAM THAT COULD CAUSE HAZARDOUS RADIATION IF EXPOSED DIRECTLY. BE SURE TO OPERATE THE MOBILE DVD PLAYER AS INSTRUCTED. USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL. WARNING: TO REDUCE
Summary of the content on the page No. 6
Important Safeguards ■ Excessive dust. WHEN DRIVING ■ Vibration, impact, or high foot traffic. Keep the volume level low enough to be aware ■ Surface tilt - the internal parts may be of road and traffic conditions. seriously damaged. WHEN CAR WASHING WHEN NOT IN USE Do not expose the product to water or excessive When not in use, set the player to standby mode. moisture. This could cause electrical shorts, fire, When left unused for a long period of time, the or other damage. player should be tu
Summary of the content on the page No. 7
Important Information FCC NOTICE YOUR WARRANTY This device complies with Part 15 of FCC rules. Your warranty registration must be completely Operation is subject to the following two condi- filled out and returned within 10 days of pur- tions: (1) This device may not cause harmful chase. Your product warranty will not be vali- interference, and (2) this device must accept dated if your warranty registration is not any interference received, including interfer- returned. Make sure you receive the
Summary of the content on the page No. 8
Disc Notes DISC CLEANING DISC FORMATS SUPPORTED BY THIS PLAYER Use a dry soft cloth to wipe the surface. If the disc is quite dirty, use a soft cloth slightly mois- DVD tened with isopropyl (rubbing) alcohol. Never 12 cm disc/8 cm disc use solvents such as benzine, thinner, or con- (Single-sided disc only) ventional record cleaners as they may mar the Video CD surface of the disc. 12 cm disc/8 cm disc Super-VCD NOTE: A disc may become somewhat scratched (althoug
Summary of the content on the page No. 9
Front Panel Operation FRONT PANEL FEATURES 1 Power Button Turns the unit on and off. 2 Play/Pause Button Begins or pauses playback. 3 Disc Slot Insert disc into the slot. 4 Stop Button Stops playback. 5 Reverse Skip Button Skips to the previous chapter/track. 6 Remote LED Receiver Receives remote control command. 7 Forward Skip Button Skips to the next chapter/track. 8 Eject Button Opens and closes the disc tray. 2 6 1 3 4 5 7 8 ■ Begin Playback - Press PLAY/PAUSE (2) FRONT PANEL CONTROLS and pl
Summary of the content on the page No. 10
Remote Operation REMOTE CONTROL BATTERY PRIOR TO USE ■ Battery Installation ■ During playback, the TV volume may be at ■ Pull down on the tab located on the a lower level then other source units. If back of the remote control and pull this is the case, adjust the volume to the the battery cover off. desired level. ■ Insert the batteries while observing ■ Connect the DVD player according to the the correct (+) and (-) polarities. instructions in the Installation section of ■ Click the battery cov
Summary of the content on the page No. 11
Remote Control Functions BUTTON FUNCTION 1 Open/Close 2 Numerals 3 Return 1 33 4 Setup 5 Directional 6 Title Menu 2 7 Play/Pause 8 Reverse Skip 9 Rewind Slow 10 Fast Rewind 3 32 11 Audio 12 Subtitle 4 31 30 13 A-B 14 Repeat 5 15 Volume 16 Channel 17 Channel Search 6 29 18 A/V Select 7 28 19 Mute 8 27 20 Program 26 9 21 Zoom 25 10 22 Go To 24 11 23 Step 23 12 22 24 Angle 13 25 Fast Forward 21 14 20 26 Forward Slow 15 19 27 Forward Skip 28 Stop 16 18 29 Menu 17 30 Enter 31 Display 32 Clear 33 Powe
Summary of the content on the page No. 12
Basic Operation Operations in this section are common for all Press repeatedly or hold the volume button to discs types (DVD, CD, Video CD, and Super-VCD). raise or lower the volume. TURNING THE PLAYER ON/OFF SLOW REWIND/SLOW FORWARD Press POWER (20) on the remote control to turn Slow motion playback can be done by pressing the player on, off, or to standby mode. the R.SLOW (9) or F.SLOW (26) buttons once. Press PLAY/PAUSE (7) to resume playback at PLAY DISC normal speed. 1. Press POWER (33) to
Summary of the content on the page No. 13
REPEAT PLAY ZOOM PLAY Chapters and tracks can be repeated during Press ZOOM (21) during playback to enlarge the playback. Press REPEAT (14) during playback to picture to twice its size. Press ZOOM (21) again toggle through the following repeat functions. to enlarge the picture to three times its size. Then use the DIRECTION BUTTONS (5) to move ■ REPEAT CHAPTER/TRACK - Repeats the DVD the picture. To return the picture to normal size, chapter or the audio CD track. press ZOOM(21) repeatedly until
Summary of the content on the page No. 14
Advanced Operation 3. Press PLAY/PAUSE (7) to return to normal DVD OPERATION playback speed. SETUP MENU NOTE: The rate of slow motion playback will be dis- The setup menu has selections for disc playback played in the On-Screen Display (OSD). setup that usually include audio, language, sub- titles, playback, and special features. The avail- FRAME ADVANCE able selections are determined by the recorded The picture can be advanced one frame at a time material on the disc. with the STEP (9) button.
Summary of the content on the page No. 15
VIEWING ANGLE MP3 OPERATION Many DVDs have scenes that are recorded from BASIC MP3 OPERATION multiple angles. These scenes can be viewed from Stop Disc, OSD, Mute, Play/Pause, Volume, Skip other angles by using the ANGLE (24) button. Tracks, Audio Mode, and Repeat Play operate as 1. Press ANGLE (24); the angle the scene is described in the Basic Operation section of this viewed from will change and the angle guide. mark will appear in the on-screen display. 2. Press ANGLE (24) repeatedly to chan
Summary of the content on the page No. 16
Setup Menu The setup menu contains settings for disc play- 6. Use the left DIRECTION BUTTON (5) to exit the submenu. back and should be used to adjust the DVD play- 7. To exit the Setup Menu at any time press er according to the disc being played, personal the SETUP (4) button. preferences, and the type of equipment the DVD player is connected to. LANGUAGE MENU NOTE: Make sure there is no disk in the player prior to The Language Menu allows the user to change accessing the Setup Menu. the subtit
Summary of the content on the page No. 17
AUDIO MENU DISPLAY OPTIONS MENU The Audio Menu allows the user to change audio The Display Options Menu allows the user to type or to turn the audio off. determine the size of the screen and what for- mat the DVD is to be played back in.
," ) *+ ",#- *+ ",#- *+! $ .+/ 0 0 # * ! 17 © 2002 Directed Electronics, Inc.
Summary of the content on the page No. 18
If the picture has no color, abnormal color or the SCREEN FORMAT video doesn't play properly, check the monitor and player settings to make sure they are the NOTE: This is controlled in the display options of the Setup Menu. same. TV SHAPE TV SYSTEM DVDs and VCDs have several screen formats that NTSC is the default setting and is the standard are usually indicated on the package. First system for video monitors in North America. determine the screen format for the disc you are PAL, PAL 60, and
Summary of the content on the page No. 19
Installation ■ Avoid installing the unit where it would be CONNECTING TO A STEREO TV subject to high temperature, such as direct sunlight, hot air from the heater, or where BASIC CONNECTION it would be subject to dust, dirt, or ■ Do not block ventilation holes of the DVD excessive vibration. player and arrange it so air can circulate freely. NOTE: Do not mount the unit where it will be stepped on ■ Read these instructions thoroughly before or where items will be placed on top of or spilled into
Summary of the content on the page No. 20
2. EXTERNALREMOTECONTROLCONNECTOR - WIRING CONNECTIONS Insert the 1/8" pin plug for the External 1. POWER CONNECTOR - The RED fused power Remote Sensor eye into this socket. wire must be connected to a wire that has 3. VIDEOSIGNAL - Connect the YELLOW (+) 12 volts when the key is in the acces- Composite Video RCA cable to this jack. sory position. The BLACK ground wire must 4. AUDIO SIGNAL - Connect the system L/R be connected to a paint-free, clean metal stereo Audio RCA cables to these jacks.
