Samsung DVD-ROM drive user manual

Summary of the content on the page No. 1

DVD-ROM DRIVE
Safety Precautions
SD-610/612
The following diagrams illustrate the precautions to be taken when using
your DVD-ROM drive.
User's Guide You must not use the drive in any manner other than that specified in this guide.
CAUTION Do not attempt to repair the DVD-ROM drive yourself. Contact
your dealer or local SAMSUNG representative for all repairs.
If you make any adjustments or perform any operations other
than those specified in this guide, you run the risk of exposure to
hazardous

Summary of the content on the page No. 2

Your DVD-ROM Drive Upgrading the Firmware Flash Memory The product firmware can be upgraded by downloading the updated file from the following Web site: http://www.samsungelectronics.com COMPACT System Requirements Before you install the DVD-ROM drive, we strongly recommend that you check that your setup meets the system requirements listed below. Item Description Computer Intel Pentium II (or higher), 32 MB of RAM (or higher) with an IDE interface 12 3 4 56 Free expansion unit 5.25 inch 1. Con

Summary of the content on the page No. 3

Connecting the Cables Setting Up the Device Driver Automatic Setup 1. Power cable 2. Master/slave select terminal 1 Insert the setup diskette in the diskette drive and change the directory to A:, where A: is the diskette drive. 3. IDE cable To do so, type A: after the C:\ prompt and press [Enter]. 4. Audio cable 2 Type CDSETUP and press [Enter]. 1 Connecting the power cable The 4-pin power cable from the internal power unit of your computer must be 3 Reboot the computer. connected to the power

Summary of the content on the page No. 4

Using the DVD-ROM Drive Installing the Device Driver To play audio or video CDs in your DVD-ROM drive, proceed as follows. No additional device driver is needed for Windows 95/98/NT, as the default Windows device driver is used. You can check that the DVD-ROM drive has been correctly detected by Windows. To do so, proceed as follows. 1 Push the power button and boot the computer. 2 After booting the computer, open the disc compartment by pressing the Eject button. 1 Double-click on the My Compu

Summary of the content on the page No. 5

Solving Technical Problems Technical Specifications SAMSUNG continually strives to improve its products. Both the design specifications and these user instructions are thus subject to change without notice. Meaning / Solution Problem Check that the power, audio and IDE cables are correct- SD - 610 SD - 612 The DVD-ROM drive is not ITEM ly connected to the computer. detected by the computer. DVD / CD Change the IDE cable and reconnect it to the computer. After installing the DVD-ROM Preferably, c