Samsung C01 user manual

Summary of the content on the page No. 1

SiPTel C01 IP Phone User Manual
















SiPTel C01
IP Phone
5.2E version

User Manual 3.1.00

Summary of the content on the page No. 2

SiPTel C01 IP Phone User Manual SAFETY INFORMATION Meticulous care had been devoted to ensure the highest safety standards in manufacturing of your SiPTel IP Phone. Safety is the major factor in designs of every set. But, safety is your responsibility too. Use only the power chord that comes with your SiPTel IP Phone. (Output: DC 5V/1.5A) To reduce the risk of electric shock, do not disassemble this product. There are no user serviceable parts. Opening or removing covers may expo

Summary of the content on the page No. 3

SiPTel C01 IP Phone User Manual TABLE OF CONTENTS 1. INTRODUCTION 1.1. Overview 1.2. Features 1.3. Specification 1.4. Structure of SiPTel IP Phone 1.4.1. Keypad 1.4.2. LCD Display 1.4.3. LED Display 1.4.4. Port Structure 2. PRE-INSTALLATION CHECK LIST 2.1. Power Requirements 2.2. Component Check List 2.3. User Requirements 3. INSTALLATION & INSTRUCTIONS 3.1. Connecting Cables 3.2. Booting Up process 3.3. Keying Instructions 4. GETTING STARTED WITH MENU 4.1. Call

Summary of the content on the page No. 4

SiPTel C01 IP Phone User Manual 4.4.3. Call Setup 4.4.4. Modem 4.4.4.1. Call Options 4.4.5. Time 4.4.6. PSTN 4.4.7. HTTP PROXY 4.5. Information 4.5.1. Network 4.5.2. Version 4.6. BALANCE 4.7. Reboot 5. USING SIPTEL IP PHONE 5.1. Connecting IP Phone to Internet 5.1.1. Using in Dialup Mode 5.1.2. Using with Broadband Cable 5.2. Making a VoIP Call 5.2.1. In On-Hook mode (Pre-dial) 5.2.2. In Off Hook mode 5.3. Making a PSTN Call 5.4. Making a call in Phone Book mode 5.5.

Summary of the content on the page No. 5

SiPTel C01 IP Phone User Manual 1. INTRODUCTION 1.1. Overview The SiPTel IP Phone is a single user VoIP (Voice over Internet Protocol) phone for the home or small- medium size businesses. The SiPTel IP Phone supports ITU -T H.323 protocol for voice communication on data lines. It is a stand-alone device, which means no PC connection is required to use it. The SiPTel IP Phone allows user to make long distance call or international call at low cost. Using the standard protocol, SiPTel

Summary of the content on the page No. 6

SiPTel C01 IP Phone User Manual • Data Modulation Standards V.90, V.34, V.432bis, V.22bis, V.22, V.23, V.21 and V.23 reversible (Minitel), Bell 212, Bell 103 Dialup Modem V.42 Error Control • Country Code support • V.42 Error Control • V.42bis Compression • Protected Against Surge and Over voltage on the Telephone Line Configuration Management Telnet, RS-232, Http, LCD display Protocol & Codec Specifications Protocol : ITU H.323 v4, H.225, H.245 Codec : ITU G.711, G.729.A, G.

Summary of the content on the page No. 7

SiPTel C01 IP Phone User Manual 1.4. Structure of SiPTel IP Phone 1.4.1. Keypad Figure 1) Keypad Structure of SiPTel IP Phone The description for each key is as follows. Key name Description Menu Ÿ Used to initiate the menu on LCD Ÿ Used to change between preferences when entering characters (English- capital and lowercase / numerical / special characters). M1~M3 Ÿ Memory dial DEL Ÿ Used to delete the characters in Pre-dial and Phone Book mode.  Ÿ Used to move up the curso

Summary of the content on the page No. 8

SiPTel C01 IP Phone User Manual ƒ P-Book Ÿ Used to move the cursor to the left in Phone Book mode. Ÿ Used to initiate the Phone Book menu. OK Ÿ Used to complete the input in Phone Book menu. Ÿ Used to confirm the entered or selected settings. Cancel Ÿ Used to cancel the selected menu, entered data, or etc. PSTN Ÿ Used to place the PSTN call. MUTE Ÿ Used to make the voice not to be heard from the counterpart. @ISP Ÿ Used to connect to dial-up ISP. (Option). VOL + / - Ÿ Used to adjust

Summary of the content on the page No. 9

SiPTel C01 IP Phone User Manual Status Flashing : Trying to find the Gatekeeper. Constant : Registered with Gatekeeper successfully. Call status : Displayed when the call is connected successfully. display : Displayed when the call isn’t connected. : Static IP Kinds of : DHCP connection : PPPoE Mute Ÿ Displayed when using Mute function. Flash save Ÿ Displayed when data is being saved in memory display Ÿ Displayed when the SiPTel IP Phone is connected to

Summary of the content on the page No. 10

SiPTel C01 IP Phone User Manual 2. PRE-INSTALLATION CHECK LIST 2.1. Power Requirements § AC Voltage : External power adapter (100V-240V, 50/60Hz). § Please use only the power adapter provided with the SiPTel IP Phone. § For additional power adapter, please ask your product provider. Safety Should liquid or solid object get into the cabinet, unplug the unit and have it checked by the qualified personnel before operating it any further. To disconnect the cord, pull it out by the p

Summary of the content on the page No. 11

SiPTel C01 IP Phone User Manual 2.3. User Requirements Before you start, please ask your local ISP or network administrator for an Internet account from User ISP Requirement Common Static IP User IP address Gateway Subnet mask DNS § H.323 ID DHCP User § E.164 Number PPPoE User User ID Password Dial-up User ISP Telephone number User name Password 3. INSTALLATION & INSTRUCTIONS 3.1. Connecting Cables STEP 1 Connect the Ethernet line that came from the Internet lea

Summary of the content on the page No. 12

SiPTel C01 IP Phone User Manual STEP 2 If the booting is completed properly, the following display will appear. You can see some Icons, Brand Name, ITSP given VoIP Phone SiP Tel Number, Time, etc. 10100-1000 A12:00 3.3. Keying Instructions Some setup menus support a few character input mode, English lower-case, English capital, numeric, and special characters or symbols. In an input mode, if you press ‘Menu’ key, the input mode will be toggled to another one in

Summary of the content on the page No. 13

SiPTel C01 IP Phone User Manual 4. GETTING STARTED WITH MENU 4.1. Call Log This menu allows user to look up the Dialed, Received and Missed calls list. User can look up the call lists up to 100 lists. User can make a call by using this call logs, and delete them when not required. 4.1.1. Rcvd Calls STEP 1 Press “Menu” key on the keypad in on-hook mode. STEP 2 Select “1: Call Log”. Press ‘OK’ button or press the menu number to select the menu

1:Call Log

Summary of the content on the page No. 14

SiPTel C01 IP Phone User Manual STEP 6 You can see the information such as the Caller Name if exists a phone book entry for that number, Date [Date/Month(day)], Time, etc., Press ‘Cancel’ button to move to the previous screen. No Entry 03034 Time : 08:04A STEP 7 Last information is Call duration in minutes [HH:MM]. Press ‘Cancel’ button to move to the previous screen. No Entry 03034 Duration : [08:37] STEP 8 You can press DELETE button an

Summary of the content on the page No. 15

SiPTel C01 IP Phone User Manual STEP 2 Select Received or Transmitted ( Dialed ) that you want to clear from list. Press ‘Cancel’ button to move to the previous screen. 1. Received 2. Transmitted STEP 3 Deleting all the options requires the authentication. Enter your user password. Enter Password Press ‘Cancel’ button to move to the previous screen. STEP 4 Confirm to delete the selected group of numbers. Use the left or rig

Summary of the content on the page No. 16

SiPTel C01 IP Phone User Manual 4.2.1.1. Find the number by Index STEP 1 Select ‘1: Find Number’ to find the telephone number registered in the phone book. Use the navigation key or press the menu number to select the menu, and press ‘OK’ button. 1: Find Number Press ‘Cancel’ key to move to the upper menu. 2: Add STEP 2 Select ‘By Index’. Use the navigation key or press the menu number to select the

Summary of the content on the page No. 17

SiPTel C01 IP Phone User Manual 4.2.1.2. Find the number by Name STEP 1 Select ‘1: Find Number’ to find a telephone number from the phone book. Use the navigation key or press the menu number to select the menu, and press ‘OK’ button. 1: Find Number Press ‘Cancel’ key to move to the upper menu. 2: Add STEP 2 Select ‘By Name’ Use the navigation key or press the menu number to select the menu, and press ‘OK’ but

Summary of the content on the page No. 18

SiPTel C01 IP Phone User Manual 4.2.2. Add This menu is to register a new telephone number into the phone book of IP Phone. The phone numbers can be registered up to 100 numbers. STEP 1 Select ‘2: ADD’ menu in PHONE BOOK menu selection. Use the navigation key and press OK or press the menu number to select the menu. 1: Find Number Press ‘Cancel’ key to move to the upper menu. 2:ADD STEP 2 Enter the name, telephone number

Summary of the content on the page No. 19

SiPTel C01 IP Phone User Manual STEP 1 Select ‘3: Memory Dial’ in the PHONE BOOK menu selection. Use navigations key and press OK or press the menu number to select the menu. 2: ADD Press ‘Cancel’ key to return to the upper menu. 3: Memory Dial STEP 2 Select the menu related to which of the three single touch KEYs you want to use for a particular number Use navigations key and press OK to select the KEY.

Summary of the content on the page No. 20

SiPTel C01 IP Phone User Manual STEP 1 Select ‘4.Delete All‘ from PHONE BOOK menu after press MENU button. PHONE BOOK menu can be selected even by pressing ‘P-BOOK’ button just besides CANCEL button. 3: Memory Dial Use navigations key and press OK button or press the menu number 4: Delete All to select the menu. STEP 2 Authenticate yourself to delete entries by entering the passowrd and press ‘OK’ button You can press ‘Cancel’ key to return t