Summary of the content on the page No. 1
Model APS-155CH
Owner’s Manual
3 Button Remote Security System with
Stage Shock Sensor & Starter Disable
FEATURES :
2 Three Button Code Hopping RF Transmitters
Three Channel Code Learning Receiver (capable of accepting 4 transmitters)
Selectable Manual Override Mode
Remote Panic in all modes
Protected Valet
7 Function LED -(Light Emitting Diode) - Arm / Disarm / Zone1, 2, 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Summary of the content on the page No. 2
NOTE: Your system has the option of using a siren, the vehicle horn, or both for the sounding device. Where the siren is referenced below, the horn or both may in fact chirp, or beep. ARMING THE SYSTEM - ACTIVE 1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid. 2. Press and release the ARM button on the keychain transmitter. The dash mounted LED begins to flash slowly. Parking Lights flash one time. Siren and or Horn sounds one chirp. If the siren/horn
Summary of the content on the page No. 3
PROTECTION WHILE THE SYSTEM IS ARMED Opening any protected door, hood, or trunk lid will cause the alarm to immediately sound. The alarm will continue to sound for 30 seconds, then stop and continue to monitor all protected entry points. If the thief left a door opened, the alarm will sound for six 30 second cycles, remain armed and ignore that triggered zone. Whenever the system is armed, the dash mounted LED indicator will slowly flash. This serves as a visual deterrent to the potential th
Summary of the content on the page No. 4
If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered. Siren/Horn does not sound. If the siren and or horn sounds 4 chirps, then the alarm was triggered in your absence. Before turning the key on, examine the LED and refer to the INTRUSION WARNING SIGNALS section of this manual to identify which zone was triggered. Doors Unlock - Optional NOTE: Chirps must be selected on to acce
Summary of the content on the page No. 5
NOTE: Always remember to return the system to the NON VALET mode, after servicing, to ensure that the vehicle remains protected at all times. MANUALLY OVERRIDING YOUR SYSTEM: USING THE VALET SWITCH MANUAL OVERRIDE Your Security System can be disarmed without the use of the keychain transmitter. This is necessary, since you will need the ability to operate your vehicle if the transmitter is lost or its battery fails. If your system has been selected for Valet Switch manual override as indicated
Summary of the content on the page No. 6
5 seconds during any of the above steps, the unit will revert back to the last successfully stored code. Custom Code Programming Example: To Change the code from the factory pre-assigned code of 11 to “52” you would do the following: 1 Disarm the system by use of the transmitter, or by use of the emergency override sequence. 2 Turn the ignition switch to the on position. 3 Within 10 seconds, press and release the valet/override switch, 3 times. 4 Within 10 seconds turn the ignition switch off, o
Summary of the content on the page No. 7
off permanently, eliminating the need to hold the ARM / DISARM button for two seconds. To do this, 1. Turn the ignition key on then off. 2. Within 10 seconds, press and release the valet push button switch three times. 3. If the chirps were on before you started, then you will hear 2 chirps indicating they have been turned off. If the chirps were off before you started, then you will hear one chirp indicating they have been turned on. NOTE:Whenever the chirps are by - passed, the 4 chirp intrusi
Summary of the content on the page No. 8
APS-155CH SYSTEM FUNCTIONS AT A GLANCE DASH LED INDICATORS RAPID FLASHING = PASSIVE ARMING SLOW FLASHING = ARMED OFF = DISARMED ON SOLID = VALET MODE 3 FLASH...PAUSE = INTRUSION ZONE 3 2 FLASH...PAUSE = INTRUSION ZONE 2 1 FLASH...PAUSE = INTRUSION ZONE 1 SIREN CHIRP INDICATORS 1 CHIRP * = ARM 2 CHIRPS * = DISARM 3 CHIRPS = ARM / DOOR OPENED 4 CHIRPS = DISARM / INTRUSION * These chirps are optional, and can be de - activated. PARKING LAMPS 1 FLASH = ARM 2 FLASHES = DISARM 3 FLASHES = DISARM / INT
