Summary of the content on the page No. 1
1
MODEL G0703/G0703P 1 ⁄2 HP
CYCLONE DUST COLLECTOR
OWNER'S MANUAL
(For models manufactured since 03/12)
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
Summary of the content on the page No. 2
This manual provides critical safety instructions on the proper setup, operation, maintenance, and service of this machine/tool. Save this document, refer to it often, and use it to instruct other operators. Failure to read, understand and follow the instructions in this manual may result in fire or serious personal injury—including amputation, electrocution, or death. The owner of this machine/tool is solely responsible for its safe use. This responsibility includes but is not limited to
Summary of the content on the page No. 3
Table of Contents INTRODUCTION ............................................... 2 SECTION 5: OPERATIONS ........................... 33 SECTION 6: ACCESSORIES ......................... 37 SECTION 1: SAFETY ....................................... 7 SECTION 7: MAINTENANCE ......................... 39 SECTION 2: POWER SUPPLY ...................... 10 SECTION 8: SERVICE ................................... 40
Summary of the content on the page No. 4
INTRODUCTION Manual Accuracy Contact Info your machine may not exactly match the manual Machine Description www.grizzly.com
Summary of the content on the page No. 5
Identification Note: The inlet restrictor is only installed if dust collector is to be used on a 20 Amp-110 Volt circuit and circuit breaker tripping occurs during start-up. Figure 1. To reduce the risk of serious injury when using this machine, read and understand this entire manual before beginning any operations.
Summary of the content on the page No. 6
Glossary Of Terms Air Suction Capacity: Duct Grounding: Main Line: Branch Line: Main Line Velocity Velocity Machine CFM Requirement: Collection Bag/Drum: CFM (Cubic Feet per Minute): Dust Collection System Cyclone: Powered Air Filter: Duct (Ducting): Single-Stag
Summary of the content on the page No. 7
Machine Data Sheet Customer Service #: (570) 546-9663 · To Order Call: (800) 523-4777 · Fax #: (800) 438-5901
MODELS G0703/G0703P
1-1/2 HP CYCLONE DUST COLLECTOR Weight............................................................................................................................................................... 165 lbs Width (side-to-side) x Depth (front-to-back) x Height........................
Summary of the content on the page No. 8
No of Lower Bags............................................................................................................................................. 1 Lower Bag Capacity........................................................................................................................... 2.66 cu. ft. Lower Bag Diameter............................................................................................................................ 15-3/4 in. Lower Bag Length..............
Summary of the content on the page No. 9
SECTION 1: SAFETY For Your Own Safety, Read Instruction Manual Before Operating this Machine The purpose of safety symbols is to attract your attention to possible hazardous conditions. This manual uses a series of symbols and signal words intended to convey the level of impor- tance of the safety messages. The progression of symbols is described below. Remember that safety messages by themselves do not eliminate danger and are not a substitute for proper accident prevention measures. Indica
Summary of the content on the page No. 10
DISCONNECTING POWER SUPPLY. GUARDS & COVERS. NEVER STAND ON MACHINE. APPROVED OPERATION. STABLE MACHINE. DANGEROUS ENVIRONMENTS. AWKWARD POSITIONS. ONLY USE AS INTENDED. UNATTENDED OPERATION. OFF USE RECOMMENDED ACCESSORIES. MAINTAIN WITH CARE.
Summary of the content on the page No. 11
Additional Safety for Dust Collectors INTENDED USE. SUSPENDED DUST PARTICLES AND IGNITION SOURCES. FIRE SUPPRESSION. HAZARDOUS DUST. IMPELLER HAZARDS. DUST ALLERGIES. AVOIDING SPARKS. WEAR RESPIRATOR. OFF EMPTYING DUST. OPERATING LOCATION. DISCONNECTING POWER SUPPLY. OFF
Summary of the content on the page No. 12
SECTION 2: POWER SUPPLY Availability Circuit Information For your own safety and protection of property, consult an electrician if you are Electrocution, fire, or unsure about wiring practices or electrical equipment damage may codes in your area. occur if machine is not correctly grounded and Note: The circuit requirements listed in this man- connected to the power ual apply to a dedicated circuit—where only one supply. mac
Summary of the content on the page No. 13
For 220V operation: Circuit Requirements for 220V Nominal Voltage .............................. 220V/240V Cycle ..........................................................60 Hz Phase ........................................... Single-Phase Circuit Rating ...................................... 15 Amps Plug/Receptacle ............................. NEMA 6-15 GROUNDED 6-15 RECEPTACLE Grounding Requirem
Summary of the content on the page No. 14
Voltage Conversion To convert the Model G0703/G0703P to 220V: 1. 2. Extension Cords 3. Figure 5 Figure 5. Minimum Gauge Size ...........................12 AWG Maximum Length (Shorter is Better).......50 ft.
Summary of the content on the page No. 15
4. Figure 6 6. Figure 8 Figure 6. 5. Figure 7 Figure 8. 7. Figure 8 8. Step 6 9. Step 3 10. Figure 7. Page 45
Summary of the content on the page No. 16
SECTION 3: SETUP Needed for Setup This machine presents serious injury hazards to untrained users. Read through this entire manu- al to become familiar with the controls and opera- Description Qty tions before starting the machine! This machine and its com- ponents are very heavy. Get lifting help or use power lifting equipment such as a forklift to move heavy items. Unpacking please call us imm
Summary of the content on the page No. 17
Hardware Recognition Chart
Summary of the content on the page No. 18
General Inventory (Figure 11): Qty Inventory I. J. K. L. M. N. O. P. Machine Inventory (Figure 9): Qty Q. A. R. B. S. T. U. V. W. X. Figure 9. Stand and Drum Inventory (Figure 10): Qty C. D. Note: The drum extension is shipped inside of the main dust collection drum. E. F. G. H. Figure 11.
Summary of the content on the page No. 19
Site Considerations Weight Load Physical Environment Machine Data Sheet Space Allocation Electrical Installation See below for required space allocation. Lighting Children or untrained people may be seriously injured by this machine. Only install in an access restricted location. Figure 12.
Summary of the content on the page No. 20
4. Assembly Figure 15 To assemble the dust collector: 1. Figure 13 Figure 15. 5. 6. Figure 13. Figure 16 2. 3. Figure 14, Figure 16. 7. Figure 14.
