Summary of the content on the page No. 1
Installation
Instructions
Built-In Dishwashers
*Custom front panel models include a kit that
contains a template, hardware and panel
installation instructions. Refer to the kit
instructions when installing the custom panel.
31-30246
10-08 JR
Summary of the content on the page No. 2
Safety Information • IMPORTANT — The dishwasher MUST BEFORE YOU BEGIN be installed to allow for future removal from Read these instructions completely and carefully. the enclosure if service is required. • IMPORTANT — Save these instructions for • If you received a damaged dishwasher, you should local inspector’s use. Observe all governing codes and immediately contact your dealer or builder. ordinances. READ CAREFULLY. • Note to Installer — Be sure to leave these instructions with the Consu
Summary of the content on the page No. 3
Installation Preparation Side Trim PARTS SUPPLIED: • Two #8-18 x 5/8" Phillips special-head Side Trim screws, to secure dishwasher to underside #8 Phillips Special-Head #10 Hex Head of countertop or sides of cabinets. Top Trim Screws 5/8" Long J-Box Screw Trim Pieces • Junction box cover and #10-1/2" hex 1/2" Long head screw • Side and top trim • Sound upgrade kit (some models) • Drain hose (78"), drain hose hanger Drain Hose (78") and hose clamp Junction Box Cover Sound Upgrade • Literatur
Summary of the content on the page No. 4
Installation Preparation ADVANCE PLANNING • These dishwashers are designed for versatility, • These dishwashers may be installed beneath adaptable to virtually any installation. countertops of stone or other materials that will not accept screws. No trim kit required. • All models have a full-length door without the traditional access panel. PREPARE DISHWASHER ENCLOSURE WARNING To reduce the risk of electric shock, fire, This Wall Area or injury to persons, the installer must must be Free of
Summary of the content on the page No. 5
Installation Preparation Method 1—Air Gap with Waste Tee or Disposer PREPARE DRAIN PLUMBING Drain Requirements • Drain hose must not exceed 10 feet in length. • A high drain loop or air gap is required. See below. Drain Method The type of drain installation depends on the following: • Do local codes or ordinances require an air gap? • Is waste tee less than 18" above the floor? Waste Tee Installation Figure C Disposer Installation If the answer to either question is yes, an air gap must be used
Summary of the content on the page No. 6
Installation Preparation PREPARE ELECTRICAL WIRING Alternate WARNING Receptacle FOR PERSONAL SAFETY: Remove house fuse Location or open circuit breaker before beginning installation. Do not use an extension cord 18" 1-1/2" Dia. or adapter plug with this appliance. Hole (Max.) 18" Electrical Requirements 6" 6" 3" from • This appliance must be supplied with 120V, 60 Hz. and Cabinet connected to an individual properly grounded branch circuit, protected by a 15- or 20-ampere circuit breaker
Summary of the content on the page No. 7
Installation Instructions PREPARE HOT WATER SUPPLY STEP 1 LOCATE INSTALLATION ITEMS • Locate the items in the installation package and set Hot Water Line aside for use in the listed steps. • The line may enter from either side, rear or floor within • Trim pieces – Step 2 the shaded area shown in Figure F. • Junction box cover – Step 7 or Step 18 • The line may pass through the same hole as the • Drain hose and clamp – Step 10 electrical cable and drain hose, or an additional 1-1/2" diameter hol
Summary of the content on the page No. 8
Installation Instructions STEP 4 REMOVE WOOD BASE, INSTALL STEP 3 CHECK DOOR BALANCE • With dishwasher on the wood skid, check the door LEVELING LEGS balance by opening and closing the door. • If the door drops when released, increase the spring tension. IMPORTANT — Do not kick off wood base! If the door rises when released, decrease the tension. Damage will occur. • There are two types of counter balance and therefore two • Move the dishwasher close to the installation location and lay method
Summary of the content on the page No. 9
Installation Instructions STEP 7 INSTALL POWER CORD STEP 9 POSITION WATER LINE AND Skip this step if dishwasher will be permanently connected to HOUSING WIRING the house electrical system. • Position water supply line and house wiring on the floor In this step you will need the junction box cover and the #10 x 1/2" of the enclosure to avoid interference with base of hex head screw from the screw kit set aside in Step 1. dishwasher and components under dishwasher. The power cord and connections
Summary of the content on the page No. 10
Installation Instructions STEP 13 SLIDE DISHWASHER INTO STEP 11 INSERT DRAIN HOSE THROUGH CABINET FINAL POSITION • Position dishwasher in front of cabinet opening. Insert • Push the dishwasher the rest of the way into drain hose into the hole in cabinet side. If a power cord is the cabinet. used, guide the end through a separate hole. • Push the sides with your hands. Do not push the dishwasher with your knee, as this will damage Maximum the door. Insulation Drain Hose Water Blanket • Check th
Summary of the content on the page No. 11
Installation Instructions STEP 14 LEVEL DISHWASHER STEP 13 SLIDE DISHWASHER INTO FINAL POSITION (cont.) IMPORTANT — Dishwasher must be level for proper dish rack operation and wash performance. Special Considerations for Positioning • Make sure 1/2" minimum gap is maintained. The controls on these models are designed to be hidden • Place level on door by your countertop. Align the dishwasher as shown in to check that the Figure U. Leave a 1/2" minimum gap between the dishwasher is level unders
Summary of the content on the page No. 12
Installation Instructions STEP 15 SECURE DISHWASHER TO STEP 16 CONNECT WATER SUPPLY COUNTERTOP OR CABINET Connect water supply line to 90° elbow. • Slide compression nut, then ferrule over end of In this step you will need Side Mounting water line. the 2 Phillips special- Brackets head screws set aside • Insert water line into 90° elbow. in Step 1. • Slide ferrule against elbow and secure with Countertop The dishwasher must be compression nut. Mounting secured to the Tub Brackets Frame count
Summary of the content on the page No. 13
Installation Instructions STEP 17 CONNECT DRAIN LINE DRAIN LINE INSTALLATION The molded end of the drain hose will fit 5/8" through • Connect drain line to air gap, waste tee or disposer 1" diameter inlet ports on the air gap, waste tee or using the previously determined method. disposer. • Secure the drain hose to the air gap, waste tee or • Determine size of inlet port. disposer with clamps. • Cut drain hose connector on the marked line, Method 1—Air gap with waste tee or disposer if required
Summary of the content on the page No. 14
Installation Instructions STEP 18 CONNECT POWER SUPPLY STEP 19 PRETEST CHECK LIST Skip this step if dishwasher is equipped with Review this list after installing your dishwasher power cord. to avoid charges for a service call that is not covered by your warranty. Verify that power is turned off at the source. • Locate junction box cover set aside in Step 1. • Check to be sure power is OFF. • Secure house wiring to the back of the junction • Open door and remove all foam and paper box with a
Summary of the content on the page No. 15
Installation Instructions/Custom Panel Dimensions STEP 20 DISHWASHER WET TEST STEP 22 INSTALL SOUND UPGRADE KIT • Turn on power supply (or plug power cord into outlet, IF EQUIPPED if equipped). Skip this step if your model does not have the Sound • Start the unit to check for leaks. Upgrade Kit. – Push RINSE ONLY pad. • Locate sound upgrade kit set aside in Step 1 and the two – Push START/RESET pad one time. screws set aside in Step 6. – Close door. • Attach the plastic Sound Panel as shown i
Summary of the content on the page No. 16
STEP 23 INSTALL TOEKICK • Locate toekick and screws set aside in step 5. Toekick Attachment Screws Figure JJ • Replace the toekick and make sure it is against the floor. • Insert and tighten the 2 toekick attachment screws. The toekick should stay in contact with the floor to ensure quiet dishwasher operation. STEP 24 LITERATURE • Be sure to leave complete literature package, Installation Instructions and product samples with the consumer. NOTE: While performing installations described in this
Summary of the content on the page No. 17
Instructions d’installation Lave-vaisselle encastré *Les modèles avec panneau frontal sur commande viennent avec une trousse comprenant un gabarit, la quincaillerie et les instructions d'installation du panneau. Se reporter aux instructions de la trousse pour installer le panneau sur commande. 31-30246 10-08 JR
Summary of the content on the page No. 18
Information de sécurité • IMPORTANT — Le lave-vaisselle DOIT être AVANT DE COMMENCER installé de manière à permettre la dépose ultérieure Il faut lire soigneusement toutes ces instructions. de l’enceinte afin de permettre toute intervention. • IMPORTANT — Conserver ces instructions afin • Si le lave-vaisselle livré est endommagé, il faut que l’inspecteur local s’en serve. Il faut respecter tous contacter immédiatement le concessionnaire ou les codes et règlements. l’entrepreneur de constructio
Summary of the content on the page No. 19
Préparation pour l’installation Pièce de finition latérale PIÈCES FOURNIES : • Deux vis cruciformes spéciales #8-18 x 5/8 po Pièce de finition latérale pour fixer le lave-vaisselle au dessous du plan Vis cruciformes spéciales Vis hexagonale #10 de travail ou aux côtés des armoires. #8, longueur de 5/8 po pour boîte de jonction, Pièce de finition supérieure longueur de 1/2 po • Couvercle de boîte de jonction et vis Pièces des finition hexagonale #10-1/2 po • Pièces de finition latérales et su
Summary of the content on the page No. 20
Préparation pour l’installation PLANIFICATION PRÉALABLE • Ces lave-vaisselle sont conçus afin d’être • Ces lave-vaisselle peuvent être installés polyvalents et de pouvoir s’adapter à pour ainsi dire au-dessous des plans de travail faits de pierre ou n’importe quelle installation. d’autres matériaux dans lesquels on ne peut pas placer de vis. Il n’y a pas besoin de trousse de • Tous les modèles ont une porte pleine longueur garniture. sans le panneau d’accès traditionnel. PRÉPARATION DE L’ENCEIN
